Effect of calcium sulfate type and dosage on properties of calcium aluminate cement-based self-leveling mortar
Source abstract
Abstract
Abstract In this paper, the influence of calcium sulfate type (α-hemihydrate, anhydrite and dihydrate) and amount (0%, 2%, 4% and 6%) on the performances of calcium aluminate cement-based self-leveling mortar (SLM) were investigated. The influence of calcium sulfate on fluidity and mechanical properties was investigated. Moreover, the impact of calcium sulfate on the hydration products, morphology and heat evolution of pastes hydrated up to 3 days were determined by using X-ray diffraction (XRD), Scanning electron microscope (SEM) and isothermal heat-conduction calorimeter. Test results revealed that SLM prepared with anhydrite exhibited the highest initial flow value (∼160 mm) and setting time and the lowest fluidity loss due to the slow dissolution rate of anhydrite compared to other calcium sulfate. In comparison to control formulation, the enhancement in flexural and compressive strength for T4 (dihydrate) was the highest and was found to be 485.71% and 437.5% respectively and hence it can be concluded that dihydrate is favorable to the early strength of SLM as compared to other SLM formulations containing α-hemihydrate and anhydrite respectively. The shrinkage compensating effect became more obvious with the increase in the amount of C$ in SLM samples. Due to the fast dissolution rate, mortar containing α-hemihydrate exhibited more expansion as compared to other calcium sulfate. SLM prepared with dihydrate showed the highest early strength due to the lowest influence on C3S hydration while the influence of α-hemihydrate was more obvious. Hence, the hydration of PC in the ternary system can be limited by increasing calcium sulfate due to the formation of ettringite. Finally, the type of calcium sulfate has an important influence on the quantity and morphology of ettringite.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Concrete and Cement Materials Research · Concrete Properties and Behavior · Innovative concrete reinforcement materials
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (20)
Show source-provided references
1. Development of self-leveling screed based on calcium sulfoaluminate cement: modelling of curling due to drying10.1016/j.cemconcomp.2008.06.004 ↗
2. Investigation into relations among technological properties, hydration kinetics and early age hydration of self-leveling underlayments10.1016/j.cemconres.2010.03.004 ↗
3. Quantitative distribution patterns of additives in self-leveling flooring compounds (underlayments) as function of application, formulation and climatic conditions10.1016/j.cemconres.2008.12.009 ↗
4. Utilization of original phosphogypsum as raw material for the preparation of self-leveling mortar10.1016/j.jclepro.2016.04.054 ↗
5. Early strength development and hydration of ordinary portland cement/calcium aluminate cement pastes10.1016/S1065-7355(97)00008-4 ↗
6. Conduction calorimetric studies of ternary binders based on Portland cement, calcium aluminate cement and calcium sulphate10.1007/s10973-013-3003-9 ↗
7. Expansive properties of ettringite in a mixture of calcium aluminate cement, Portland cement and β-calcium sulfate hemihydrate10.1016/S0008-8846(00)00495-6 ↗
8. The kinetics of ettringite formation and dilatation in a blended cement with β-hemihydrate and anhydrite as calcium sulfate10.1016/j.cemconres.2004.09.012 ↗
9. Effect of gypsum type on properties of cementitious materials containing high range water reducing admixture10.1016/j.cemconcomp.2016.02.007 ↗
10. Effect of sulfate content on cement mixtures10.1016/j.conbuildmat.2013.05.106 ↗
11. Formation of ettringite in Portland cement/calcium aluminate cement/calcium sulfate ternary system hydrates at lower temperatures10.1016/j.conbuildmat.2011.12.078 ↗
12. Influence of tartaric acid on early hydration and mortar performance of Portland cement-calcium aluminate cement-anhydrite binder10.1016/j.conbuildmat.2016.02.214 ↗
13. Influence of curing temperatures on the hydration of calcium aluminate cement/Portland cement/calcium sulfate blends10.1016/j.cemconcomp.2017.03.016 ↗
14. Effects of lactic and citric acid on early-age engineering properties of Portland/calcium aluminate blended cements10.1016/j.conbuildmat.2015.10.054 ↗
15. Limestone reaction in calcium aluminate cement-calcium sulfate systems10.1016/j.cemconres.2015.05.019 ↗
16. Influence of the type of calcium sulfate on the strength and hydration of Portland cement under an initial steam-curing condition10.1016/0008-8846(96)00149-4 ↗
17. Mechanisms and parameters controlling the tricalcium aluminate reactivity in the presence of gypsum10.1016/j.cemconres.2007.06.001 ↗
18. Research on effect of limestone and gypsum on C3A, C3S and PC clinker system10.1016/j.conbuildmat.2007.06.013 ↗
19. Effects of superplasticizers on the stability and morphology of ettringite10.1016/j.conbuildmat.2016.02.198 ↗
20. Metha · 2006