journal article·2018-03

Influence of chloride ion on depassivation of passive film on galvanized steel bars in concrete pore solution

Haibing Zheng, Jian-Guo Dai, Weihua Li, Chi Sun Poon

Publisher page

Abstract

Abstract This work aimed at studying the depassivation mechanism of the passive film on galvanized steel bar in concrete pore solution with different concentrations of chloride ion. The results showed that in a saturated Ca(OH)2 solution, the critical chloride values for the depassivation of the passive films formed on galvanized steel bars and zinc metal specimens were 0.2 M and 0.3 M respectively. When the Cl− concentration was lower than the critical value, the donor density of the passive film increased and thus the protective property reduced with increasing the concentration of chloride ion, which could be interpreted by the point defect model (PDM). The corrosion products formed on the galvanized steel surface could inhibit the further ingress of the chloride ions and enhance the protective property, while such effect was not obvious for the zinc metal.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Concrete Corrosion and Durability · Corrosion Behavior and Inhibition · Hydrogen embrittlement and corrosion behaviors in metals

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (48)

Show source-provided references
1. Corrosion and corrosion products of hot dipped galvanized steel during long term atmospheric exposure at different sites world-wide10.1016/j.corsci.2017.06.025 ↗
2. Effect of Fe–Zn alloy layer on the corrosion resistance of galvanized steel in chloride containing environments10.1016/j.corsci.2007.03.039 ↗
3. Corrosion resistance of galvanized steel reinforcements in carbonated concrete: effect of wet–dry cycles in tap water and in chloride solution on the passivating layer10.1016/j.cemconres.2014.07.014 ↗
4. Yeomans · 2004
5. Effect of surface condition on the initial corrosion of galvanized reinforcing steel embedded in concrete10.1016/j.corsci.2008.06.035 ↗
6. Corrosion of galvanized steel reinforcements in alkaline solutions. Part 1: Electrochemical results10.1179/000705987798271631 ↗
7. Corrosion of galvanized steel reinforcements in alkaline solutions. Part 2: SEM study and identification of corrosion products10.1179/000705987798271749 ↗
8. Corrosion rate of galvanized steel immersed in saturated solutions of Ca(OH)2 in the pH range 12–13.810.1179/bcj.1983.18.2.82 ↗
9. Influence of the conversion coating on the corrosion of galvanized reinforcing steel10.1016/j.cemconcomp.2006.01.010 ↗
10. Electrochemical and analytical assessment of galvanized steel reinforcement pre-treated with Ce and La salts under alkaline media10.1016/j.cemconcomp.2006.01.004 ↗
11. Investigation of the major reduction reaction occurring during the passivation of galvanized steel rebars10.1016/j.corsci.2009.11.021 ↗
12. The protective efficiency of galvanizing against corrosion of steel in mortar and in Ca(OH)2 saturated solutions containing chlorides10.1016/0008-8846(96)00150-0 ↗
13. The behaviour of galvanized steel in chloride-containing alkaline solutions-Ⅰ. The influence of the cation10.1016/0010-938X(90)90046-8 ↗
14. Corrosion of anodically polarized Zn-Al alloys in saturated Ca(OH)2 containing Cl10.1016/0257-8972(86)90049-6 ↗
15. Studies on galvanized carbon steel in Ca(OH)2 solutions
16. Critical chloride corrosion threshold of galvanized reinforcing bars
17. Analysis of the protective efficiency of galvanizing against corrosion of reinforcements embedded in chloride contaminated concrete10.1016/0008-8846(95)00215-4 ↗
18. Corrosion of zinc in simulated carbonated concrete pore solutions10.1016/j.electacta.2007.01.014 ↗
19. Effect of carbonation process on the passivating products of zinc in Ca(OH)2 saturated solution10.1002/maco.201206868 ↗
20. Degradation mechanism of galvanized steel in wet–dry cyclic environment containing chloride ions10.1016/S0010-938X(03)00153-7 ↗
