journal article·2014-08

Long-term behaviour of concrete produced with recycled lightweight expanded clay aggregate concrete

J. Alexandre Bogas, J. de Brito, J. Cabaço

Publisher page

Abstract

Abstract In this paper some of the main long-term properties of concrete produced with recycled aggregates obtained from crushing both structural and non-structural lightweight concrete (LWC) are analysed. The properties studied are drying shrinkage, capillary and immersion absorption, and carbonation and chloride penetration resistance. A comprehensive experimental study was carried out on a series of concrete mixes in which ratios of 20%, 50% and 100% of two types of coarse lightweight aggregates (LWA) were replaced with two types of recycled lightweight concrete aggregates (RLCA). Long-term shrinkage is affected by the paste adhered to LWA and increases as the replacement ratio of LWA with RLCA goes up. However, the internal curing promoted by RLCA reduces the early shrinkage. In terms of durability, the experimental results show that generally all the properties studied decay due to the progressive replacement of structural LWA with RLCA. However, despite the general reduction of long-term properties, recycled lightweight concrete (RLWC) can be also durable, regardless of the type of RLCA. Moreover, it is shown that even for low to moderate strength RLWC the mechanism of carbonation is not a determinant factor for durability. On the other hand, the carbonation and chloride penetration resistance of concrete with non-structural LWA tends to improve with the incorporation of RLCA. It can thus be concluded that RLWC may be a viable and more cost-effective alternative solution, especially given its higher structural efficiency. In addition, RLCA obtained from non-structural LWC can be incorporated in concrete without significantly compromising its durability.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Recycled Aggregate Concrete Performance · Innovative concrete reinforcement materials · Asphalt Pavement Performance Evaluation

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (52)

