The Influence of Substrate Preparation on the Performance of Two Alkyd Coatings After 7 Years of Exposure in Outdoor Conditions
Source abstract
Abstract
Alkyd resins are among the most common coatings used for exterior wood joinery. In Romania, solvent-borne alkyd coatings are widely used to finish wood. The study aims to compare the performance after 7 years of outdoor exposure of two types of alkyd coatings, a semi-transparent brown stain with micronized pigments (Alk1) and an opaque white enamel (Alk2), applied directly on wood or wood pre-treated with three types of resins: acryl-polyurethane (R1), epoxy (R2), and alkyd-polyurethane (R3). Fir (Abies alba) wood served as the substrate. Cracking, coating adhesion, and biological degradation were periodically assessed through visual inspection and microscopy. Additionally, a cross-cut test was performed, and the loss of coating on the directly exposed upper faces was measured using ImageJ. The results indicated that resin pretreatments somewhat reduced cracking but negatively affected coating adhesion after long-term exposure. All samples pretreated with resins and coated with Alk1 lost more than 50% (up to 78%) of the original finishing film by the end of the test. In comparison, coated control samples lost less than 50%. The Alk2 coating exhibited a film loss between 2% and 12%, compared to an average loss of 9% for the coated control. Overall, samples pretreated with alkyd-polyurethane resin (R3) and coated with alkyd enamel (Alk2) demonstrated the best performance in terms of cracking, adhesion, and discoloration.
Source: crossref · Quality: baseline
Research context
OpenAlex topics: Wood Treatment and Properties · Building materials and conservation · Cultural Heritage Materials Analysis
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
Faculty of Furniture Design and Wood Engineering (FDMIL), Transilvania University of Brașov, 500036 Brașov, Romania
References (47)
Show source-provided references
1. Feist, W.C. (1984, January 5–8). Painting and Finishing Wood for Use Outdoors. New Ideas Materials Procedures. Proceedings of the Seventh Annual Educational Conference, Baltimore, MD, USA.
2. Williams, R.S. (2010). Finishing of wood. Wood Handbook, Chapter 16, Forest Products Laboratory, United States Department of Agriculture Forest Service.
3. Ekstedt, J. (2002). Studies On The Barrier Properties Of Exterior Wood Coatings. [Doctoral Thesis, KTH-Royal Institute of Technology].
4. Weathering properties of wood species treated with different coating applications
5. Exterior wood coatings. Part-1: Performance of semitransparent stains on preservative-treated wood10.1007/s11998-011-9332-3 ↗
6. Nejad, M., and Cooper, P.A. (2017). Exterior wood coatings. Wood in Civil Engineering, IntechOpen Limited.10.5772/67170 ↗
7. The multifactorial aspect of wood weathering: A review based on a holistic approach of wood degradation protected by clear coating
8. Oberhofnerová, E., Šimunková, K., Dvorák, O., Šterbová, I., Hiziroglu, S., Šedivka, P., and Pánek, M. (2019). Comparison of Exterior Coatings Applied to Oak Wood as a Function of Natural and Artificial Weathering Exposure. Coatings, 9.10.3390/coatings9120864 ↗
9. Coating adhesion and wettability of aged and preweathered FIR wood and pine wood surfaces
10. Comparative analysis of the quality properties of oil-based and alkyd coating materials for wood
11. Enhancing Weathering Durability of Pre-Protected and Unprotected Wood by Using Bark Extracts as Natural UV Absorbers in Waterborne Acrylic Coating10.1007/s11998-021-00528-3 ↗
12. Evaluation of natural ageing of alkyd paints used for wood protection10.1016/j.polymdegradstab.2024.110947 ↗
13. National Institute of Statistics-INS (31 October 2024). Available online: https://insse.ro/cms/ro/content/seria-silvicultura-volumul-de-lemn-exploatat-%C3%AEn-anul-2023.
14. (2019). Paints and Varnishes. Coating Materials and Coating System for Exterior Wood, Part 3: Natural Weathering Test (Standard No. EN 927-3:2019).
15. Hundhausen, U., Reimann, C., and Gobakken, L.R. (2013, January 17–19). Evaluation of mould growth on coated wood using digital image analysis (ImageJ). COST Action FP1006 Bringing new functions to wood through surface modification. Proceedings of the 3rd Workshop–Process and Service life modelling, Ghent, Belgium.
