journal article·2020-12Open access

Flexural behavior of bamboo–concrete composite beams with perforated steel plate connections

Zhiyuan Wang, Yang Wei, Ning Li, Kang Zhao, Mingmin Ding

Journal of Wood Science· Volume 66· Issue 1

Abstract

Abstract A new type of bamboo–concrete composite structure using perforated steel plates as connectors was proposed. To study the composite effect of this new type of composite structure, the slip behavior of bamboo–concrete shear connectors was first studied through push-out tests. Subsequently, four-point bending tests of ten bamboo–concrete composite beams were carried out. The results show that the failure of bamboo–concrete shear connectors occurred between the perforated steel plate and the concrete, and there was no obvious damage between the perforated steel plate and the bamboo. The load carrying capacity of perforated steel plate connectors was relatively stable. The failure mode was moderate failure. Considering the three stages of the load–slip curve, an exponential function is proposed to describe the load–slip curve. The failure modes of composite beams can be summarized as two types. In the first type, the bamboo beam ruptures on the bottom and the concrete dose not suffer significant damage; in the second type, the top surface of the concrete first exhibits longitudinal cracks, and finally, the bamboo beam ruptures. Compared with bamboo beams, the ultimate load of composite beams increased by 1.2–1.5 times, and the sectional stiffness of composite beams increased by 2.9–4.2 times. The equivalent section stiffness was obtained after determining the connection coefficient, and the connection coefficient γb ranged between 0.50 and 0.80 and decreased as the center spacing of the perforated steel plate increased. The equivalent cross-section stiffness obtained by different load stages of the shear slip stiffness was calculated to predict the mid-span displacement. The calculation results show that the effect of slip stiffness on the equivalent stiffness of cross section is not sensitive, and a 35% increase in slip stiffness results in a maximum increase in equivalent section stiffness of only 6%.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Bamboo properties and applications · Tree Root and Stability Studies · Structural Load-Bearing Analysis

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (33)

