Simulation of Freeze–Thaw Damage and Fine Characterization of Water-Rich Sandstone Materials Based on PFC3D
Source abstract
Abstract
This paper proposes a method for simulating freeze–thaw damage in water-rich sandstone using PFC3D (Particle Flow Code in three dimensions). Water-rich sandstone is idealized as a composite system consisting of rock particles, water particles, and three types of contact surface: rock–rock, rock–water, and water–water. The volume change in water particles is governed by temperature, unfrozen water content, and porosity. During thawing, the volume change in water particles is realized by increasing the porosity after each cycle because the expansion of water particles is reflected by pore enlargement and the accumulation of externally supplied water. The proposed approach is intended for saturated or highly water-rich sandstone under laboratory freeze–thaw conditions with external water replenishment. It represents freeze–thaw damage associated with pore water freezing expansion and porosity-controlled equivalent water replenishment, whereas ice segregation, cryogenic suction, moisture migration, and a moving freezing front are not explicitly considered. A comparison between simulation results and laboratory tests indicates that the proposed method can effectively reproduce the freeze–thaw cycling process in water-rich sandstone. The results show that the mechanical behavior of sandstone after freeze–thaw cycles, including uniaxial compressive strength and elastic modulus, deteriorates significantly. The failure mode changes from shear failure to splitting failure. Freeze–thaw cycling and subsequent uniaxial compression are dominated by tensile damage, with tensile cracks accounting for approximately 90% of the total cracks. The tensile damage rate, Rt, increases exponentially. Crack development induced by freeze–thaw cycling follows an S-shaped trend and can be divided into three stages: slow crack growth from 0 to 10 cycles, rapid crack growth from 10 to 32 cycles, and a reduced growth rate after 32 cycles. The results provide a reference for the freeze–thaw damage analysis of rocks in cold regions and numerical simulations of freeze–thaw cycling processes.
Source: crossref · Quality: baseline
Research context
OpenAlex topics: Climate change and permafrost · Rock Mechanics and Modeling · Geothermal Energy Systems and Applications
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
College of Geology and Enviroment, Xi’an University of Science and Technology, Xi’an 710064, China
School of Architecture and Transportation Engineering, Guilin University of Electronic Technology, Guilin 541010, China
China Railway 22nd Bureau Group Fifth Engineering Co., Ltd., Chongqing 400042, China
Funding
Guangxi Natural Science Foundation
References (32)
Show source-provided references
1. Predicting mechanical strength loss of natural stones after freeze–thaw in cold regions10.1016/j.coldregions.2012.07.003 ↗
2. Tensile Strength of Geological Discontinuities Including Incipient Bedding, Rock Joints and Mineral Veins10.1007/s00603-016-1041-x ↗
3. Microstructural Control of Physical Properties During Deformation of Porous Limestone10.1029/2018JB015636 ↗
4. Xiao, Y.G., Deng, H.W., Tian, G.L., and Yu, S.T. (2023). Analysis of Microscopic Pore Characteristics and Macroscopic Energy Evolution of Rock Materials under Freeze–Thaw Cycle Conditions. Mathematics, 11.10.3390/math11030710 ↗
5. Critical degree of saturation: A control factor of freeze–thaw damage of porous limestones at Castle of Chambord, France10.1016/j.enggeo.2014.11.018 ↗
6. Energy Evolution and Strain Localization in Fractured Sandstone Under Freeze–Thaw Cycling and Uniaxial Loading–Unloading10.1016/j.ijrmms.2024.105746 ↗
7. A fully coupled thermohydromechanical model for fractured rock masses in cold regions10.1016/j.coldregions.2022.103707 ↗
8. On the effect of freeze–thaw on fracture and instability of hole-fissure-contained granite under uniaxial variable frequency-amplitude cyclic loads10.1016/j.coldregions.2022.103554 ↗
9. Effects of Freezing and Thawing Cycle on Mechanical Properties and Stability of Soft Rock Slope10.1155/2017/3173659 ↗
10. Study on the microscopic damage evolution and dynamic fracture properties of sandstone under freeze–thaw cycles10.1016/j.coldregions.2021.103328 ↗
11. Scrutiny of freeze–thaw cycles effect on physical and dynamic fracture characteristics of cracked sandstone10.1016/j.coldregions.2023.103837 ↗
12. Non-linear decay of building stones during freeze–thaw weathering processes10.1016/j.conbuildmat.2012.07.059 ↗
13. Microstructural, petro-graphical and mechanical studies of schist rocks under the freezing-thawing cycles10.1016/j.coldregions.2020.103039 ↗
14. Study on the simulation method and mesoscopic characteristics of rock freeze–thaw damage10.1016/j.compgeo.2022.105038 ↗
15. Rock bridge fracturing characteristics in granite induced by freeze–thaw and uniaxial deformation revealed by AE monitoring and posttest CT scanning10.1016/j.coldregions.2020.103115 ↗
16. Experimental Observations and Statistical Modeling of Crack Propagation Dynamics in Limestone by Acoustic Emission Analysis During Freezing and Thawing10.1029/2021JF006127 ↗
17. Failure mechanisms of granite in deep underground caverns influenced by rock veins: Insights from DEM-FDM cross-scale coupling and moment tensor analysis10.1016/j.compgeo.2025.107412 ↗
18. Multiscale fracture evolution in deep hard rock masses under strong excavation disturbances: Stress-mineral synergy unraveled through integrated 3D DEM–FDM modeling and borehole monitoring10.1007/s00603-025-05065-8 ↗
19. Huang, C., Zhu, C., Aluthgun Hewage, S., Ma, Y., and Shi, X. (2022). Investigating Influence of Freeze-Thaw Cycles on the Degradation of Sandstone Through Discrete Method Modeling. Proceedings of the ARMA US Rock Mechanics/Geomechanics Symposium, Santa Fe, NM, USA, 26–29 June 2022, ARMA.10.56952/ARMA-2022-0065 ↗
20. Experimental and DEM simulations of the mechanical properties of rock under freeze–thaw cycles10.1016/j.coldregions.2023.103866 ↗
21. Fracture behavior of cylindrical sandstone specimens with two preexisting flaws: Experimental investigation and PFC3D simulation10.1007/s12303-021-0013-7 ↗
22. A DEM-Based Approach for Modeling the Damage of Rock Under Freeze–Thaw Cycles10.1007/s00603-021-02465-4 ↗
23. Study on meso-fracture evolution characteristics of sandstone after freeze–thaw cycles based on discrete element method simulation
24. M.I.G. Inc. (2009). ITASCACONSULTING GROUP INC.PFC 6.0-Documentation, M.I.G. Inc.
25. A bonded-particle model for rock10.1016/j.ijrmms.2004.09.011 ↗
26. The Complete ISRM Suggested Methods for Rock Characterization, Testing and Monitoring; 1974–200610.2113/gseegeosci.15.1.47 ↗
27. Degradation characteristics of shear strength of joints in three rock types due to cyclic freezing and thawing10.1016/j.coldregions.2017.03.011 ↗
28. Rock damage and regolith transport by frost: An example of climate modulation of the geomorphology of the critical zone10.1002/esp.3330 ↗
29. Study of unfrozen water content and frost heave model for saturated rock under low temperature
30. Study of effects of microparameters on macroproperties for parallel bonded model
31. Frost damage to stone and concrete: Geological considerations10.1016/0013-7952(68)90010-0 ↗
32. Effect of Freezing and Thawing on Microstructure Damage and Dynamic Flexural Tension of Granite10.1007/s00603-020-02127-x ↗