journal article·2004-07

On buckling loads for edge-loaded orthotropic plates including transverse shear

Tomas Nordstrand

Composite Structures· Volume 65· Issue 1
Publisher page

Abstract

Abstract Corrugated board usually exhibits low transverse shear stiffness, especially across the corrugations. In the present study the transverse shear is included in an analysis to predict the critical buckling load of an edge-loaded orthotropic linear elastic sandwich plate with all edges simply supported. In the analysis, effective (homogenised) properties of the corrugated core are used. Classical elastic buckling theory of orthotropic sandwich plates predicts that such plates have a finite buckling coefficient when the aspect ratio, i.e. the ratio between the height and width of the plate, becomes small. However, inclusion in the governing equilibrium equations of the additional moments, produced by the membrane stresses in the plate at large transverse shear deformations, gives a buckling coefficient which approaches infinity when the aspect ratio goes to zero. This improvement was first included in the buckling theory of helical springs by Harinx [Proc. Konjlike Nederland Akademie Wettenschappen, vol. 45, 1942, Amsterdam, Holland, pp. 533–539, 650–654] and later applied to orthotropic plates by Bert and Chang [J. Eng. Mech. Division, Proc. Am. Soc. Civil Engrs. 98 (EM6) (1972) 1499–1509]. Some inconsistencies in the latter analysis have been considered. The critical buckling load calculated with corrected analysis is compared with a predicted load obtained using finite element analysis of a corrugated board panel, and also with the critical buckling load obtained from panel compression tests.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Material Properties and Processing · Vibration and Dynamic Analysis · Metal Forming Simulation Techniques

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (15)

Show source-provided references
1. Transverse shear stiffness of structural core sandwich10.1016/0263-8223(94)90091-4 ↗
2. Evaluation of transverse shear stiffness of structural core sandwich plates10.1016/S0263-8223(97)80007-4 ↗
3. The effect of transverse shear deformation on bending of elastic plates10.1115/1.4009435 ↗
4. Plantema · 1966
5. Harinx JA. On buckling and the lateral rigidity of helical compression springs. Proceedings of the Konjlike Nederland Akademie Wettenschappen 45. Amsterdam, Holland, 1942. p. 533–9, 650–4
6. Shear-flexible orthotropic plates loaded in-plane10.1061/JMCEA3.0001695 ↗
7. Jones · 1975
8. On the elastic stiffnesses of corrugated core sandwich10.1106/BKJF-N2TF-AQ97-H72R ↗
9. Libove C, Hubka RE. Elastic constants for corrugated core sandwich plates. NACA, TN 2289, 1951
10. Orthotropic elastic constants of paper
11. Poisson's ratio of paper
12. Parametrical study of the post-buckling strength of structural core sandwich panels10.1016/0263-8223(94)00066-2 ↗
13. ANSYS User's Manual, Swanson Analysis System Inc., vol. 1–2, 1989
14. Analysis of thick and thin shell structures by curved finite elements10.1002/nme.1620020310 ↗
15. Analysis and testing of corrugated board panels into the post-buckling regime10.1016/S0263-8223(03)00155-7 ↗