Noisiness of the Surfaces on Low-Speed Roads
Source abstract
Abstract
Traffic noise is a particular threat to the environment in the vicinity of roads. The level of the noise is influenced by traffic density and traffic composition, as well as vehicle speed and the type of surface. The article presents the results of studies on tire/road noise from passing vehicles at a speed of 40–80 kph, carried out by using the statistical pass-by method (SPB), on seven surfaces with different characteristics. It has been shown that increasing the speed from 40 kph to 50 kph contributes to the increase in the maximum A-weighted sound pressure level by about 3 dB, regardless of the type of surface. For larger differences in speed (30 kph–40 kph) increase in noise levels reaches values about 10 dB. In the case of higher speeds, this increase is slightly lower. In this article, special attention is paid to the noisiness from surfaces made of porous asphalt concrete (PAC), BBTM (thin asphalt layer), and stone mastic asphalt (SMA) with a maximum aggregate size of 8 mm and 5 mm. It has also been proved that surfaces of porous asphalt concrete, within two years after the commissioning, significantly contribute to a reduction of the maximum level of noise in the streets and roads with lower speed of passing cars. Reduction of the maximum A-weighted sound pressure level of a statistical car traveling at 60 kph reaches values of up to about 6 dB, as compared with the SMA11. Along with the exploitation of the road, air voids in the low-noise surface becomes clogged and acoustic properties of the road decrease to a level similar to standard asphalt.
Source: crossref · Quality: baseline
Research context
OpenAlex topics: Offshore Engineering and Technologies · Smart Materials for Construction · Asphalt Pavement Performance Evaluation
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
Division of Road Engineering, Faculty of Civil and Environmental Engineering, Bialystok University of Technology, Wiejska St. 45E, 15-351 Bialystok, Poland
References (20)
Show source-provided references
1. Abbott, P.G., Morgan, P.A., and McKell, B. (2010). A Review of Current Research on Road Surface Noise Reduction Techniques, Transport Research Laboratory.
2. Morgan, P.A., Stait, R.E., Reeves, S., and Clifton, M. (2007). The Feasibility of Using Twin-Layer Porous Asphalt Surfaces on England's Strategic Road Network, Transport Research Laboratory.
3. Sandberg, U., and Mioduszewski, P. (2012). The importance for noise reduction of the bottom layer in double-layer porous asphalt. J. Acoust. Soc. Am., 131.10.1121/1.4708027 ↗
4. Sandberg, U., and Goubert, L. (2011, January 4–7). PERSUADE—A European project for exceptional noise reduction by means of poroelastic road surfaces. Proceedings of the 40th International Congress and Exposition on Noise Control Engineering 2011 (INTER-NOISE 2011), Osaka, Japan.
5. Ejsmont, J.A., Sandberg, U., Świeczko-Żurek, B., and Mioduszewski, P. (2014, January 16–19). Tyre/road noise reduction by a poroelastic road surface. Proceedings of the 43rd International Congress on Noise Control Engineering 2014 (INTER-NOISE 2014), Melbourne, Australia.
6. The effect of time on the contribution of asphalt rubber mixtures to noise abatement10.3397/1.3676311 ↗
7. Durability and variability of the acoustical performance of rubberized road surfaces10.1016/j.apacoust.2015.02.001 ↗
8. Sandberg, U., and Ejsmont, J.A. (2002). Tyre/Road Noise. Reference Book, Informex.
9. Influence of road pavement macrotexture on tyre/road noise of vehicles10.3846/bjrbe.2014.23 ↗
10. Acoustic monitoring of low noise road pavements10.3397/1.3082400 ↗
11. California-Denmark study on acoustic aging of road pavements10.3141/2158-15 ↗
12. Bendtsen, H., Andersen, B., Oddershede, J., and Iversen, L.M. (2012, January 19–22). Long time effect of noise reducing thin layer pavements. Proceedings of the 41st International Congress and Exposition on Noise Control Engineering 2012 (INTER-NOISE 2012), New York, NY, USA.
13. Mioduszewski, P., and Gardziejczyk, W. (2013, January 15–18). Noise measurements on low noise pavements—Problems with inhomogeneity of wearing course. Proceedings of the 42nd International Congress and Exposition on Noise Control Engineering 2013 (INTER-NOISE 2013), Innsbruck, Austria.
14. The effect of time on acoustic durability of low noise pavements—The case studies in Poland10.1016/j.trd.2016.02.006 ↗
15. Temperature effect on tyre-road noise10.1016/j.apacoust.2006.06.001 ↗
16. Berge, T., and Storeheier, S.Å. (2009, January 23–26). Low noise pavements in a Nordic climate. Results from a four year project in Norway. Proceedings of the 38th International Congress and Exposition on Noise Control Engineering 2009 (INTER NOISE 2009), Ottawa, ON, Canada.
17. Comparison of vehicle noise on dry and wet road surfaces
18. Thin noise-reducing asphalt pavements for urban areas in Germany
19. Assessment of asphalt concrete acoustic performance in urban streets10.1121/1.2828068 ↗
20. (1997). ISO 11819–1 Acoustics—Method for Measuring the Influence of Road Surfaces on Traffic Noise—Part 1: The Statistical Pass-By Method, ISO.