Show source-provided references
1. Chen G, Li HT, Zhou T, Li CL, Song YQ, Xu R (2015) Experimental evaluation on mechanical performance of OSB webbed parallel strand bamboo I-joist with holes in the web. Constr Build Mater 101(12):91–98. https://doi.org/10.1016/j.conbuildmat.2015.10.04110.1016/j.conbuildmat.2015.10.041 ↗
2. Chen G, He B (2017) Stress-strain constitutive relation of OSB under axial loading: an experimental investigation. Bioresources 12(3):6142–6156. https://doi.org/10.15376/biores.12.3.6142-615610.15376/biores.12.3.6142-6156 ↗
3. Lee PH, Odlin M, Yin H (2014) Development of a hollow cylinder test for the elastic modulus distribution and the ultimate strength of bamboo. Constr Build Mater 51(2):235–243. https://doi.org/10.1016/j.conbuildmat.2013.10.05110.1016/j.conbuildmat.2013.10.051 ↗
4. Moran R, Webb K, Harries K, García JJ (2017) Edge bearing tests to assess the influence of radial gradation on the transverse behavior of bamboo. Constr Build Mater 131(1):574–584. https://doi.org/10.1016/j.conbuildmat.2016.11.10610.1016/j.conbuildmat.2016.11.106 ↗
5. Taufani AR, Nugroho ASB (2014) Proposed bamboo school buildings for elementary schools in Indonesia. Procedia Eng 95:5–14. https://doi.org/10.1016/j.proeng.2014.12.15910.1016/j.proeng.2014.12.159 ↗
6. Tian LM, Kou YF, Hao JP (2019) Flexural behavior of sprayed lightweight composite mortar-original bamboo composite beams: experimental study. Bioresources 14(1):500–517. https://doi.org/10.15376/biores.14.1.500-51710.15376/biores.14.1.500-517 ↗
7. Moroz JG, Lissel SL, Hagel MD (2014) Performance of bamboo reinforced concrete masonry shear walls. Constr Build Mater 61(6):125–137. https://doi.org/10.1016/j.conbuildmat.2014.02.00610.1016/j.conbuildmat.2014.02.006 ↗
8. Javadian A, Wielopolski M, Smith IFC, Hebel DE (2016) Bond-behavior study of newly developed bamboo-composite reinforcement in concrete. Constr Build Mater 122(9):110–117. https://doi.org/10.1016/j.conbuildmat.2016.06.08410.1016/j.conbuildmat.2016.06.084 ↗
9. Karthik S, Rao PRM, Awoyera PO (2017) Strength properties of bamboo and steel reinforced concrete containing manufactured sand and mineral admixtures. J King Saud Univ Eng Sci 29(4):400–406. https://doi.org/10.1016/j.jksues.2016.12.00310.1016/j.jksues.2016.12.003 ↗
10. Shangguan W, Zhong Y, Xing X, Zhao R, Ren H (2015) Strength models of bamboo scrimber for compressive properties. J Wood Sci 61(2):1–8. https://doi.org/10.1007/s10086-014-1444-910.1007/s10086-014-1444-9 ↗
11. Zhong Y, Wu G, Ren H, Jiang Z (2017) Bending properties evaluation of newly designed reinforced bamboo scrimber composite beams. Constr Build Mater 143(7):61–70. https://doi.org/10.1016/j.conbuildmat.2017.03.05210.1016/j.conbuildmat.2017.03.052 ↗
12. Wei Y, Ji XW, Duan MJ, Li GF (2017) Flexural performance of bamboo scrimber beams strengthened with fiber-reinforced polymer. Constr Build Mater 142(7):66–82. https://doi.org/10.1016/j.conbuildmat.2017.03.05410.1016/j.conbuildmat.2017.03.054 ↗
13. Li HT, Wu G, Zhang QS, Deeks AJ, Su JW (2018) Ultimate bending capacity evaluation of laminated bamboo lumber beams. Constr Build Mater 160(1):365–375. https://doi.org/10.1016/j.conbuildmat.2017.11.05810.1016/j.conbuildmat.2017.11.058 ↗
14. Wei Y, Zhou MQ, Chen DJ (2015) Flexural behaviour of glulam bamboo beams reinforced with near-surface mounted steel bars. Mater Res 19(sup1):S1–S98. https://doi.org/10.1179/1432891715z.000000000137710.1179/1432891715z.0000000001377 ↗
15. Yan Y, Liu H, Zhang X, Wu H, Yun H (2016) The effect of depth and diameter of glued-in rods on pull-out connection strength of bamboo glulam. J Wood Sci 62(1):109–115. https://doi.org/10.1007/s10086-015-1516-510.1007/s10086-015-1516-5 ↗
16. Auclair SC, Sorelli L, Salenikovich A (2016) A new composite connector for timber-concrete composite structures. Constr Build Mater 112(6):84–92. https://doi.org/10.1016/j.conbuildmat.2016.02.02510.1016/j.conbuildmat.2016.02.025 ↗
