Microstructure and Corrosion Behavior of Thermal-Sprayed Hydroxyapatite/Magnesium Composite Coating on the Surface of AZ91D Magnesium Alloy
Source abstract
Abstract
To slow down the corrosion rate and increase the bioactivity of magnesium alloys, biodegradable hydroxyapatite/magnesium (HA/Mg) composite coating was deposited onto AZ91D alloy substrate by high-velocity suspension flame spray technique using nano-sized HA and micron-sized Mg powders. Microstructures and phase constitutions of HA/Mg composite coating were analyzed by scanning electron microscopy and x-ray diffraction. Corrosion resistance of composite coating was also evaluated by potentiodynamic polarization test and electrochemical impedance spectroscopy in Hanks’ balanced salt solution (HBSS). The result shows that the HA/Mg composite coating mainly consisted of Mg and HA in addition to a few of MgO phases. The coating showed a rough surface morphology with homogeneous elemental distribution and a lamellar structure in cross section as well as well-bonded coating/substrate interface. Mg particles presented superior deposition during spraying due to their higher melting degree compared to HA particles. AZ91D alloy substrate was significantly protected from corrosion in HBSS by the HA/Mg composite coating with Mg dissolution on surfaces of the composite coating. This strategy can offer a new route to fabricate HA/Mg composite coatings on other metal substrates for use in biodegradable implant fields.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Magnesium Alloys: Properties and Applications · Bone Tissue Engineering Materials · Layered Double Hydroxides Synthesis and Applications
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (33)
Show source-provided references
1. R. Zeng, W. Dietzel, F. Witte, N. Hort, and C. Blawert, Progress and Challenge for Magnesium Alloys as Biomaterials, Adv. Eng. Mater., 2010, 10, p 12
2. S. Shadanbaz and G.J. Dias, Calcium Phosphate Coatings on Magnesium Alloys for Biomedical Applications: A Review, Acta Biomater., 2012, 8, p 2010.1016/j.actbio.2011.10.016 ↗
3. M.S. Uddin, C. Hall, and P. Murphy, Surface Treatments for Controlling Corrosion Rate of Biodegradable Mg and Mg-Based Alloy Implants, Sci. Technol. Adv. Mater., 2015, 16, p 05350110.1088/1468-6996/16/5/053501 ↗
4. D. Chen, R. Wang, Z. Huang, Y. Wu, Y. Zhang, and G. Wu, Evolution Processes of the Corrosion Behavior and Structural Characteristics of Plasma Electrolytic Oxidation Coatings on AZ31 Magnesium Alloy, Appl. Surf. Sci., 2018, 434, p 32610.1016/j.apsusc.2017.09.232 ↗
5. C. Wang, B. Jiang, M. Liu, and Y. Ge, Corrosion Characterization of Micro-arc Oxidization Composite Electrophoretic Coating on az31b Magnesium Alloy, J. Alloy. Compd., 2015, 621, p 5310.1016/j.jallcom.2014.09.168 ↗
6. W.F. Ng, M.H. Wong, and F.T. Cheng, Stearic Acid Coating on Magnesium for Enhancing Corrosion Resistance in Hanks’ Solution, Surf. Coat. Technol., 2010, 204(11), p 182310.1016/j.surfcoat.2009.11.024 ↗