16. Podgorski, L., Reynaud, C., and Montibus, M. (2019). Fungal Growth on Coated Wood Exposed Outdoors: Influence of Coating Pigmentation, Cardinal Direction, and Inclination ofWood Surfaces. Coatings, 9.10.3390/coatings9010027 ↗
17. Dvorak, O., Kvietková, M.S., Šimunková, K., Machanec, O., Pánek, M., Pastierovič, F., Lin, C.-F., and Jones, D. (2023). The Influence of the Initial Treatment of OakWood on Increasing the Durability of Exterior Transparent Coating Systems. Polymers, 15.10.3390/polym15153251 ↗
18. (2003). Wood Preservatives-Field Test Method for Determining the Relative Protective Effectiveness of A Wood Preservative Exposed out of Ground Contact-Horizontal Lap-Joint Method (Standard No. ENV–12037:2003).
19. (2014). Wood Preservatives-Determination of the Relative Protective Effectiveness of A Wood Preservative for Use Under A Coating and Exposed out-of-Ground Contact-Field Test: L-Joint Method (Standard No. EN 330:2014).
20. Testing and evaluation of natural durability of wood in above ground conditions in Europe-An overview10.1007/s10086-005-0717-8 ↗
21. Biological durability of wood in relation to end-use--Part 2: The use of an accelerated outdoor L-joint performance test10.1007/s00107-003-0368-7 ↗
22. An Insight Into Beech Wood (Fagus sylvatica L.) Degradation in Outdoors, Above Ground, Long-time Exposure. Part 1: Degradation and Influence of Surface Treatments Revealed by Non-Destructive Evaluation after 7 Years
23. Assesing protecting efficiency of some surface treatments on fir wood after 7 years outdoor exposure
24. The effectiveness of end-grain sealers in improving paint performance in softwood joinery. L-joints results after 4 years natural weathering10.1007/BF02609599 ↗
25. Laboratory testing and computer simulation of blue stain growth on and in wood coatings10.1016/j.ibiod.2006.08.009 ↗
26. Outdoor weathering performance parameters of exterior wood coating systems on tropical hardwood substrates10.1007/s00107-014-0779-7 ↗
27. Davis, C., Leavengood, S., and Morrell, J.J. (2021). Performance of Exterior Wood Coatings in Temperate Climates. Coatings, 11.10.3390/coatings11030325 ↗
28. Effect of some formulation parameters on the penetration and adhesion of water-borne primers into wood10.1007/s001070100209 ↗
29. Assessing the performance of joinery coatings10.1007/BF02699506 ↗
30. Outdoor Wood Finishing: A Review on Making Wood Resistant to Moisture, Ultraviolet Light, and Degradation10.15376/biores.20.3.Laleicke ↗
31. Review on Solvents Based Alkyd Resins and Water Borne Alkyd Resins:Impacts of Modification on Their Coating Properties10.1007/s42250-022-00318-3 ↗
32. De Meijer, M. (1999). Interactions Between Wood and Coatings with Low Organic Solvent Content. [Ph.D. Thesis, Wageningen University].
33. Recent Developments and Trends in Sustainable and Functional Wood Coatings10.1007/s40725-023-00195-0 ↗
34. Etxeberria, I., Ingemar Svensson, I., Diaz, A.I., and Barruetabena, L. (2025). Novel Bio-Based Formulations for Alkyd Wood Coatings: Effect on Biodegradation and Technical Performance. Coatings, 15.10.3390/coatings15040400 ↗
35. Weathering performance of painted wood pretreated with water-repellent preservatives
36. Influence of biocide pre-treatment of wood on performance of exterior coatings10.1007/BF02699706 ↗
37. Current Researches on the Protection of Exterior Wood from Weathering10.5658/WOOD.2018.46.5.449 ↗
38. Weathering characteristics of impregnated and coated Calabrian pine wood10.4067/S0718-221X2021000100431 ↗
39. The Search for Durable Exterior Clear Coatings for Wood10.3390/coatings5040830 ↗
40. Pánek, M., Dvorák, O., Oberhofnerová, E., Šimunková, K., and Zeidler, A. (2019). Efectiveness of Two Different Hydrophobic Topcoats for Increasing of Durability of Exterior Coating Systems on Oak Wood. Coatings, 9.10.3390/coatings9050280 ↗
41. Natural, Accelerated and Simulated Weathering of wood: A Review10.15376/biores.15.4.Kropat ↗
42. Van Acker, J., and Stevens, M.A. (1997). New Concept for the Evaluation of Wood for out of Ground Contact Using Accelerated L-Joint Testing, International Research Group on Wood Preservation. Available online: http://hdl.handle.net/1854/LU-275427.
43. (2020). Paints and Varnishes—Cross-Cut Test (Standard No. ISO 2409:2020).
44. Yamasaki, R.S. (1965). Mechanism of Weathering of Paints. Technical Note (National Research Council of Canada. Division of Building Research), National Research Council of Canada.
45. Comparative weathering tests of North American and European exterior wood finishes
46. Evaluation of several finishes on severely weathered wood10.1007/BF02697927 ↗
47. The effect of surface roughness on the performance of finishes. Part 1. Roughness characterisation and stain performance