Coupled effect of ambient high relative humidity and varying temperature marine environment on corrosion of reinforced concrete
Source abstract
Abstract
Abstract Chloride induced corrosion under coupled environmental effects of high humidity and high temperature often found in gulf marine environment is a very serious threat for durability of reinforced concrete structures. There exist different schools of thought between various researchers and the data in high relative humidity and high temperature range is also limited. This has been investigated by laboratory controlled experimentation under three different temperature conditions (30, 40 and 50 °C) and 85% R.H. A non-uniform and non-linear corrosion reaction was observed even after the breaking of passive layer. Furthermore, a decrease in corrosion potential and corrosion mass loss at 50 °C in comparison to 40 °C temperature conditions was seen. This may be due to the reduction of oxygen solubility in the pore solution at high temperature and blockage of concrete pores at high relative humidity. Thus, producing a reversing trend in corrosion mass loss as a function of chloride concentration at high temperature condition of 50 °C and high relative humidity of 85%. It is expected that a stable oxide layer may have developed under limiting oxygen controlled corrosion reaction. This can form basis for the development of a new technique to passivate steel bar embedded in chloride contaminated concrete. The paper also presents qualitative analysis of the microstructure of corrosion products under coupled varying temperature-chloride conditions and identifies the dividing line and turning point chloride concentration.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Concrete Corrosion and Durability · Concrete and Cement Materials Research · Corrosion Behavior and Inhibition
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (21)
Show source-provided references
1. Influence of connectivity of concrete pores and associated diffusion of oxygen on corrosion of steel under high humidity10.1016/j.conbuildmat.2009.11.017 ↗
2. Development of numerical model for FEM computation of oxygen transport through porous media coupled with micro-cell corrosion model of steel in concrete structures10.1016/j.compstruc.2010.02.008 ↗
3. Experimental investigation of time dependent non linear 3D relationship between critical carbonation depth and corrosion of steel in carbonated concrete
4. Investigation of volumetric effect of coarse aggregate on corroding steel reinforcement at the interfacial transition zone of concrete10.1007/s12205-011-1035-x ↗
5. Enhanced electro-chemical corrosion model for reinforced concrete under severe coupled environmental action of chloride and temperature10.1016/j.conbuildmat.2010.09.014 ↗
6. Enhanced classical tafel diagram model for corrosion of steel in chloride contaminated concrete and the non linear experimental effect of temperature10.4334/IJCSM.2010.4.2.71 ↗
7. Novel approach towards calculation of averaged activation energy based on arrhenius plot for modeling of the effect of temperature on chloride induced corrosion of steel in concrete10.1520/JAI102667 ↗
8. Effect of moisture variation on oxygen consumption rate of corroding steel in chloride contaminated concrete10.1016/j.cemconcomp.2010.09.014 ↗
9. Induced macro-cell corrosion phenomenon in the simulated repaired reinforced concrete patch10.1080/14488353.2010.11463957 ↗
10. Underwater half-cell corrosion potential bench mark measurements of corroding steel in concrete influenced by a variety of material science and environmental engineering variables10.1016/j.measurement.2010.10.002 ↗
11. Enhanced mass balance electrochemical computational model for corrosion rate of steel coupled with CO2 transport model in extremely carbonated concrete10.12989/cac.2011.8.2.177 ↗
12. Carbonation-induced reinforcement corrosion in silica fume concrete10.1016/j.conbuildmat.2008.08.005 ↗
13. Performance of generic and proprietary corrosion inhibitors in chloride-contaminated silica fume cement concrete10.1016/j.conbuildmat.2008.10.010 ↗
14. Significance of the ambient temperature and the steel material in the process of concrete reinforcement corrosion10.1016/S0950-0618(97)00001-9 ↗
15. Influence of atmospheric corrosion on the mechanical properties of reinforcing steel10.1016/0950-0618(94)90006-X ↗
16. Oh Byung Hwan, Jang Bong Seok, Lee Seong Cheol. Chloride diffusion and corrosion initiation time of reinforced concrete structures. In: Proceedings of the international workshop on microstructure and durability, Sapporo, Japan; February 2004.
17. Uomoto · 2000
18. ASTM C 876-91. Standard test method for half-cell potentials of uncoated reinforcing steel in concrete, ASTM, USA; 1999.
19. ASTM G1-03. Standard test practice for preparing, cleaning and evaluating corrosion test specimens, ASTM, USA; 2002.
20. Quantitative characterization of steel/cement paste interface microstructure and corrosion phenomena in mortars suffering from chloride attack10.1016/j.corsci.2006.03.003 ↗
21. Koleva DA, Hu J, Fraaij ALA, Boshkov N. Influences of chloride ions on plain and reinforced mortars, investigated by combined microstructure and electrochemical approaches, Paper 315, Eurocorr 2005, 4–8 September 2005, Lisbon, Portugal.