Analysis of cutting force coefficients in high-speed ball end milling at varying rotational speeds
Source abstract
Abstract
In high-speed ball end milling, cutting forces influence machinability, dimensional accuracy, tool failure, tool deflection, machine tool chatter, vibration, etc. Thus, an accurate prediction of cutting forces before actual machining is essential for a good insight into the process to produce good quality machined parts. In this article, an attempt has been made to determine specific cutting force coefficients in ball end milling based on a linear mechanistic model at a higher range of rotational speeds. The force coefficients have been determined based on average cutting force. Cutting force in one revolution of the cutter was recorded to avoid the cutter run-out condition (radial). Milling experiments have been conducted on aluminum alloy of grade Al2014-T6 at different spindle speeds and feeds. Thus, the dependence of specific cutting force coefficients on cutting speeds has been studied and analyzed. It is found that specific cutting force coefficients change with change in rotational speed while keeping other cutting parameters unchanged. Hence, simulated cutting forces at higher range of rotational speed might have considerable errors if specific cutting force coefficients evaluated at lower rotational speed are used. The specific cutting force coefficients obtained analytically have been validated through experiments.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Advanced machining processes and optimization · Advanced Machining and Optimization Techniques · Metal Alloys Wear and Properties
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
Department of Mechanical Engineering, National Institute of Technology, Durgapur, India
Faculty of Mechanical, National Institute of Technology, Durgapur, India
Advance Design and Optimization, CSIR-CMERI, Durgapur, India
References (22)
Show source-provided references
1. Altintas Y.
2. Altintas Y. · 1998 · 120 · 684
3. Altintas Y. · 1991 · 40 · 31
4. Axinte D. · 2010 · 224 · 15
5. Budak E. · 1996 · 118 · 216
6. Dewes R.C. · 1997 · 69 · 1
7. Gao G. · 2013 · 26 · 823
8. Gok A. · 2013 · 63 · 1063
9. Gonzalo O. · 2010 · 50 · 765
10. Grossi N. · 2015 · 42 · 321
11. Kline W.A. · 1982 · 22 · 7
12. Lamikiz A. · 2004 · 44 · 1511
13. Ma J. · 2014 · 29 · 364
14. Sadeghi M.H. · 2003 · 22 · 775
15. Schulz H. · 1992 · 41 · 637
16. Sun Y. · 2009 · 49 · 1238
17. Wan M. · 2007 · 47 · 1767
18. Wang F. · 2014 · 18 · 448
19. Wang M. · 2014 · 78 · 1
20. 10.1016/j.ijmachtools.2014.10.00610.1016/j.ijmachtools.2014.10.006 ↗
21. Wojciechowski S. · 2012 · 1 · 680
22. Zhu R. · 2001 · 123 · 369