Effect of Post-Oxidation Treatment on the Performance and Microstructure of Silicon Carbide Ceramic Membrane
Source abstract
Abstract
The post-oxidation treatment (POT) is an important step in the preparation of silicon carbide (SiC) ceramic membranes via recrystallization sintering, which is generally considered to remove any possible free carbon. It is found, however, that increasing the temperature of POT improves not only the hydrophilicity and flux of SiC ceramic membranes but also their mechanical properties, chemical stability, etc. Therefore, it is necessary to study the principle of POT in order to obtain SiC ceramic membranes with optimal properties. In this study, the principle of POT was characterized via scanning electron microscopy, X-ray diffraction, X-ray photoelectron spectroscopy, synchronous thermal analysis, and metallographic microscopy. According to the principle, the conditions, such as the temperature and air flow rate, of the post-oxidation process were optimized. Under the optimized conditions, POT improved the flux of SiC ceramic membranes from 1074 to 5118 L·m−2·h−1·bar−1, increased the bending strength from 26 to 35 MPa, and provided SiC ceramic membranes with high stability under acid and alkali conditions.
Source: crossref · Quality: baseline
Research context
OpenAlex topics: Advanced ceramic materials synthesis · MXene and MAX Phase Materials · Membrane Separation Technologies
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
School of Chemistry and Chemical Engineering, Shanghai University of Engineering Science, Shanghai 201620, China
Innovation Centre for Environment and Resources, Shanghai University of Engineering Science, Shanghai 201620, China
Shandong Silicon Membrane Technology Co., Ltd., Weifang 262517, China
Funding
Capacity Building Project of Some Local Colleges and Universities in Shanghai · National Natural Science Foundation of China
References (48)
Show source-provided references
1. Ceramic nanocomposite membranes and membrane fouling: A review10.1016/j.watres.2020.115674 ↗
2. A review of the potential of conventional and advanced membrane technology in the removal of pathogens from wastewater10.1016/j.seppur.2022.120454 ↗
3. Othman, N.H., Alias, N.H., Fuzil, N.S., Marpani, F., Shahruddin, M.Z., Chew, C.M., Ng, K.M.D., Lau, W.J., and Ismail, A.F. (2021). A Review on the Use of Membrane Technology Systems in Developing Countries. Membranes, 12.10.3390/membranes12010030 ↗
4. Pilot plants of membrane technology in industry: Challenges and key learnings10.1007/s11705-019-1860-x ↗
5. Enhancement of reaction-sintering of alumina-excess magnesium aluminate spinel in presence of titania10.1016/j.ceramint.2018.03.115 ↗
6. Pressureless sintering of high performance silicon nitride ceramics at 1620 °C10.1016/j.ceramint.2021.07.104 ↗
7. Phase stability (at 1000 °C) of hollow t-ZrO2 fibers costabilized by lanthana and yttria10.1111/ijac.13490 ↗
8. Fabrication, microstructural characterization and gas permeability behavior of porous silicon nitride ceramics with controllable pore structures10.1016/j.jeurceramsoc.2019.03.011 ↗
9. Fabrication of high-strength porous SiC-based composites with unidirectional channels10.1111/jace.16332 ↗
10. Silicon carbide microfiltration membranes for oil-water separation: Pore structure-dependent wettability matters10.1016/j.watres.2022.118270 ↗
11. Air-sintered silicon (Si)-bonded silicon carbide (SiC) hollow fiber membranes for oil/water separation10.1016/j.jeurceramsoc.2021.08.025 ↗
12. Enhanced fabrication of silicon carbide membranes for wastewater treatment: From laboratory to industrial scale10.1016/j.memsci.2020.118080 ↗
13. Removal of micropollutants in a ceramic membrane bioreactor for the post-treatment of municipal wastewater10.1016/j.cej.2021.131458 ↗
14. Processing and properties of glass-bonded silicon carbide membrane supports10.1016/j.jeurceramsoc.2016.11.019 ↗
15. Review on synthesis, structure, physical and chemical properties and functional characteristics of porous silicon carbide10.1016/j.jiec.2017.02.002 ↗
16. Fabrication and optimization of a clay-bonded SiC flat tubular membrane support for microfiltration applications10.1016/j.ceramint.2017.03.079 ↗
17. Microstructural evolution during silicon carbide (SiC) formation by liquid silicon infiltration using optical microscopy10.1016/j.ijrmhm.2009.09.002 ↗
