journal article·2017-07

Effect of air entrainment on the performance of reactive MgO and PC mixes

S. Ruan, C. Unluer

Publisher page

Abstract

This study investigated the influence of air-entraining agents (AEA) on the performance and microstructure of reactive MgO cement (RMC) samples in comparison with Portland cement (PC) samples under different water contents and curing conditions. Porosity, density, workability, strength, pH and thermal conductivity measurements were supported with XRD, TGA/DSC and SEM analyses. Performance of RMC samples depended on the dense formation of carbonate phases such as nesquehonite and hydromagnesite, whereas PC samples gained strength by hydration. Introduction of AEA reduced early strength due to increased air contents. This was compensated by increased CO2 penetration, carbonation and strength gain in longer periods.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Concrete and Cement Materials Research · Magnesium Oxide Properties and Applications · Advanced ceramic materials synthesis

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (68)

Show source-provided references
1. Portal · 2016
2. Global strategies and potentials to curb CO2 emissions in cement industry10.1016/j.jclepro.2012.10.049 ↗
3. Carbon dioxide equivalent (CO2-e) emissions: a comparison between geopolymer and OPC cement concrete10.1016/j.conbuildmat.2013.01.023 ↗
4. Environmental impact and life cycle assessment (LCA) of traditional and ‘green’concretes: literature review and theoretical calculations10.1016/j.cemconcomp.2012.01.004 ↗
5. Comparative life cycle assessment of reactive MgO and Portland cement production10.1016/j.jclepro.2016.07.071 ↗
6. Shand · 2006
7. Enhancing the carbonation of MgO cement porous blocks through improved curing conditions10.1016/j.cemconres.2014.02.005 ↗
8. CO2 disposal by means of silicates10.1038/345486b0 ↗
9. Zur Erhärtung von Weißkalkmörteln
10. Accelerated curing of cementitious systems by carbon dioxide: part I. Portland cement10.1016/0008-8846(72)90111-1 ↗
11. Hydration and mechanical properties of magnesia, pulverized fuel ash, and portland cement blends10.1061/(ASCE)0899-1561(2008)20:5(375) ↗
12. Impact of hydrated magnesium carbonate additives on the carbonation of reactive MgO cements10.1016/j.cemconres.2013.08.009 ↗
13. Characterization of light and heavy hydrated magnesium carbonates using thermal analysis10.1007/s10973-013-3300-3 ↗
14. Influence of carbonation on the properties of reactive magnesia cement-based pressed masonry units10.1680/adcr.2008.20.2.53 ↗
15. Accelerated carbonation of reactive MgO cements10.1680/adcr.2007.19.2.67 ↗
16. Properties of binary and ternary reactive MgO mortar blends subjected to CO2 curing10.1016/j.cemconcomp.2013.03.009 ↗
17. Effects of accelerated carbonation on the microstructure of Portland cement pastes containing reactive MgO10.1016/j.cemconres.2012.02.017 ↗
18. A.J.W. Harrison, Reactive magnesium oxide cements, Google Patents, 2008.
19. Accelerated carbonation–a potential approach to sequester CO2 in cement paste containing slag and reactive MgO10.1016/j.cemconcomp.2013.07.001 ↗
20. Improving the performance of reactive MgO cement-based concrete mixes10.1016/j.conbuildmat.2016.09.090 ↗
21. Investigation of carbonation depth and its influence on the performance and microstructure of MgO cement and PC mixes10.1016/j.conbuildmat.2016.05.067 ↗
22. Microstructures of reactive magnesia cement blends10.1016/j.cemconcomp.2008.05.002 ↗
23. Effects of reactive magnesia on microstructure and frost durability of portland cement–based binders10.1061/(ASCE)MT.1943-5533.0000768 ↗
24. Performance of magnesia cements in porous blocks in acid and magnesium environments10.1680/adcr.11.00011 ↗
25. Performance of magnesia cements in pressed masonry units with natural aggregates: production parameters optimisation10.1016/j.conbuildmat.2007.05.007 ↗
26. The role of brucite, ground granulated blastfurnace slag, and magnesium silicates in the carbonation and performance of MgO cements10.1016/j.conbuildmat.2015.07.105 ↗
27. Effectiveness of using CO2 pressure to enhance the carbonation of Portland cement-fly ash-MgO mortars10.1016/j.cemconcomp.2016.03.013 ↗
