journal article·2018-03-04

Temperature measurement and machining damage in slotting of multidirectional CFRP laminate

Souhir Gara, Samir M'hamed, Oleg Tsoumarev

Machining Science and Technology· Volume 22· Issue 2
Publisher page

Abstract

Compared to metallic materials, carbon fiber-reinforced plastics (CFRPs) have lower thermal conductivity and minor thermal expansion coefficient. Despite this, their machining can generate accuracy errors if the cutting temperature is not controlled. In this paper, an experimental study of slotting of multidirectional CFRP laminate (G803/914) with three micrograin carbide burr tools with different geometries is considered in order to investigate tool-workpiece contact point temperature, chip temperature, machined surface damage, subsurface defects and tool degradation. The experiment is made on a computer numerical control (CNC) machine with cutting speed ranging from 80 to 200 m/min and feed per tooth from 0.008 to 0.060 mm/rev/tooth. The data were analyzed in order to establish empirical models showing the dependence of cutting temperature on tool geometry and cutting conditions. Based on the results, it is concluded that cutting speed is the factor influencing cutting temperature the most, the heat generated during slotting is removed mainly by chips and the chip temperature is greater than the tool-workpiece contact temperature of about 18.5°C on average for the three burr tools.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Advanced machining processes and optimization · Mechanical Behavior of Composites · Advanced Surface Polishing Techniques

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

Mechanical Department, Laboratoire de Recherche Mécanique Appliquée et Ingénierie, Le Belvédère, Tunisia

Department of Mechanical Engineering, Institut Supérieur des Etudes Technologiques de Nabeul, Nabeul, Tunisia

References (14)

Show source-provided references
1. Chatterjee A. · 2009 · 114 · 1417
2. 10.1007/s00170-015-8185-910.1007/s00170-015-8185-9 ↗
3. 10.1007/s00170-016-9161-810.1007/s00170-016-9161-8 ↗
4. Ghafarizadeh S. · 2015 · 50 · 1059
5. Haddad M. · 2013 · 13 · 289
6. Janardhan, P. (December 2005) Tool wear of diamond interlocked tools in routing of CFRP composites, Thesis, Faculty of the Graduate School, Wichita State University.
7. Liu J. · 2014 · 86 · 89
8. Merino Pérez J.L. · 2015 · 123 · 161
9. Sreejith P.S. · 2007 · 193 · 88
10. Turki, Y. (2013) Etude expérimentale des mécanismes de coupe des matériaux composites carbone/époxy: Application au perçage. Thesis, Picardie Jules Verne University.
11. Turner J. · 2015 · 1 · 54
12. Wang H. · 2016 · 82 · 1517
13. Weinert K. · 2004 · 6 · 684
14. Yashiro T. · 2013 · 70 · 63