journal article·2016-03

Laboratory performance of warm mix asphalt binder containing polyphosphoric acid

Jun Liu, Kezhen Yan, Lingyun You, Dongdong Ge, Zexing Wang

Publisher page

Abstract

Abstract In this study, the objective was to conduct a laboratory investigation of rheological and morphological properties of warm mix asphalt containing polyphosphoric acid (WMA-PPA). The Superpave binder tests (i.e., rotational viscosity test, dynamic shear rheometer (DSR) test and bending beam rheometer (BBR) test) as well as microscopic tests (i.e., Fluorescence microscopy, Fourier transform infrared spectroscopy (FT-IR) and Differential Scanning Calorimetry and Thermogravimetry (DSC/TG) test) were performed to determine the influences of polyphosphoric acid (PPA) on warm mix asphalt binders. The experimental design included six binders and four different polyphosphoric acid dosages (by weigh of neat asphalt). The test results indicated that, the addition of PPA into warm mix asphalt binders exhibited an increase in the viscosity at different test temperatures, giving clear indication of the modification effects of PPA on the warm mix asphalt binders’ high-temperature performances. Temperature and frequency sweep tests show that the WMA-PPA binders demonstrate lower value of phase angle and higher value of complex modulus compared with the WMA binder regardless of aging state, the WMA-PPA asphalt containing more PPA has higher values of complex modulus (lower values of phase angle) than the WMA-PPA asphalt with less PPA in original state and after RTFO aging state. Bending beam rheometer (BBR) test illustrates that the addition of PPA making the low temperature rheological properties of the WMA binder worse. Furthermore, the amount of PPA has a great effect on the microstructures and hot storage stability of WMA-PPA asphalts, and the modification effect of PPA on WMA asphalt is a chemistry process. The 1.5% of PPA was found to be the optimum content between the studied percentages due to the warm mix asphalt binder containing 1.5% PPA achieved comparative good intermediate and high temperature rheological properties and at the same time is considered economical.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Asphalt Pavement Performance Evaluation · Infrastructure Maintenance and Monitoring · Petroleum Processing and Analysis

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (34)