28. Precipitation in the Mg-carbonate system—effects of temperature and CO2 pressure10.1016/j.ces.2007.09.052 ↗
29. The influence of relative humidity on structural and chemical changes during carbonation of hydraulic lime10.1016/j.cemconres.2007.05.002 ↗
30. Chemical changes and phase analysis of OPC pastes carbonated at different CO2 concentrations10.1617/s11527-008-9399-1 ↗
31. Development of low-carbon cementitious materials via carbonating Portland cement–fly ash–magnesia blends under various curing scenarios: a comparative study
32. Johnson · 2000
33. Mechanisms of air entrainment in concrete10.1016/j.cemconres.2004.07.026 ↗
34. Neville · 1995
35. Lamond · 2006
36. Pigeon · 2010
37. Workability, and mechanical, acoustic and thermal properties of lightweight aggregate concrete with a high volume of entrained air10.1016/j.conbuildmat.2011.08.067 ↗
38. Effect of expanded perlite on the mechanical properties and thermal conductivity of lightweight concrete10.1016/j.enbuild.2010.11.008 ↗
39. Relationships between the British Standard tests for workability and the two-point test10.1680/macr.1976.28.96.143 ↗
40. Effect of entrained air voids on the microstructure and mass transport properties of concrete10.1016/j.cemconres.2011.06.013 ↗
41. Forced and natural carbonation of lime-based mortars with and without additives: mineralogical and textural changes10.1016/j.cemconres.2004.12.012 ↗
42. BS, EN 196-3 · 2016
43. Air void morphology in fresh cement pastes10.1016/S0008-8846(01)00751-7 ↗
44. The morphology of entrained air voids in hardened cement paste generated with different anionic surfactants10.1016/j.cemconcomp.2008.02.003 ↗
45. Evaluation of natural zeolite as a viscosity-modifying agent for cement-based grouts10.1016/j.cemconres.2008.03.007 ↗
46. The influence of mineral admixtures on the rheology of cement paste and concrete10.1016/S0008-8846(00)00454-3 ↗
47. P.-C. Aı̈tcin, Importance of adequate soluble alkali content to ensure cement/superplasticizer compatibility10.1016/S0008-8846(98)00179-3 ↗
48. Rheological properties of aerated cement pastes with fly ash, metakaolin and sepiolite additions10.1016/j.conbuildmat.2014.05.034 ↗
49. Standard test Method for Density, Absorption, and Voids in Hardened Concrete
50. ASTM, C109-16A · 2016
51. Standard test methods for chemical analysis of limestone, quicklime and hydrated lime, ASTM Standard C25-06, ASTM international, West Conshohocken, PA, vol. 10, 2006.
52. A fundamental parameters approach to X-ray line-profile fitting10.1107/S0021889891010804 ↗
53. Modelling of the microstructure and transport properties of concrete10.1016/0950-0618(94)00019-0 ↗
54. Influence of porosity and water content on the diffusivity of CO2 and O2 through hydrated cement paste10.1016/0008-8846(94)90040-X ↗
55. Microstructure of cement paste subject to early carbonation curing10.1016/j.cemconres.2011.09.010 ↗
56. Influence of air entraining agents on deicing salt scaling resistance and transport properties of high-volume fly ash concrete10.1016/j.cemconcomp.2013.01.005 ↗
57. Leaching of inorganic contaminants from cement-based waste materials as a result of carbonation during intermittent wetting10.1016/S0956-053X(01)00076-9 ↗
58. Microstructural changes caused by carbonation of cement mortar10.1016/S0008-8846(01)00498-7 ↗
59. Liska · 2010
60. Solubility of calcium hydroxide10.1021/j150296a010 ↗
61. Solubility of magnesium oxide in calcium oxide-calcium chloride mixtures10.1007/BF02654919 ↗
62. Controlled rate thermal analysis of hydromagnesite10.1007/s10973-007-8845-6 ↗
63. The thermal decomposition of huntite and hydromagnesite—a review10.1016/j.tca.2010.06.012 ↗
64. On the thermal decomposition of nesquehonite10.1007/s10973-015-4756-0 ↗
65. Thermal stability of artinite, dypingite and brugnatellite—Implications for the geosequestration of green house gases10.1016/j.tca.2008.06.007 ↗
66. Synthesis of magnesium oxide hierarchical microspheres: a dual-functional material for water remediation10.1021/acsami.5b05553 ↗
67. Carbonates binders: reaction kinetics, strength and microstructure10.1016/j.cemconcomp.2006.03.004 ↗
68. Evaluation of thermal conductivity in air permeable concrete for dynamic breathing wall construction10.1016/j.cemconcomp.2007.04.008 ↗