Influence of strain rate on bond behavior of concrete members reinforced with basalt fiber-reinforced polymer rebars
Source abstract
Abstract
Abstract Fiber-reinforced polymer (FRP) rebars are utilized extensively in reinforced concrete structures because of advantageous mechanical and physical properties. The bond behavior of concrete members reinforced with FRP rebars is essential to evaluate the load carrying capacity of concrete members. Although the bond behavior of concrete members reinforced with FRP rebars under static loading has been studied, research studies on the bond behavior of concrete members reinforced with basalt FRP (BFRP) rebars under dynamic loading are still lacking. The bond behaviors of concrete members reinforced with BFRP rebars under different strain rates were investigated. Test results and corresponding analysis showed that: (1) three bond failure modes of concrete members reinforced with BFRP rebars under dynamic loading were observed: crushing of concrete, bond failure at interface between resin and concrete, and bond failure at interface between fiber and resin; (2) the bond strength of concrete members reinforced with BFRP rebars increased as the strain rates increased and a model for bond strength was proposed considering strain rate; (3) the slip corresponding to bond strength decreased as the strain rates increased and a model for the slip corresponding to bond strength of concrete members reinforced with BFRP rebars was proposed considering strain rate; (4) a prediction model for bond stress-slip relationship of concrete members reinforced with BFRP rebars considering strain rate was proposed based on the BPE model which considers concrete cover, transverse confinement, steel rebar spacing and compressive strength of concrete, etc.. The proposed model showed good correlation with experimental results.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Structural Behavior of Reinforced Concrete · Concrete Corrosion and Durability · Structural Response to Dynamic Loads
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (77)
Show source-provided references
1. An explanation for rate effect of concrete strength based on fracture toughness including free water viscosity10.1016/j.engfracmech.2004.01.012 ↗
2. Influence of initial static stress on the dynamic properties of concrete10.1016/j.cemconcomp.2007.11.004 ↗
3. Site amplification effects of a radially multi-layered semi-cylindrical canyon on seismic response of an earth and rockfill dam10.1016/j.soildyn.2018.09.014 ↗
4. Effect of soil variability on bearing capacity accounting for non-stationary characteristics of undrained shear strength10.1016/j.compgeo.2019.02.003 ↗
5. Blast testing of ultra-high performance fiber and FRP-retrofitted concrete slabs10.1016/j.engstruct.2009.03.020 ↗
6. Strain rate effect on bond stress-slip relationship between basalt fiber-reinforced polymer sheet and concrete10.1177/0731684415574539 ↗
7. Analysis of FRP-strengthened RC beam-column joints10.1061/(ASCE)1090-0268(2002)6:1(41) ↗
8. Experimental investigations on reinforced concrete shear walls strengthened with basalt fiber-reinforced polymers under cyclic load10.1016/j.conbuildmat.2016.12.102 ↗
9. Experimental testing of concrete bridge-deck slabs reinforced with Basalt-FRP reinforcing bars under concentrated loads10.1061/(ASCE)BE.1943-5592.0000892 ↗
10. Tests on seismic performance of corroded reinforced concrete shear walls repaired with basalt fiber-reinforced polymers10.1016/j.conbuildmat.2019.02.109 ↗
11. Behavior of RC box beam strengthened with basalt FRP using end anchorage with grooving10.1177/0021998319826376 ↗
12. Experimental response and code modelling of continuous concrete slabs reinforced with BFRP bars10.1016/j.compstruct.2013.08.029 ↗
13. Study on bond properties of BFRP bars to basalt fiber reinforced concrete10.4028/www.scientific.net/AMR.163-167.1251 ↗
14. Mechanical properties of basalt fiber reinforced geopolymeric concrete under dynamic loading10.1016/j.msea.2008.11.063 ↗
15. Brik · 1997 · 21
16. Characteristics of basalt fiber as a strengthening material for concrete structures10.1016/j.compositesb.2005.02.002 ↗
17. V.B. Brik, Advanced concept concrete using basalt fiber/BF composite rebar reinforcement. IDEA Project 86, Washington, DC: Transportation Research Board, p. 71.