Show source-provided references
1. B.G. Koenders, D.A. Stoker, C. Bowen, P.C. de Groot, O. Larsen, D. Hardy et al., Innovative process in asphalt production and application to obtain lower operating temperatures, in: Proceedings of the Second Eurasphalt & Eurobitume Congress Book II, Spain, Barcelona, 2000.
2. FHWA. Warm mix asphalt: European practice. Report of WMA European practice. Federal Highway Administration, Washington, DC, United States, 2008. p. 19–24.
3. The role of a surfactant based additive on the production of recycled warm mix asphalts – less is more10.1016/j.conbuildmat.2012.04.141 ↗
4. W. Jones, Warm mix asphalt – A STATE-OF-THE-ART Review, Australian Asphalt Pavement Association Advisory Note 17, KEW Victoria, Australia, 2004.
5. B.D. Prowell, G.C. Hurley, E. Crews, Field performance of warm-mix asphalt at the NCAT test track, in: Proceeding of Transportation Research Board 86th Annual Meeting, Washington, DC, United States, 2007.
6. Ó. Kristjánsdóttir, S. Muench, L. Michael, G. Burke, Assessing the potential for warm mix asphalt technology adoption, in: Proceeding of Transportation Research Board 86th Annual Meeting, Washington, DC, United States, 2007.10.3141/2040-10 ↗
7. M.R. Barreto, L. Grampe, J.A. Gonzalez, Warm asphalt mixtures by chemical additivation: field and laboratory studies, in: Proceedings of the 4th Eurasphalt & Eurobitume Congress. Copenhagen, Denmark, 2008.
8. M.B.C. Borleo, K. Kanitpong, N. Charoentham, Performance evaluation of warm mix asphalt produced with Sasobit additive, in: Proceeding of International Conference on Road and Airfield Pavement Technology. Sapporo, Japan, 2008.
9. Y. Hachiya, K. Su, I. Motono, T. Muranaga, A. Kajitani, T. Kano, Implementing overnight asphalt inlay works for rehabilitating full length working runway. In: Proceedings of the 4th Eurasphalt & Eurobitume Congress. Denmark, Copenhagen, 2008.
10. Selection of type of warm mix asphalt additive based on the rheological properties of asphalt binders10.1016/j.jclepro.2015.03.036 ↗
11. Laboratory performance of warm mix asphalt containing recycled asphalt mixtures10.1016/j.conbuildmat.2014.04.002 ↗
12. Fatigue behavior of rubberized asphalt concrete mixtures containing warm asphalt additives10.1016/j.conbuildmat.2009.06.036 ↗
13. Rheology evaluations of wma binders using ultraviolet and pav aging procedures10.1016/j.conbuildmat.2015.01.046 ↗
14. Characterization of rutting performance of warm additive modified asphalt mixtures10.1016/j.conbuildmat.2011.12.101 ↗
15. M. Zaumanis, V. Haritonovs, Research on properties of Warm Mix Asphalt, in: Scientific proceedings of Riga Technical University, Series 2: Architecture and Construction Science, 11(77), 2010.
16. G. Hurley, B. Prowell, Evaluation of Evotherm for use in warm mix asphalt. NCAT Report 06–02, Auburn, 2006.
17. Warm mix asphalt: an overview10.1016/j.jclepro.2011.11.053 ↗
18. Polyphosphoric acid modified asphalt: proposed mechanisms
19. Brief review of the chemistry of polyphosphoric acid (PPA) and bitumen10.1021/ef800120x ↗
20. FTIR study of the reaction of polyphospheric acid and model bitumen sulfur compounds10.1021/ef800582j ↗
21. Ionic pairs in polyphosphoric acid (PPA) modified bitumen: insights from model compounds10.1021/ef8002526 ↗
22. Reactions of polyphosphoric acid and bitumen model compounds with oxygenated functional groups: where is the phosphorylation?10.1021/ef800511v ↗
23. Rheological property investigations for polymer and polyphosphoric acid modified asphalt binders at high temperatures10.1016/j.conbuildmat.2014.04.082 ↗
24. Rheological effects of commercial waxes and polyphosphoric acid in bitumen 160/220–low temperature performance10.1016/j.fuel.2005.09.014 ↗
25. Rheological effects of commercial waxes and polyphosphoric acid in bitumen 160/220–high and medium temperature performance10.1016/j.conbuildmat.2006.07.012 ↗
26. Shifting the bitumen structure from sol to gel10.1016/S0920-4105(98)00052-7 ↗
27. C. Chin, J. Oliver, Polyphosphoric acid modified binders. Austroads Technical Report, Austroads Publication No. AP-T87/07, Austroads Inc., Sydney, Australia, 2007.
28. Macrostructure and rheological properties of chemically modified residues and bitumens10.1021/ef9902045 ↗
29. Ministry of Transport of the People’s Republic of China. Technical Specification for Construction of Highway Asphalt Pavement JTG F40–2004. Beijing: China Communication Press, 2004.
30. Determining mixing and compaction temperatures of evotherm® warm mix asphalt using 100% reclaimed asphalt pavement
31. The Asphalt Institute. Performance graded asphalt binder specification and testing, SP-1. The Asphalt Institute, Lexington, [KY2003].
32. Effects of non-foaming WMA additives on asphalt binders at high performance temperatures10.1016/j.fuel.2011.09.017 ↗
33. Experimental investigation on related properties of asphalt mastic containing recycled red brick powder10.1016/j.conbuildmat.2010.12.040 ↗
34. Study of the modification of coal-tar pitch with p-methyl benzaldehyde10.1016/j.fuel.2004.08.013 ↗