17. Martins C, Dias AMPG, Costa R, Santos P (2016) Environmentally friendly high performance timber–concrete panel. Constr Build Mater 102(2):1060–1069. https://doi.org/10.1016/j.conbuildmat.2015.07.19410.1016/j.conbuildmat.2015.07.194 ↗
18. Boccadoro L, Zweidler S, Steiger R, Frangi A (2017) Bending tests on timber-concrete composite members made of beech laminated veneer lumber with notched connection. Eng Struct 132(2):14–28. https://doi.org/10.1016/j.engstruct.2016.11.02910.1016/j.engstruct.2016.11.029 ↗
19. Tannert T, Endacott B, Brunner M, Vallee T (2017) Long-term performance of adhesively bonded timber-concrete-composites. Int J Adhes Adhes 72(1):51–61. https://doi.org/10.1016/j.ijadhadh.2016.10.00510.1016/j.ijadhadh.2016.10.005 ↗
20. Kozma A, Odenbreit C, Braun MV, Veljkovic M, Nijgh MP (2019) Push-out tests on demountable shear connectors of steel-concrete composite structures. Structures. https://doi.org/10.1016/j.istruc.2019.05.01110.1016/j.istruc.2019.05.011 ↗
21. Katwal U, Tao Z, Hassan MK (2018) Finite element modelling of steel-concrete composite beams with profiled steel sheeting. J Constr Steel Res 146(7):1–15. https://doi.org/10.1016/j.jcsr.2018.03.01110.1016/j.jcsr.2018.03.011 ↗
22. Lasheen M, Shaat A, Khalil A (2018) Numerical evaluation for the effective slab width of steel-concrete composite beams. J Constr Steel Res 148(9):124–137. https://doi.org/10.1016/j.jcsr.2018.05.01510.1016/j.jcsr.2018.05.015 ↗
23. Song A, Wan S, Jiang Z, Xu J (2018) Residual deflection analysis in negative moment regions of steel-concrete composite beams under fatigue loading. Constr Build Mater 158(1):50–60. https://doi.org/10.1016/j.conbuildmat.2017.09.07510.1016/j.conbuildmat.2017.09.075 ↗
24. Tian LM, Kou YF, Hao JP (2019) Axial compressive behaviour of sprayed composite mortar-original bamboo composite columns. Constr Build Mater 215:726–736. https://doi.org/10.1016/j.conbuildmat.2019.04.23410.1016/j.conbuildmat.2019.04.234 ↗
25. Shan B, Xiao Y, Zhang WL, Liu B (2017) Mechanical behavior of connections for glubam-concrete composite beams. Constr Build Mater 143(7):158–168. https://doi.org/10.1016/j.conbuildmat.2017.03.13610.1016/j.conbuildmat.2017.03.136 ↗
26. Wei Y, Ji XW, Zhou MQ, Zhao LL, Duan MJ (2017) Mechanical properties of bamboo–concrete composite structures with dowel-type connections. Trans Chin Soc Agric Eng 33(3):65–72. https://doi.org/10.11975/j.issn.1002-6819.2017.03.009 (in Chinese)10.11975/j.issn.1002-6819.2017.03.009 ↗
27. Wei Y, Li N, Wu G, Duan MJ, Li GF (2017) Load-slip behavior of perforated plate connections of bamboo–concrete. J Southeast Univ 47(6):1167–1173. https://doi.org/10.3969/j.issn.1001-0505.2017.06.014 (in Chinese)10.3969/j.issn.1001-0505.2017.06.014 ↗
28. Wei Y, Zhou MQ, Ji XW, Duan MJ, Li GF (2017) Flexural performance of composite bamboo–concrete beams. J Southwest Jiaotong Univ 52(6):1148–1151. https://doi.org/10.3969/j.issn.0258-2724.2017.06.015 (in Chinese)10.3969/j.issn.0258-2724.2017.06.015 ↗
29. Ding LN, Xia L, Xin W, Jiao HH, Shen WZ (2018) Mechanical properties of pultruded basalt fiber-reinforced polymer tube under axial tension and compression. Constr Build Mater 176(7):629–637. https://doi.org/10.1016/j.conbuildmat.2018.05.03610.1016/j.conbuildmat.2018.05.036 ↗
30. Wang LB, Wu Y, Noori M (2015) Parameters of static response of carbon fiber reinforced polymer (CFRP) suspension cables. J Cent South Univ 22(8):3123–3132. https://doi.org/10.1007/s11771-015-2849-310.1007/s11771-015-2849-3 ↗
31. Zhang YX, Peng H, Lv WH (2018) Shear stress transfer model for evaluating the fracture behaviour of SHCCs for RC shear strengthening. Mag Concr Res 70(10):1–7. https://doi.org/10.1680/jmacr.17.0010410.1680/jmacr.17.00104 ↗
32. ASTM D143-09 (2009) Standard test methods for small clear specimens of timber. Pennsylvania, USA
33. Gutkowski R, Brown K, Shigidi A, Natterer J (2008) Laboratory tests of composite wood–concrete beams. Constr Build Mater 22(6):1059–1066. https://doi.org/10.1016/j.conbuildmat.2007.03.01310.1016/j.conbuildmat.2007.03.013 ↗