journal article·2016-12Open access

Local Viscosity Control Printing for High-Throughput Additive Manufacturing of Polymers

Joshua E. Siegel, Dylan C. Erb, Isaac M. Ehrenberg, Pranay Jain, Sanjay E. Sarma

Abstract

Fused deposition modeling's (FDM) throughput is limited by process physics as well as practical considerations favoring single-head polymer extrusion. To expedite the thermoplastic additive manufacturing process, we propose a parallelized material deposition process called local viscosity control (LVC) additive manufacturing. LVC prints an entire layer in one step by selectively modulating the viscosity of polymer feedstock in contact with a heated wire mesh. Layers of molten polymer are contact printed, with the relative motion between the wire mechanism and a build plate allowing wetting and surface tension to transfer selectively heated, lower viscosity regions of polymer to a fixed substrate. Experiments demonstrate the viability of this process using a single cell depositing layered polycarbonate pixels. Theoretical analysis shows this process may offer similar capabilities in resolution to conventional FDM with a significantly higher production rate for commonly available input power.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Additive Manufacturing and 3D Printing Technologies · Injection Molding Process and Properties · Nanofabrication and Lithography Techniques

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

Massachusetts Institute of Technology, Cambridge, Massachusetts.

References (12)

Show source-provided references
1. 10.1115/1.168837710.1115/1.1688377 ↗
2. 10.1016/S0007-8506(07)63240-510.1016/S0007-8506(07)63240-5 ↗
3. WachsmuthJP. Dissertation. Multiple independent extrusion heads for fused deposition modeling. Virginia Polytechnic Institute and State University 2008.
4. 10.1201/b11341-8310.1201/b11341-83 ↗
5. 10.3184/003685012X1342098446304710.3184/003685012X13420984463047 ↗
6. 10.1002/adma.20120332110.1002/adma.201203321 ↗
7. HarperCA. Handbook of Plastics, Elastomers, and Composites, 2nd ed. New York: McGraw-Hill, 1996.
8. 10.1007/978-3-540-30738-9_310.1007/978-3-540-30738-9_3 ↗
9. 10.1016/0021-9797(82)90263-610.1016/0021-9797(82)90263-6 ↗
10. 10.1016/0021-9797(84)90407-710.1016/0021-9797(84)90407-7 ↗
11. 10.1108/1355254061063725510.1108/13552540610637255 ↗
12. 10.1016/j.addma.2016.03.00110.1016/j.addma.2016.03.001 ↗