18. Oxidation-bonded SiC membrane for microfiltration10.1016/j.jeurceramsoc.2017.10.019 ↗
19. Tuning pore structure of corrosion resistant solid-state-sintered SiC porous ceramics by particle size distribution and phase transformation10.1016/j.matdes.2016.03.105 ↗
20. In-situ reaction bonding to obtain porous SiC membrane supports with excellent mechanical and permeable performance10.1016/j.ceramint.2019.01.234 ↗
21. Fabrication of polycarbosilane and silicon oxycarbide microspheres with hierarchical morphology10.1016/j.solidstatesciences.2011.06.009 ↗
22. Highly permeable silicon carbide-alumina ultrafiltration membranes for oil-in-water filtration produced with low-pressure chemical vapor deposition10.1016/j.seppur.2020.117496 ↗
23. Nagano, T., Sato, K., and Kawahara, K. (2020). Gas Permeation Property of Silicon Carbide Membranes Synthesized by Counter-Diffusion Chemical Vapor Deposition. Membranes, 10.10.3390/membranes10010011 ↗
24. Impact of C-CVD synthesis conditions on the hydraulic and electronic properties of SiC/CNTs nanocomposite microfiltration membranes10.1016/j.diamond.2021.108611 ↗
25. Deposition of thin ultrafiltration membranes on commercial SiC microfiltration tubes10.1016/j.ceramint.2013.09.107 ↗
26. Influencing factors on the performance of tubular ceramic membrane supports prepared by extrusion10.1016/j.ceramint.2020.12.235 ↗
27. Fabrication of B4C ultrafiltration membranes on SiC supports10.1016/j.jeurceramsoc.2022.02.035 ↗
28. Recrystallization sintering and characterization of composite powders composed of two types of SiC with dissimilar particle sizes10.1111/ijac.14059 ↗
29. Microstructures and properties of solid-state-sintered silicon carbide membrane supports10.1016/j.ceramint.2019.06.244 ↗
30. The effect of the morphology of carbon used as a sintering aid on the mechanical properties of silicon carbide10.1016/j.ceramint.2018.10.069 ↗
31. Crack tolerant silicon carbide ceramics prepared by liquid-phase assisted oscillatory pressure sintering10.1016/j.ceramint.2020.04.222 ↗
32. Fabrication of wood-like porous silicon carbide ceramics without templates10.1016/j.jeurceramsoc.2010.11.036 ↗
33. Morphological, chemical surface and filtration characterization of a new silicon carbide membrane10.1016/j.jeurceramsoc.2016.10.007 ↗
34. Silicon carbide filters and porous membranes: A review of processing, properties, performance and application10.1016/j.memsci.2020.118193 ↗
35. Impact of membrane pore morphology on multi-cycle fouling and cleaning of hydrophobic and hydrophilic membranes during MBR operation10.1016/j.memsci.2018.04.014 ↗
36. Oxidation behavior of silicon carbide at 1200 °C in both air and water-vapor-rich environments10.1016/j.corsci.2014.07.052 ↗
37. Amorphous and homogeneously Zr-doped MnOx with enhanced acid and redox properties for catalytic oxidation of 1,2-Dichloroethane10.1016/j.cej.2021.131067 ↗
38. Stabilisation, rheology and application of aqueous suspensions of oxidised vs. non-oxidised SiC powder10.1016/j.matchemphys.2022.127153 ↗
39. Influence of surface oxide layer of SiC powder on the rheological properties of its slurry10.1111/ijac.13385 ↗
40. Oxidation of ZrC–30vol% SiC composite in air from low to ultrahigh temperature10.1016/j.jeurceramsoc.2011.10.024 ↗
41. Oxidation behaviour of C–SiC–ZrC composite10.1179/1432891715Z.0000000001504 ↗
42. Porous silicon carbide structures with anisotropic open porosity for high-temperature cycling applications10.1016/j.jeurceramsoc.2020.10.060 ↗
43. Ablation behaviour of C/C and C/C–ZrC–SiC composites with cone-shaped holes under an oxyacetylene flame10.1016/j.corsci.2015.09.022 ↗
44. Processing and properties of silica-bonded porous nano-SiC ceramics with extremely low thermal conductivity10.1016/j.jeurceramsoc.2019.11.072 ↗
45. SiO2 nanoparticles modified Si3N4 hollow fiber membrane for efficient oily wastewater microfiltration10.1016/j.jwpe.2019.100799 ↗
46. Zirconia ultrafiltration membranes on silicon carbide substrate: Microstructure and water flux10.1016/j.jeurceramsoc.2020.04.020 ↗
47. Enhancement of super-hydrophilic/underwater super-oleophobic performance of ceramic membrane with TiO2 nanowire array prepared via low temperature oxidation10.1016/j.ceramint.2021.12.139 ↗
48. Modified dip-coating method for preparation of pinhole-free ceramic membranes10.1016/j.memsci.2010.10.024 ↗