Effect of compaction temperature and procedure on the design of asphalt mixtures using Marshall and gyratory compactors
Source abstract
Abstract
Abstract The use of the Superpave Gyratory Compactor (SGC) for asphalt mixtures design is increasingly common in many countries. Although in Spain the Marshall compactor is still used, the possibility of adopting the gyratory compactor is currently being evaluated. This is the reason why this study is focused on evaluating the influence of these compaction procedures in volumetric and mechanical properties of asphalt mixtures. Two representative mixtures of the most used in Spain have been selected. Specimens of continuous (AC16S) and gap-graded (BBTM11B) mixtures with 50/70 penetration bitumen were produced. Three combinations of vertical pressure and angles of gyration, and five compaction temperatures, were used and the influence of these variables on the shear stress, density, air-void content and stiffness modulus was analyzed. The stiffness modulus and densities obtained in samples produced with SGC and Marshall hammer at different temperatures were also compared. For the studied mixtures it was shown that the variation of the temperature slightly affects the volumetric properties of the mixtures and introduces a significant change in the stiffness modulus.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Asphalt Pavement Performance Evaluation · Infrastructure Maintenance and Monitoring · Material Properties and Failure Mechanisms
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (17)
Show source-provided references
1. Butcher M. Determining gyratory compaction characteristic using servopac gyratory compactor. In: Transportation Research Record: Journal of the Transportation Research Board, No. 1630. Transportation Research Board Academies, Washington, DC; 1998. p. 89–97.10.3141/1630-11 ↗
2. Kennedy TW, Huber GA, Harrigan ET, Cominsky RJ, Hughes CS, Von Quintus H, et al. Superior performing asphalt pavements (Superpave). The product of the SHRP asphalt research program. Strategic highway research program, SHRP-A-410, National Research Council Washington; 1994.
3. Cominsky Ronald J. The Superpave mix design manual for new construction and overlays. Report no. SHRP-A-407. Washington (DC): National Academy of Sciences; 1994.
4. Watson DE, Brown R, Moore J. Comparison of Superpave and Marshall mix performance in Alabama. In: Transportation Research Record: Journal of the Transportation Research Board, No. 1929. Transportation Research Board Academies, Washington, DC; 2005. p. 133–40.10.1177/0361198105192900116 ↗
5. Habib A, Hossain M, Kaldate R, Fager GA. Comparison of Superpave and Marshall mixtures for low-volume roads and shoulders. In: Transportation Research Record: Journal of the Transportation Research Board, No. 1609. Transportation Research Board Academies, Washington, DC; 1998. p. 44–50.10.3141/1609-06 ↗
6. Cominsky RJ, Huber GA, Kennedy TW, Anderson M. The Superpave mix design manual for new construction and overlays, strategic highway research program, Report no. SHRP-A-407, Washington, DC; 1994.
7. Pine WJ. Superpave gyratory compaction and the NdesignTable. Internal report to Illinois Department of Transportation; 1997.
8. Bahia HU, Friemel T, Peterson P, Russell J. Optimization of constructability and resistance to traffic: a new design approach for HMA using the Superpave gyratory compactor. Asphalt paving technology, vol. 67, Journal of the Association of Asphalt Paving Technologists; 1998. p. 189–232.
9. Barral M, Romera R, Miranda L, Bravo F, Berbis J, Felipo J, et al. Estudio Comparativo de la Metodología de Compactación Giratoria-Impacto, Parte III. Revista Asfalto y Pavimentación No. 6, vol. II; 2012. p. 9–20.
10. Watson DE, Moore J, Heartstill J, Jared D, Wu P. Verification of Superpave number of design gyration compaction levels for Georgia. In: Transportation Research Record: Journal of the Transportation Research Board, No. 2057. Transportation Research Board Academies, Washington, DC; 2008. p. 75–82.10.3141/2057-09 ↗
11. Cho DW, Bahia HU, Kamel NI. Critical evaluation of use of the procedure of Superpave volumetric mixture design for modified binders. In: Transportation Research Record: Journal of the Transportation Research Board, No. 1929. Transportation Research Board Academies, Washington, DC; 2005. p. 114–25.10.1177/0361198105192900114 ↗
12. Martínez A, Miró R, Pérez-Jiménez F. Spanish experience with gyratory compactor and indirect tensile test in design and control of cold recycle asphalt pavement. In: Transportation Research Record: Journal of the Transportation Research Board, No. 2001. Transportation Research Board Academies, Washington, DC; 2007. p. 163–8.10.3141/2001-18 ↗
13. Evaluation of compactability and mechanical properties of bituminous mixes with warm additives10.1016/j.conbuildmat.2010.11.024 ↗
14. Faheem A, Bahia H. Using gyratory compactor to measure mechanical stability of asphalt mixtures. Wisconsin department of transportation. Technical report. Wisconsin highway research program, October 2004.
15. Mallick R. Use of Superpave gyratory compactor to characterize hot-mix asphalt. In: Transportation Research Record: Journal of the Transportation Research Board, No. 1681. Transportation Research Board Academies, Washington, DC; 1999. p. 86–96.10.3141/1681-11 ↗
16. Anderson RM, Turner PA, Peterson RL, Mallick RB. Relationship of Superpave gyratory compaction properties to HMA rutting behavior. National cooperative highway research program NCHRP report no. 478, Transportation Research Board-TRB, Washington; 2002.
17. Moutier F, Corte JF, Bonnot J. Comparison of the use of the gyratory compactor in the French mix design method and in Superpave level 1. In: Proceedings of the conference on road safety in Europe and strategic highway research program, Prague, The Czech Republic, September 20–22, 1995.