18. Chemical and thermal resistance of basalt fiber in inclement environments10.1007/s11595-013-0731-4 ↗
19. Polymer composite materials made from carbon, basalt, and glass fibres. Structure and Properties10.1023/A:1026170209171 ↗
20. The performance of basalt fibre in high strength concrete
21. Properties of basalt plastics and of composites reinforced by hybrid fibers in operating conditions
22. Environmental resistance and mechanical performance of basalt and glass fibers10.1016/j.msea.2010.04.021 ↗
23. Polymer composite materials with fibrous and disperse basalt fillers10.1007/s10692-008-9044-3 ↗
24. Post-dynamic mechanical characterisation of E-Glass/basalt woven fabric interply hybrid laminates10.3144/expresspolymlett.2011.43 ↗
25. Bond behavior between basalt fiber-reinforced polymer sheet and concrete substrate under the coupled effects of freeze-thaw cycling and sustained load10.1061/(ASCE)CC.1943-5614.0000349 ↗
26. Experiment study of BFRP bars’ mechanical properties10.4028/www.scientific.net/AMM.174-177.830 ↗
27. Behavior of reinforced concrete box beam with initial cracks repaired with basalt fiber-reinforced polymer sheet10.1177/0731684415595469 ↗
28. Study of ductility properties by effective replacement of steel with basalt fibre reinforced polymer
29. Bond stress–slip relationship between basalt fiber-reinforced polymer bars and concrete using a pull-out test10.1177/0731684415627504 ↗
30. Bond performance of basalt fiber-reinforced polymer bars to concrete10.1061/(ASCE)CC.1943-5614.0000487 ↗
31. Experimental study on the mechanical property of micro-concrete in model test
32. Comité Euro-International du Béton (CEB-FIP) (2010) CEB-FIP model code 2010, first completed draft, vol 1. Comité Euro-International du Béton, Lausanne.
33. Effects of strain-rate on concrete strength
34. Influence of high strain rates on stress–strain relationship, strength and elastic modulus of concrete10.1016/j.cemconcomp.2007.10.001 ↗
35. Influence of loading rate on bond behavior of reinforcing steel and prestressing strands
36. Experimental study on dynamic behavior of CFRP-to-concrete interface10.1061/(ASCE)CC.1943-5614.0000677 ↗
37. Experimental and calculative research on the dynamic bond strength of the interface between steel and cement mortar
38. Experimental investigation about dynamic bond-slip between reinforcing steel bar and concrete10.4028/www.scientific.net/AMM.249-250.1073 ↗
39. Numerical simulation about dynamic bond-slip between reinforcing steel bar and concrete
40. Prediction of bond between steel and concrete by numerical analysis
41. Bond behavior between steel reinforcing bars and concrete under dynamic loads10.1002/suco.201700205 ↗
42. Eligehausen · 1983
43. Chinese standard GB 50010-2010 Code for design of concrete structures. China Ministry of Construction, Beijing. (in Chinese)
44. Local bond stress-slip behavior of reinforcing bars embedded in plain and fiber concrete
45. Numerical bond analysis using experimentally derived local bond laws: a powerful method for evaluating the bond strength of reinforcement10.1061/(ASCE)0733-9445(2007)133:5(695) ↗
46. A local bond stress-slip model for reinforcing bars in self-compacting concrete
47. Fujii · 1992
48. Experimental study of early-age bond behavior between high strength concrete and reinforcement using a pull-out test10.1016/j.conbuildmat.2016.03.094 ↗
