journal article·2018-04

Determining the water damage resistance of nano-clay modified bitumens using the indirect tensile strength and surface free energy methods

Hend Ali Omar, Nur Izzi Md. Yusoff, Halil Ceylan, Irman Abdul Rahman, Zainuddin Sajuri, Fauzan Mohd Jakarni, Amiruddin Ismail

Publisher page

Abstract

Abstract Water infiltration into asphalt mixtures is one the serious distresses which lowers the performance of the top layer of road pavements. This problem is even worse in tropical countries which experience high temperature and heavy rainfalls. Therefore, this study aims to evaluate the effects of water infiltration on a 60/70 penetration grade bitumen vis-a-vis bitumen modified with 2 and 4% nano-clay. The Fourier Transform InfraRed (FTIR) test was done to identify any chemical changes that might occur in the nano-clay and the bitumen. The loose and compacted mixtures of the nano-clay modified bitumen were tested to determine their resistance to water damage. The loose mixture was tested by conducting the boiling water, the Vialit adhesion, and surface free energy (SFE) tests, while the compacted mixture was tested using the indirect tensile strength (ITS) test. Aging simulation was done for samples tested using SFE and ITS. The results of the tests show that adding nano-clay alters the mixtures’ ability to resist water damage. The improvement in the samples varies depending on the type of binder as well as its aging stage. Unaged bitumen modified with 2% nano-clay show better ability to resist water damage compared to both the unmodified bitumen and the bitumen modified with 4% nano-clay. However, after being subjected to short-term aging (STA) and long-term aging (LTA), the results of both the ITS and SFE tests show that the addition of 4% nano-clay enhance the bitumen’s resistance to water damage in comparison with the unmodified bitumen and the bitumen modified with 2% nano-clay. The addition of nano-clay reduces water’s effect on the binder, hence indicating the benefit of using nano-clay as an additive to mitigate water effect.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Asphalt Pavement Performance Evaluation · Infrastructure Maintenance and Monitoring · Concrete and Cement Materials Research

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (62)