7. S. Gaur, R.K. Singh Raman, and A.S. Khanna, In Vitro Investigation of Biodegradable Polymeric Coating for Corrosion Resistance of mg-6zn-ca Alloy in Simulated Body Fluid, Mater. Sci. Eng. C Mater. Biol. Appl., 2014, 42, p 9110.1016/j.msec.2014.05.035 ↗
8. P. Amaravathy, S. Sowndarya, S. Sathyanarayanan, and N. Rajendran, Novel Sol Gel Coating of Nb2O5 on Magnesium Alloy for Biomedical Applications, Surf. Coat. Technol., 2014, 244(15), p 13110.1016/j.surfcoat.2014.01.050 ↗
9. H. Amiri, I. Mohammadi, and A. Afshar, Electrophoretic Deposition of Nano-Zirconia Coating on AZ91D Magnesium Alloy for Bio-Corrosion Control Purposes, Surf. Coat. Technol., 2016, 311, p 18210.1016/j.surfcoat.2016.12.103 ↗
10. F.M. Rojaee, K. Raeissi, and A. Sharifnabi, Biodegradation Assessment of Nanostructured Fluoridated Hydroxyapatite Coatings on Biomedical Grade Magnesium Alloy, Ceram. Int., 2014, 40, p 10
11. S.Z. Khalajabadi, A.H. Abu, N. Ahmad, M. Kadir, and A. Ismail, Biodegradable Mg/HA/TiO2 Nanocomposites Coated with MgO and Si/MgO for Orthopedic Applications: A Study on the Corrosion, Surface Characterization and Biocompatability, Coatings, 2017, 7, p 15410.3390/coatings7100154 ↗
12. A. Arifin, A. Sulong, N. Muhamad, J. Syarif, and M.I. Ramli, Material Processing of Hydroxyapatite and Titanium Alloy (HA/Ti) Composite as Implant Materials Using Powder Metallurgy: A Review, Mater. Des., 2014, 55, p 165-17510.1016/j.matdes.2013.09.045 ↗
13. M. Die, M.H. Kang, S.M. Kim, H.E. Kim, and J. Song, Hydroxyapatite (HA) Poly-l-Lactic Acid (PLLA) Dual Coating on Magnesium Alloy Under Deformation for Biomedical Applications, J. Mater. Sci. Mater. Med., 2015, 27, p 34
14. W. Fan, H. Du, Y. An, C. Guo, Y. Wei, and L. Hou, Fabrication and Characterization of a Hydroxyapatite–Methylcellulose Composite Coating on the Surface of AZ31 Magnesium Alloy, Mater. Lett., 2015, 152, p 3210.1016/j.matlet.2015.03.068 ↗
15. S.Z. Khalajabadi, M.R.A. Kadir, S. Izman, H.R. Bakhsheshi-Rad, and S. Farahany, Effect of Mechanical Alloying on the Phase Evolution, Microstructure and Bio-Corrosion Properties of a Mg/HA/TiO2/MgO Nanocomposite, Ceram. Int., 2014, 40, p 1710.1016/j.ceramint.2014.08.039 ↗
16. M. Zhang, S. Cai, F.Y. Zhang, G.H. Xu, F.W. Wang, N. Yu, and X.D. Wu, Preparation and Corrosion Resistance of Magnesium Phytic Acid/Hydroxyapatite Composite Coatings on Biodegradable AZ31 Magnesium Alloy, J. Mater. Sci. Mater. Med., 2017, 28, p 8210.1007/s10856-017-5876-9 ↗
17. G.Y. Xiong, Y.J. Nie, D.H. Ji, J. Li, C.Z. Li, W. Li, Y. Zhu, H.L. Luo, and Y.Z. Wan, Characterization of Biomedical Hydroxyapatite/Magnesium Composites Prepared by Powder Metallurgy Assisted with Microwave Sintering, Curr. Appl. Phys., 2016, 16, p 83010.1016/j.cap.2016.05.004 ↗
18. J. Kubasek, D. Vojtech, J. Maixner, and D. Dvorsky, The Effect of Hydroxyapatite Reinforcement and Preparation Methods on the Structure and Mechanical Properties of Mg-HA Composites, Sci. Eng. Compos. Mater., 2017, 24, p 29710.1515/secm-2015-0006 ↗
19. X.Y. Ni, A.J. Li, X.B. Xiong, R.C. Bai, and D. Zhou, Effect of Electromagnetic Induction Deposition’s Heating Time of Magnesium-Hydroxyapatite Coating on Carbon/Carbon Composites, J. Biobased Mater. Bioener., 2014, 8, p 60310.1166/jbmb.2014.1475 ↗