49. Q.W. Bi, H. Wang, Bond strength of BFRP bars to basalt fiber reinforced high-strength concrete, in: The 5th International Conference on FRP Composites in Civil Engineering 2010 Beijing, China, 27–29 September 2010, pp. 576–58010.1007/978-3-642-17487-2_125 ↗
50. Bond performances of FRP rebars-reinforced concrete10.1061/(ASCE)0899-1561(2007)19:3(205) ↗
51. Bond stress-slip behaviour of two common GFRP rebar types with pullout failure10.1680/macr.11.00050 ↗
52. Evaluation of bond stress-slip models for FRP reinforcing bars in concrete10.1016/j.compstruct.2013.07.037 ↗
53. Quantification of bond-slip relationship for externally bonded FRP-to concrete joints10.1061/(ASCE)CC.1943-5614.0000375 ↗
54. Local bond-slip relationship for FRP reinforcement in concrete10.1061/(ASCE)1090-0268(2000)4:1(24) ↗
55. Interfacial bond strength of glass fiber reinforced polymer bars in high-strength concrete10.1016/j.compositesb.2007.03.008 ↗
56. Bond-slip models for FRP sheets/plates bonded to concrete10.1016/j.engstruct.2005.01.014 ↗
57. Experimental investigation of bond characteristics between CFRP fabrics and steel plate joints under dynamic tensile loads10.1016/j.compstruct.2011.08.018 ↗
58. Early-age behavior and cracking resistance of high-strength concrete reinforced with Dramix 3D steel fiber10.1016/j.conbuildmat.2018.10.125 ↗
59. Dynamic bond stress-slip relationship between basalt FRP sheet and concrete under initial static loading10.1061/(ASCE)CC.1943-5614.0000568 ↗
60. Strain rate effect on effective bond length of basalt FRP sheet bonded to concrete10.1016/j.conbuildmat.2015.02.016 ↗
61. ACI 363R–92, State-of-the-Art Report on High-Strength Concrete ACI Committee Report American Concrete Institute, Detroit, 1992, 363R1–363R55
62. Bond strength of fiber reinforced polymer rebars in normal strength concrete10.1061/(ASCE)1090-0268(2005)9:3(203) ↗
63. Guide test methods for fiber-reinforced polymers (FRPs) for reinforcing or strengthening concrete structures (ACI 440–3R-04)
64. Bond strength of glass fiber reinforced polymer ribbed rebars in normal strength concrete10.1016/j.conbuildmat.2008.04.011 ↗
65. Effect of loading rate on the bonding strength between rebar and concrete10.4028/www.scientific.net/AMR.450-451.122 ↗
66. Influence of service temperature and strain rate on the bond performance of CFRP reinforcement in concrete10.1016/j.compstruct.2015.02.076 ↗
67. Bond behavior of FRP bars under direct pullout conditions10.1061/(ASCE)1090-0268(2004)8:2(173) ↗
68. Transfer bond stresses generated between FRP tendons and concrete10.1680/macr.1999.51.4.229 ↗
69. Characterization of FRP rods as near-surface mounted reinforcement10.1061/(ASCE)1090-0268(2001)5:2(114) ↗
70. Tensile characterization of glass FRP bars10.1016/j.compositesb.2004.05.004 ↗
71. Compressive behaviour of concrete at high strain rates10.1007/BF02472016 ↗
72. Effect of fibers on the bonds between FRP reinforcing bars and high-strength concrete10.1016/j.compositesb.2007.11.005 ↗
73. Local bond performance of rebar embedded in steel-polypropylene hybrid fiber reinforced concrete under monotonic and cyclic loading10.1016/j.conbuildmat.2015.11.040 ↗
74. Bond strength of concrete with the reinforcement bars polluted with oil
75. Prediction of tensile capacity of bond anchorages for FRP tendons10.1061/(ASCE)1090-0268(2000)4:2(39) ↗
76. Huang · 1996
77. Behavior and modeling of bond of FRP rebars to concrete10.1061/(ASCE)1090-0268(1997)1:2(40) ↗