Show source-provided references
1. The greening of the concrete industry10.1016/j.cemconcomp.2008.12.010 ↗
2. Influence of the amount of recycled coarse aggregate in concrete design and durability properties10.1016/j.conbuildmat.2011.06.059 ↗
3. Compressive behaviour and failure modes of structural lightweight aggregate concrete – characterization and strength prediction10.1016/j.matdes.2012.11.004 ↗
4. Chandra · 2003
5. Holm TA, Bremner TW. State-of-the-art report on high-strength, high-durability structural low-density concrete for applications in severe marine environments. Us Army Corps of Engineers. Structural Laboratory, ERDC/SL TR-00-3, 2000.
6. Properties of structural lightweight aggregate concrete
7. Hansen · 1992
8. Influence of recycled concrete aggregates on strength properties of concrete10.1016/j.conbuildmat.2008.06.007 ↗
9. Mechanical and durability properties of concretes containing recycled lime powder and recycled aggregates10.1016/j.conbuildmat.2013.11.102 ↗
10. Mechanical behaviour of concrete made with fine recycled concrete aggregates10.1016/j.cemconcomp.2006.12.004 ↗
11. Mechanical behaviour of non-structural concrete made with recycled ceramic aggregates10.1016/j.cemconcomp.2004.07.005 ↗
12. Bazuco RS. The use of recycled concrete aggregates for the production of new concrete. MSc thesis in civil engineering. Federal University of Santa Catarina, Florianópolis, Brazil; 1999 [in Portuguese].
13. Application of recycled concrete aggregate concrete for structural concrete. Part 1 – Experimental study on the quality of recycled aggregate and recycled aggregate concrete
14. Levy S. Recycling of construction debris for use as aggregate for mortars and concrete. MSc dissertation in Civil Engineering. Polytechnic University of São Paulo, São Paulo, Brazil; 2001 [in Portuguese].
15. Hansen T, Marga M. Strength of concrete made from coarse and fine recycled concrete aggregates. In: Second symposium on demolition and reuse of concrete and masonry, Prentice Hall, Tokyo, Japan, vol. 2; 1998. p. 605–12.10.1201/9781003416562-13 ↗
16. Properties of concrete incorporating fine recycled aggregate10.1016/j.cemconres.2004.06.017 ↗
17. Mechanical properties of concrete with recycled coarse aggregate10.1016/j.buildenv.2005.07.033 ↗
18. Modeling of mechanical properties and durability of recycled aggregate concretes10.1016/j.conbuildmat.2011.06.043 ↗
19. Drying shrinkage behavior of recycled aggregate concrete
20. Recycled aggregate concrete (RAC) – methodology for estimating its long-term properties
21. Buttler A. Concrete with recycled coarse aggregate concrete – influence of the recycling age on the properties of recycled aggregate and recycled concrete. MSc thesis in Civil Engineering, Engineering School of São Carlos, University of São Paulo, Brazil; 2003 [in Portuguese].
22. Elasticity and drying shrinkage of recycled aggregate concretes
23. Concrete made with coarse concrete aggregate: influence of curing on durability
24. Levy S. Recycling of construction debris for use as aggregate for mortar and concrete. MSc thesis in Civil Engineering, Polytechnic of the University of São Paulo, Brazil; 2001 [in Portuguese].
25. Design requirements
26. ACI Committee 213. Guide for structural lightweight-aggregate concrete. American Concrete Institute, Farmington Hills; 2003.
27. EuroLightConR26. Recycling lightweight aggregate concrete. European Union – Brite EuRam III, BE96-3942/R26; 2000.
28. Experimental study of recycling lightweight concrete with aggregates containing expanded glass10.1016/j.psep.2009.03.003 ↗
29. Some tests on creep and shrinkage of recycled lightweight concrete
30. Figueiredo JM. Mechanical performance of concrete with recycle lightweight aggregate from crushed lightweight concrete. Lisbon: Msc thesis in civil engineering, Technical University of Lisbon, Instituto Superior Técnico; 2013.
31. Microstructural analysis of Iberian expanded clay aggregates10.1017/S1431927612000487 ↗
32. Estimation of water absorbed by expanding clay aggregates during structural lightweight concrete production10.1617/s11527-012-9857-7 ↗
33. EN 12390-3. Testing hardened concrete. Compressive strength of test specimens. CEN: Brussels; 2009.
34. LNEC E391. Determination of the carbonation resistance. National Laboratory for Civil Engineering (LNEC): Lisbon (Portugal); 1993 [in Portuguese].
35. NTbuild492. Concrete, mortar and cement based repair materials: chloride migration coefficient from non-steady state migration experiments. Nordtest 492, Finland; 1999.
36. LNEC E393. Determination of the water absorption by capillarity. National Laboratory for Civil Engineering (LNEC): Lisbon (Portugal); 1993 [in Portuguese].
37. TC116-PCD. Rilem TC 116-PCD: permeability of concrete as a criterion of its durability. Recomendations. Tests for gas permeability of concrete, determination of the capillary absortion of water of hardened concrete. Mater Struct 1999; 32: 174–9.10.1007/BF02481510 ↗
38. LNEC E394. Determination of the water absorption by immersion. National Laboratory for Civil Engineering (LNEC): Lisbon (Portugal); 1993 [in Portuguese].
39. LNEC E398. Determination of shrinkage and expansion. National Laboratory for Civil Engineering (LNEC): Lisbon (Portugal); 1993 [in Portuguese].
40. Wierig HJ. Longtime studies on the carbonation of concrete under normal outdoor exposure. In: RILEM seminar durability of concrete structures under normal outdoor exposure, Hannover; 1984. p. 239–49.
41. Kropp J. Relations between transport characteristics and durability. In: state of the art report by Rilem technical committee TC 116-PCD, performance of concrete as a criterion of its durability. E&FN Spon; 1995. p. 97–137.
42. fib 1. Structural concrete-textbook on behavior, design and performance. Updated knowlwdge of the CEB/FIP model code 1990, vol. 1. Introduction – design process – materials. Manual textbook; 1999. 244p.
43. Carbonation of concrete and its prediction10.1016/0008-8846(87)90012-3 ↗
44. EN 206-1. Concrete – Part 1: Specification performance, production and conformity; 2013.
45. Shrinkage of high-strength lightweight aggregate concrete exposed to dry environment
46. Influence of mineral additions and different compositional parameters on the shrinkage of structural expanded clay lightweight concrete10.1016/j.matdes.2013.12.013 ↗
47. Influence of the pre-saturation of recycled coarse concrete aggregates on concrete properties10.1680/macr.2011.63.8.617 ↗
48. Bogas JA. Characterization of structural lightweight expanded clay aggregate concrete. Lisbon: PhD thesis in civil engineering, Technical University of Lisbon, Instituto Superior Técnico; 2011.
49. Analytical modeling of capillary flow in tubes of nonuniform cross section10.1016/j.jcis.2009.01.038 ↗
50. Water absorption, permeability, and resistance to chloride-ion penetration of lightweight aggregate concrete10.1016/j.conbuildmat.2010.06.020 ↗
51. Bai Y, Ibrahim R, Basheer PAM. Properties of lightweight concrete manufactured with fly ash, furnace bottom ash, and Lytag. In: Intern workshop on sustainable development and concrete technology, Beijing, May 20–21, 2004. p. 77–88.
52. fib 34. Bulletin 34 – model code for service life design. Lausanne: prepared by CEB/FIP working group 5.6 on lightweight aggregate concrete. FIB – Fédération Internationale du Béton; 2006.