journal article·2013-10

An experimental study on the within-member variability of in situ concrete strength in RC building structures

A. Masi, L. Chiauzzi

Publisher page

Abstract

Abstract Reinforced Concrete (RC) buildings can require the determination of in situ concrete strength during the execution of new structures to investigate low-strength results from acceptance tests and, especially, in the capacity assessment of existing structures. Most structural codes and technical recommendations indicate that in situ concrete strength should be estimated by means of drilled cores (Destructive Test, DT), possibly supplemented by non-destructive tests (NDTs). Besides contributing to the identification of homogenous concrete areas and thus indicating locations where cores have to be extracted, NDTs can significantly reduce the total amount of cores needed to adequately estimate concrete strength in an entire structure. The paper firstly reports a brief review of the most usual NDT methods (rebound number and ultrasonic pulse) and DT methods (cores) and discusses the role of the main factors influencing in situ strength estimation. It then reports and analyses the results of a wide investigation carried out on an RC beam member extracted from an existing structure. The results show a low variability of rebound number and direct velocity values along the beam, and a high variability for surface velocity values and, especially, core strengths. The wide scatter in some test results has been seen in relationship to the micro-cracking condition arising from past applied loads. Suggestions for test location and interpretation of in situ and laboratory test results are provided.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Structural Health Monitoring Techniques · Ultrasonics and Acoustic Wave Propagation · Non-Destructive Testing Techniques

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (30)

Show source-provided references
1. Masi A, Vona M. Estimation of the in situ concrete strength: provisions of the European and Italian seismic codes and possible improvements. In: Cosenza E, editor. Proc. of the eurocode 8 perspectives from the Italian Standpoint workshop. Naples; April 1-3 2009.p. 67–7 .
2. Augenti N, Cosenza E, Dolce M, Manfredi G, Masi A, Samela L. Performance of school buildings during the 2002 Molise, Italy, Earthquake, Earthquake Spectra 2004, Special Issue on the Molise 2002 earthquake, 20(S1):S257–S270.10.1193/1.1769374 ↗
3. Ordinanza del Presidente del Consiglio dei Ministri (OPCM). General criteria for the seismic classification of the national territory and technical standards for constructing in seismic zones. Ordinance no. 3274, G.U. n. 72 del 8–5-2003 (in Italian).
4. The effect of material and ground motion uncertainty on the seismic vulnerability curves of RC structure10.1016/j.engstruct.2005.07.010 ↗
5. Vulnerability assessment of gravity-load designed RC buildings: evaluation of seismic capacity through non-linear dynamic analyses10.1016/j.engstruct.2012.06.043 ↗
6. Comité Européen de Normalisation (CEN). Eurocode 8 – Design of structures for earthquake resistance – Part 3: assessment and retrofitting of buildings (draft n. 6), prEN 1998–3, Brussels; 2004.
7. Federal Emergency Management Agency (FEMA). FEMA 356 – prestandard and commentary for the seismic rehabilitation of buildings, Washington (DC); November 2000.
8. New Zealand Society for Earthquake Engineering (NZSEE). Assessment and improvement of the structural performance of buildings in earthquakes, recommendations of a NZSEE study group on earthquake risk, buildings; June 2006.
9. Masi A, Nigro D, Vona M. Effect of core drilling and subsequent restoration on RC column strength. In:Proc. of 15th world conference on earthquake engineering, Lisboa; September 2012.
10. Masi A. The estimation of in situ concrete strength through destructive and non-destructive tests, Il Giornale delle Prove non Distruttive Monitoraggio Diagnostica, n. 1; 2005 (in Italian).
11. Non-destructive evaluation of concrete strength: An historical review and a new perspective by combining NDT methods10.1016/j.conbuildmat.2011.12.103 ↗
12. American Concrete Institute (ACI). Guide for obtaining cores and interpreting compressive strength results, ACI 214.4R-10, Detroit; June 2010.
13. EN 12504-1. Testing concrete in structures – cored specimens – taking, examining and testing in compression; March 2000.
14. Equivalent specified concrete strength from core test data
15. EN 13791. Assessment of in situ compressive strength in structures and precast concrete components. European Standard ICS 91.080.40; January 2007.
16. Concrete Society. Concrete core testing for strength, Technical Report 11 (TR 11); 1976.
17. Collepardi M. The new concrete, second edition, Edizioni Tintoretto; 2002 (in Italian).
18. UNI 10834. Shotcrete; October 1999 (in Italian).
19. Dolce M, Masi A, Ferrini M. Estimation of the actual in-place concrete strength in assessing existing RC structures. In: Proc. of the Second international fib congress, Naples, Italy; June 5–8, 2006.
20. American Concrete Institute (ACI). Non-destructive test methods for evaluation of concrete in structures, ACI 228.2R-98, Detroit ;1998.
21. EN 12504-2. Testing concrete in structures – non-destructive testing – determination of rebound number; June 2001.
22. Surface hardness methods
23. C.E.B. Diagnosis and assessment of concrete structures – state of art report, Bulletin d’Information, n. 192; 1989.
24. EN 12504-4. Testing concrete – Part 4: determination of ultrasonic pulse velocity; August 2004.
25. Naik TR, Malhotra VM, Popovics JS. The ultrasonic pulse velocity Method. In: Malhotra VM, Carino NJ. Handbook on nondestructive testing of concrete, second edition: CRC Press; 2004.10.1201/9781420040050 ↗
26. Comité Européen de Normalisation (CEN). Eurocode 2: Design of concrete structures – Part 1-1: General rules and rules for buildings, prEN 1992–1-1, Brussels; December 2003.
27. Samarin A. Combined Methods. In: Malhotra VM, Carino NJ. Handbook on Nondestructive Testing of Concrete, Second Edition, CRC Press ; 2004.10.1201/9781420040050.ch9 ↗
28. RILEM NDT 4. Recommendations for in situ concrete strength determination by combined non-destructive methods, Compendium of RILEM Technical Recommendations, E&FN Spon, London; 1993.
29. Regio Decreto 16/11/1939 n. 2229. Regulations for the execution of concrete structures; 1939 (in Italian).
30. Braga F, Dolce M, Masi A, Nigro D. The evaluation of mechanical properties of poor quality concrete through non-destructive testing, L’Industria Italiana del Cemento; March 1992 (in Italian).