21. Chloride corrosion threshold of reinforcing steel in alkaline solutions – effect of specimen size10.5006/1.3287721 ↗
22. ASTM G31-12a, Standard Guide for Laboratory Immersion Corrosion Testing of Metals, ASTM International, 2012.
23. SEM study of the corrosion products of galvanized reinforcements immersed in solutions in the pH range 12.6 to 13.610.1179/000705984798273524 ↗
24. ASTM G59-14, Standard Test Method for Conducting Potentiodynamic Polarization Resistance Measurements, ASTM International, 2014.
25. Application of electrochemical impedance spectroscopy (EIS) to monitor the corrosion of reinforced concrete: a new approach10.1016/j.conbuildmat.2016.02.047 ↗
26. The effect of simulated concrete pore solution composition and chlorides on the electronic properties of passive films on carbon steel rebar10.1016/j.corsci.2016.01.027 ↗
27. The role of UV illumination on the initial atmospheric corrosion of 09CuPCrNi weathering steel in the presence of NaCl particles10.1016/j.corsci.2014.07.013 ↗
28. Effect of heat treatment on corrosion behavior of AZ63 magnesium alloy in 3.5wt.% sodium chloride solution10.1016/j.corsci.2016.05.019 ↗
29. Mott-Schottky analysis of passive films on Cu containing Fe–20Cr–xCu (x = 0, 4) alloys10.1179/1743278214Y.0000000154 ↗
30. Threshold chloride level and characteristics of reinforcement corrosion initiation in simulated concrete pore solutions10.1016/j.conbuildmat.2011.06.079 ↗
31. Electrochemical investigation of chloride-induced depassivation of black steel rebar under simulated service conditions10.1016/j.corsci.2010.02.016 ↗
32. Properties of the passive film formed on interstitially hardened AISI 316L stainless steel10.1016/j.electacta.2015.06.102 ↗
33. Study of depassivation of carbon steel in simulated concrete pore solution using different equivalent circuits10.1016/j.conbuildmat.2017.09.104 ↗
34. EIS study of potentiostatically formed passive film on 304 stainless steel10.1016/j.electacta.2011.07.072 ↗
35. Effect of time on the characteristics of passive film formed on stainless steel10.1016/j.apsusc.2017.03.155 ↗
36. Experimental and quantum chemical evaluation of 8-hydroxyquinoline as a corrosion inhibitor for copper in 0.1 M HCl10.1021/acs.iecr.6b02414 ↗
37. Electrochemical studies of copper, copper-aluminium and copper-aluminium-silver alloys: impedance results in 0.5 M NaCl10.1016/0013-4686(95)00108-Q ↗
38. Electrochemical and passivation behavior investigation of ferritic stainless steel in alkaline environment10.1016/j.conbuildmat.2015.08.052 ↗
39. The performance of a surface-applied corrosion inhibitor for the carbon steel in saturated Ca(OH)2 solutions10.1016/j.cemconres.2013.10.005 ↗
40. Adsorption and inhibitive properties of some new Mannich bases of Isatin derivatives on corrosion of mild steel in acidic media10.1016/j.corsci.2010.01.015 ↗
41. Electrochemical investigation of passive film in pre-deformation AISI 304 stainless steels10.1016/j.apsusc.2012.08.058 ↗
42. Influence of temperature, chloride ions and chromium element on the electronic property of passive film formed on carbon steel in bicarbonate/carbonate buffer solution10.1016/j.electacta.2007.06.059 ↗
43. Electronic structure and pitting susceptibility of passive film on carbon steel10.1016/S0013-4686(99)00011-0 ↗
44. Effect of tartrate on the electrochemical behaviour and semiconductive properties of passive film on steel in saturated calcium hydroxide10.1002/maco.201408203 ↗
45. Performance variances of galvanized steel in mortar and concrete10.5006/1.3316010 ↗
46. Corrosion behaviour in concrete of three differently galvanized steel bars10.1016/j.cemconcomp.2006.01.011 ↗
47. Corrosion products of galvanized rebars embedded in chloride-contaminated concrete10.5006/1.3280600 ↗
48. Influence of temperature on the service life of rebars10.1016/0008-8846(93)90173-7 ↗