20. C.C. Berndt, M.F. Hasan, U. Tietz, and K.P. Schmitz, A Review of Hydroxyapatite Coatings Manufactured by Thermal Spray, vol. 2, p. 267. Springer, Berlin (2014)10.1007/978-3-642-53980-0_9 ↗
21. H.L. Yao, H.T. Wang, X.B. Bai, G.C. Ji, and Q.Y. Chen, Improvement in Mechanical Properties of Nano-Structured HA/TiO2 Multilayer Coatings Deposited by High Velocity Suspension Flame Spraying (HVSFS), Surf. Coat. Technol., 2018, 342, p 9410.1016/j.surfcoat.2018.02.058 ↗
22. H.L. Yao, Y.L. Zou, X.B. Bai, H.T. Wang, G.C. Ji, and Q.Y. Chen, Microstructures, Mechanical Properties and Electrochemical Behaviors of Nano-structured HA/Ti Composite Coatings Deposited by High-Velocity Suspension Flame Spray (HVSFS), Ceram. Int., 2018, 44, p 1302410.1016/j.ceramint.2018.04.121 ↗
23. M.E. Derevyaga, Effect of Pressure on Magnesium Combustion, Combust. Explos. Shock Waves, 1983, 19, p 3110.1007/BF00790232 ↗
24. H.M. Cassel and I. Liebman, Combustion of Magnesium Particles I, Combust. Flame, 1962, 6, p 15310.1016/0010-2180(62)90084-6 ↗
25. Y. Lu, M. Li, S. Li, Z. Wang, and R. Zhu, Plasma-Sprayed Hydroxyapatite + Titania Composite Bond Coat for Hydroxyapatite Coating on Titanium Substrate, Biomaterials, 2004, 25(18), p 439310.1016/j.biomaterials.2003.10.092 ↗
26. M.H. Song, G.H. Wu, G.Q. Chen, and W.S. Yang, Thermal Expansion and Dimensional Stability of Unidirectional and Orthogonal Fabric M40/AZ91D Composites, Trans. Nonferrous Metals Soc. China, 2010, 20(1), p 4710.1016/S1003-6326(09)60095-9 ↗
27. R.B. Heimann, Plasma-Sprayed Hydroxylapatite Coatings as Biocompatible Intermediaries Between Inorganic Implant Surfaces and Living Tissue, J. Therm. Spray Technol. 1 (2018).10.1007/s11666-018-0737-8 ↗
28. Y.F. Ding, C.E. Wen, P. Hodgson, and Y.C. Li, Effects of Alloying Elements on the Corrosion Behavior and Biocompatibility of Biodegradable Magnesium Alloys: A Review, J. Mater. Chem. B, 2014, 2, p 191210.1039/C3TB21746A ↗
29. R.D. Campo, B. Savoini, A. Muñoz, M.A. Monge, and G. Garcés, Mechanical Properties and Corrosion Behavior of Mg-HAp Composites, J. Mech. Behav. Biomed. Mater., 2014, 39, p 23810.1016/j.jmbbm.2014.07.014 ↗
30. F. Witte, F. Feyerabend, P. Maier, J. Fischer, M. Störmer, and C. Blawert, Biodegradable Magnesium-Hydroxyapatite Metal Matrix Composites, Biomaterials, 2007, 28(13), p 216310.1016/j.biomaterials.2006.12.027 ↗
31. K. Mensah-Darkwa, R.K. Gupta, and D. Kumar, Mechanical and Corrosion Properties of Magnesium–Hydroxyapatite (Mg–HA) Composite Thin Films, J. Mater. Sci. Technol., 2013, 29(9), p 78810.1016/j.jmst.2013.04.019 ↗
32. Y.L. Gao, Y. Liu, and X.Y. Song, Plasma-Sprayed Hydroxyapatite Coating for Improved Corrosion Resistance and Bioactivity of Magnesium Alloy, J. Therm. Spray Technol., 2018, https://doi.org/10.1007/s11666-018-0760-910.1007/s11666-018-0760-9 ↗
33. S.Z. Khalajabadi, M.R.A. Kadir, S. Izman, and M. Marvibaigi, The Effect of Mgo on the Biodegradation, Physical Properties and Biocompatibility of a Mg/HA/MgO Nanocomposite Manufactured by Powder Metallurgy Method, J. Alloy. Compd., 2016, 655, p 26610.1016/j.jallcom.2015.09.107 ↗