Show source-provided references
1. Adhesion tension in asphalt pavements, its significance and methods applicable in its determination
2. G. Factors of importance in the practical solution of the stripping problem
3. A Method for quantitative evaluation of adhesion test
4. K. Majidzadeh, F.N. Brovold, Effect of water on bitumen-aggregate mixtures. University of Florida, Gainesville, FL, Report CE-1, 1966.
5. The mechanisms of asphalt stripping from aggregate surfaces
6. Surface energy measurement of asphalt and its application to predicting fatigue and healing in asphalt mixtures10.3141/1810-06 ↗
7. Use of surface free energy properties of the asphalt-aggregate system to predict moisture damage potential
8. Fundamental Characterization of Asphalt Clay Nanocomposites10.1061/(ASCE)NM.2153-5477.0000050 ↗
9. Hicks · 1991
10. A Synthesis of Theories and Mechanisms of Bitumen-Aggregate Adhesion Including Recent Advances in Quantifying the Effects of Water
11. Stripping of asphalt pavements: State of the art
12. Adhesion and disbonding mechanisms of asphalt used in highway construction and maintenance
13. B.M. Kiggundu, F.L. Roberts, Stripping in HMA mixtures: state-of-the-art and critical review of test methods. National Center for Asphalt Technology Auburn, Report No. 88-2.1988.
14. Rheological properties, low-temperature cracking resistance, and optical performance of exfoliated graphite nanoplatelets modified asphalt binder10.1016/j.conbuildmat.2016.03.152 ↗
15. Effect of aging on fatigue performance of hydrated lime modified bituminous mixes10.1016/j.conbuildmat.2016.03.066 ↗
16. Ahmed · 2016 · 180
17. A review of advances of nanotechnology in asphalt mixtures10.1016/j.sbspro.2013.08.144 ↗
18. Influence of surface modification on physical and ultraviolet aging resistance of bitumen containing inorganic nanoparticles10.1016/j.conbuildmat.2015.08.138 ↗
19. Rheological properties and chemical analysis of nanoclay and carbon microfiber modified asphalt with Fourier transform infrared spectroscopy10.1016/j.conbuildmat.2012.08.004 ↗
20. Effect of deicing solutions on the tensile strength of micro-or nano-modified asphalt mixture10.1016/j.conbuildmat.2010.06.038 ↗
21. Evaluation of moisture susceptibility of nanoclay-modified asphalt binders through the surface science approach10.1061/(ASCE)MT.1943-5533.0001228 ↗
22. Evaluation of mechanical properties of nano-clay modified asphalt mixtures10.1016/j.measurement.2016.07.045 ↗
23. Effect of clay and lime nano-additives on the freeze–thaw durability of hot mix asphalt
24. K. Louw, D. Rossmann, D. Cupido, The Vialit adhesion test: Is it an appropriate test to predict low temperature binder/aggregate failure? in: Proceedings of the 8th Conference on Asphalt Pavements for Southern Africa (CAPSA'04), 2004, p. 16.
25. Characterisation of halloysite for use as a microtubular drug delivery system10.1016/S0378-5173(02)00274-0 ↗
26. A critical review on nanotube and nanotube/nanoclay related polymer composite materials10.1016/j.compositesb.2006.02.020 ↗
27. Thakur · 2015
28. Determining the effects of aging on halloysite nano-tube modified binders through the pull-off test method10.1016/j.conbuildmat.2016.09.038 ↗
29. Evaluation of polymer modified chip seal coats
30. M. Karasahin, B. Aktas, C. Gurer, Determining of precoated aggregate performance on chip seals using vialit test, Transportation Research Board 90th Annual Meeting, Report No. 11-1220, 2011.
31. Using surface free energy method to study the cohesion and adhesion of asphalt mastic10.1016/j.conbuildmat.2013.05.067 ↗
32. Relationship between bond energy and total work of fracture for asphalt binder-aggregate systems10.1080/14680629.2012.657094 ↗
33. D.N. Little, A. Bhasin, A. Hefer, Using surface energy measurements to select materials for asphalt pavement, Transportation Research Board. Report RRD 316, 2006.
34. A.W. Hefer, Adhesion in bitumen-aggregate systems and quantification of the effects of water on the adhesive bond, Ph.D Thesis, Texas A&M University, 2004.
35. Surface free energy and moisture susceptibility evaluation of asphalt binders modified with surfactant-based chemical additive10.1016/j.jclepro.2015.10.101 ↗
36. Moisture susceptibility of asphalt mixtures, Part 1: mechanisms10.1080/10298430701792128 ↗
37. D. Cheng, D. Little, R.L. Lytton, J.C. Holste, Surface Free Energy Measurement of Aggregates and Its Application to Adhesion and Moisture Damage of Asphalt Aggregate Systems, in: International Center for Aggregates Research, 9th Annual Symposium, Austin, Texas, 2001.
38. Assessment of the effect of mineral filler on asphalt–aggregate interfaces based on thermodynamic properties10.1016/j.conbuildmat.2011.08.089 ↗
39. Influence of using nonmaterial to reduce the moisture susceptibility of hot mix asphalt10.1016/j.conbuildmat.2011.06.048 ↗
40. A.R. Copeland, Influence of moisture on bond strength of asphalt-aggregate systems, Ph.D Thesis, Vanderbilt University, 2007.
41. R.G. Hicks, L. Santucci, T. Aschenbrener, Introduction and seminar objectives. Moisture Sensitivity of Asphalt Pavements-A National Seminar, 2003.
42. A study of asphalt aging using Indirect Tensile Strength test10.1016/j.conbuildmat.2015.07.159 ↗
43. Study on the amorphous poly alpha olefin (APAO) modified asphalt binders10.1016/j.conbuildmat.2014.05.071 ↗
44. P. Mikhailenko, A. Bertron, E. Ringot, Methods for analyzing the chemical mechanisms of bitumen aging and rejuvenation with FTIR spectrometry, in: 8th RILEM International Symposium on Testing and Characterization of Sustainable and Innovative Bituminous Materials: Springer, 2016; pp. 203–214.10.1007/978-94-017-7342-3_17 ↗
45. Infrared microscopy investigation of oxidation and phase evolution in bitumen modified with polymers10.1016/j.fuel.2007.06.029 ↗
46. M. Perez-Martinez, P. Marsac, T. Gabet, E. Chailleux, Prediction of the Mechanical Properties of Aged Asphalt Mixes from FTIR Measurements, in: 8th RILEM International Symposium on Testing and Characterization of Sustainable and Innovative Bituminous Materials: Springer, 2016; pp. 399–409.10.1007/978-94-017-7342-3_32 ↗
47. Abdullah · 2014 · 996
48. Laboratory evaluation of asphalt binder modified with carbon nanotubes for Egyptian climate10.1016/j.conbuildmat.2016.05.168 ↗
49. Effect of sonication on high temperature properties of bituminous binders reinforced with nano-additives10.1016/j.conbuildmat.2014.11.021 ↗
50. Physiochemical, Rheological, and Oxidative Aging Characteristics of Asphalt Binder in the Presence of Mesoporous Silica Nanoparticles10.1061/(ASCE)MT.1943-5533.0001423 ↗
51. The effects of moisture susceptibility and ageing conditions on nano-silica/polymer-modified asphalt mixtures10.1016/j.conbuildmat.2014.09.014 ↗
52. Nanomaterials applied in asphalt modification: a review10.1016/j.jmst.2013.04.008 ↗
53. Experimental evaluation of anti-stripping additives in bituminous mixtures through multiple scale laboratory test results10.1016/j.conbuildmat.2011.10.012 ↗
54. Q. Lu, Investigation of conditions for moisture damage in asphalt concrete and appropriate laboratory test methods, Ph.D Thesis, University of California, 2005.
55. Effect of aggregate properties on stripping
56. Kennedy · 1984
57. Evaluation of the effects of anti-stripping agents on the performance of asphalt mixtures10.1016/j.conbuildmat.2015.03.024 ↗
58. Examination of moisture sensitivity of aggregate–bitumen bonding strength using loose asphalt mixture and physico-chemical surface energy property tests10.1080/10298436.2013.855312 ↗
59. Studies on the aging behavior of the Arabian asphalts10.1016/S0016-2361(99)00018-6 ↗
60. J. Deng, L.Ye, Effects of chemical treatment and mixing methods on fracture behaviour of halloysite-epoxy nanocomposites, in: Proc 17th International Conference on ‘Composite materials’, Edinburgh, UK, 2009.
61. Effect of water absorption on the mechanical properties of nano-filler reinforced epoxy nanocomposites10.1016/j.matdes.2012.05.060 ↗
62. Water absorption, mechanical, and thermal properties of halloysite nanotube reinforced vinyl-ester nanocomposites10.1007/s10853-013-7240-x ↗