Preparation and characterization of methyl palmitate/palygorskite composite phase change material for thermal energy storage in buildings
Source abstract
Abstract
Abstract In this study, palygorskites (PALs) including raw PAL, acid-activated PAL and organic PAL were using as carrier to prepare methyl palmitate (MPA)/PAL composite phase change materials (PCM) by vacuum impregnation method (VIM) and direct impregnation method (DIM), respectively. The microstructure, thermal property and thermal stability of MPA/PAL composite were investigated. Scanning electron microscopy and N2 adsorption-desorption measurement results of PAL indicated that acid treatment can remove the impurities inside the crystal bundles and then form a highly porous structure. The MPA was well incorporated into the holes and surface of PAL. The MPA/PAL composite prepared by VIM exhibited higher absorption ratio (46.32%) than that of DIM. The values of freezing latent heat for MPA/Raw PAL, MPA/H+-PAL and MPA/OPAL (prepared via VIM) were 51.31 J/g, 96.10 J/g and 81.96 J/g, respectively. The phase-change temperature of MPA/PAL composites was range from 22.29 °C to 24.5 °C. Moreover, the H+-PAL/MPA composite had good thermal reliability after 300 times thermal cycling test. Therefore, the MPA/PAL composite was an effective building material for reducing energy consumption.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Phase Change Materials Research · Adsorption and Cooling Systems · Solar Thermal and Photovoltaic Systems
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (37)
Show source-provided references
1. Integrating phase change materials in construction materials: critical review10.1016/j.conbuildmat.2019.05.064 ↗
2. Multifunctional smart concretes with novel phase change materials: Mechanical and thermo-energy investigation10.1016/j.apenergy.2018.01.014 ↗
3. Preparation and thermal properties of short carbon fibers/erythritol phase change materials10.1016/j.enconman.2017.01.023 ↗
4. Thermal energy storage characterization of cement-based systems containing microencapsulated-PCMs10.1016/j.conbuildmat.2018.11.195 ↗
5. Study on preparation, structure and thermal energy storage property of capric-palmitic acid/attapulgite composite phase change materials10.1016/j.apenergy.2011.02.030 ↗
6. A review on current status and challenges of inorganic phase change materials for thermal energy storage systems10.1016/j.rser.2016.12.012 ↗
7. Fatty acids as phase change materials: a review10.1016/j.rser.2013.08.107 ↗
8. Preparation, characterization and thermal properties of lauric acid/expanded perlite as novel form-stable composite phase change material10.1016/j.cej.2009.09.005 ↗
9. Fatty acid eutectic/polymethyl methacrylate composite as form-stable phase change material for thermal energy storage10.1016/j.apenergy.2010.01.010 ↗
10. Myristic acid/polyaniline composites as form stable phase change materials for thermal energy storage10.1016/j.solmat.2013.03.006 ↗
11. Investigation of unbranched, saturated, carboxylic esters as phase change materials10.1016/j.renene.2017.02.056 ↗
12. Fatty acid esters-based composite phase change materials for thermal energy storage in buildings10.1016/j.applthermaleng.2011.11.017 ↗
13. Latent heat characteristics of fatty acid derivatives pursuant phase change material applications10.1016/S0009-2509(03)00006-X ↗
14. High-chain fatty acid esters of 1-hexadecanol for low temperature thermal energy storage with phase change materials10.1016/j.solmat.2011.09.013 ↗
15. Fatty acid ester-based commercial products as potential new phase change materials (PCMs) for thermal energy storage10.1016/j.solmat.2012.08.015 ↗
16. Microencapsulation of caprylic acid with different wall materials as phase change material for thermal energy storage10.1016/j.solmat.2013.09.035 ↗
17. Preparation, morphology and thermal properties of microencapsulated palmitic acid phase change material with polyaniline shells10.1007/s10973-017-6352-y ↗
18. Microencapsulated n-octadecane with different methylmethacrylate-based copolymer shells as phase change materials for thermal energy storage10.1016/j.energy.2012.08.037 ↗
19. Microencapsulation of n-octadecane phase change material with calcium carbonate shell for enhancement of thermal conductivity and serving durability: synthesis, microstructure, and performance evaluation10.1016/j.apenergy.2013.10.029 ↗
20. New approach for sol–gel synthesis of microencapsulated n-octadecane phase change material with silica wall using sodium silicate precursor10.1016/j.energy.2013.11.088 ↗
21. Preparation and characterization of sodium thiosulfate pentahydrate/silica microencapsulated phase change material for thermal energy storage10.1039/C6RA28056K ↗
22. Synthesis and properties of microencapsulated paraffin composites with SiO2 shell as thermal energy storage materials10.1016/j.cej.2010.07.054 ↗
23. Review on clay mineral-based form-stable phase change materials: preparation, characterization and applications10.1016/j.rser.2016.10.014 ↗
24. Solvent-free selective epoxidation of soybean oil catalyzed by peroxophosphotungstate supported on palygorskite10.1016/j.clay.2014.01.015 ↗
25. Recent progress in dispersion of palygorskite crystal bundles for nanocomposites10.1016/j.clay.2015.06.030 ↗
26. Purification of lignocellulose hydrolysate by org-attapulgite/(divinyl benzene-styrene-methyl acrylate) composite adsorbent10.15376/biores.11.4.8664-8675 ↗
27. Stearic–capric acid eutectic/activated-attapulgiate composite as form-stable phase change material for thermal energy storage10.1016/j.enconman.2014.02.045 ↗
28. Y Enhancement of thermal conductivity by the introduction of carbon nanotubes as a filler in paraffin/expanded perlite form-stable phase-change materials10.1016/j.enbuild.2017.05.037 ↗
29. Tailoring the properties of palygorskite by various organic acids via a one-pot hydrothermal process: a comparative study for removal of toxic dyes10.1016/j.clay.2015.11.019 ↗
30. Acid activation of a palygorskite with HCl: development of physico-chemical, textural and surface properties10.1016/0169-1317(95)00007-Q ↗
31. Acid treatment of south Tunisian palygorskite: removal of Cd(II) from aqueous and phosphoric acid solutions10.1016/j.desal.2009.01.043 ↗
32. H3PW12O40 immobilized on silylated palygorskite and catalytic activity in esterification reactions10.1016/j.clay.2009.10.014 ↗
33. Paraffin/Palygorskite composite phase change materials for thermal energy storage10.1016/j.solmat.2015.09.002 ↗
34. Experimental study on the phase change behavior of phase change material confined in pores10.1016/j.solener.2006.08.010 ↗
35. Preparation and thermal performance of methyl palmitate and lauric acid eutectic mixture as phase change material (PCM)10.1016/j.est.2017.08.005 ↗
36. Effect of compaction pressure and water-content on the thermal-conductivity of some natural clays10.1346/CCMN.1988.0360512 ↗
37. Thermal and flammable properties of bamboo pulp fiber/high-density polyethylene composites: influence of preparation technology, nano calcium carbonate and fiber content10.1016/j.renene.2018.09.051 ↗