journal article·2020-11Open access

Rheological and tribological behaviors of polypropylene fiber reinforced concrete

I. Bentegri, O. Boukendakdji, E-H. Kadri, T.T. Ngo, H. Soualhi

Abstract

Abstract The historical data showed a positive influence of polypropylene fibers (PPF) on concrete performance in terms of mechanical properties, shrinkage and fire resistance. However, in regards to fresh state properties, the workability is negatively affected by fibers inclusion. Therefore, several studies have been done to evaluate the workability loss of fiber-reinforced concrete (FRC), but there has been little research about the rheological and tribological properties such as the plastic viscosity and the viscous constant. In this context, the present study aims to evaluate the effect of PPF inclusion on both rheological and tribological properties of ordinary concrete through two phases (without and with incorporation of superplasticizer), using fibrillated twist and wave fibers shapes at different dosages (0.12, 0.24, 0.36%) and with various lengths (19, 30 and 54 mm). The obtained results of the first part showed that the plastic viscosity of FRC without superplasticizer is not affected by fibers length while it augments with increasing PPF percentage. Regarding the tribological behavior, segregation phenomenon was observed for mixtures with high fiber dosage (0.24 and 0.36%) during the test. In the second part, the use of superplasticizer has improved the concrete workability in addition to the rheological and tribological behaviors. Finally, a special attention was devoted to the effect of using two different shapes and lengths of PPF on the same fresh concrete, indicating that this combination of fibers leads to decrease both the plastic viscosity and the constant viscous for all mixtures comparing to that of concrete mixtures with one fiber type.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Innovative concrete reinforcement materials · Structural Behavior of Reinforced Concrete · Concrete and Cement Materials Research

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (38)

Show source-provided references
1. P.K. Mehta, Concrete Microstructure, properties and materials, 1986, Consulté le: sept. 09, 2019. [En ligne]. Disponible sur: https://trid.trb.org/view/273357.
2. H. Othman, T. Sabrah, et H. Marzouk, Conceptual design of ultra-high performance fiber reinforced concrete nuclear waste container, Nucl. Eng. Technol., 51 (2) 588–599, avr. 2019, doi: 10.1016/j.net.2018.10.014.10.1016/j.net.2018.10.014 ↗
3. Lightweight aggregate concrete fiber reinforcement – A review10.1016/j.conbuildmat.2012.07.071 ↗
4. S. Kakooei, H.M. Akil, M. Jamshidi, et J. Rouhi, The effects of polypropylene fibers on the properties of reinforced concrete structures, Constr. Build. Mater., 27 (1) 73–77, févr. 2012, doi: 10.1016/j.conbuildmat.2011.08.015.10.1016/j.conbuildmat.2011.08.015 ↗
5. A. Noushini, M. Hastings, A. Castel, et F. Aslani, Mechanical and flexural performance of synthetic fibre reinforced geopolymer concrete, Constr. Build. Mater., 186, p. 454‑475, oct. 2018, doi: 10.1016/j.conbuildmat.2018.07.110.10.1016/j.conbuildmat.2018.07.110 ↗
6. J. jun Li, J. gang Niu, C. jun Wan, B. Jin, et Y. liu Yin, Investigation on mechanical properties and microstructure of high performance polypropylene fiber reinforced lightweight aggregate concrete, Constr. Build. Mater., 118, p. 27‑35, août 2016, doi: 10.1016/j.conbuildmat.2016.04.116.10.1016/j.conbuildmat.2016.04.116 ↗
7. E. Güneyisi, M. Gesoğlu, A.O.M. Akoi, et K. Mermerdaş, Combined effect of steel fiber and metakaolin incorporation on mechanical properties of concrete, Compos. Part B Eng., 56, p. 83‑91, janv. 2014, doi: 10.1016/j.compositesb.2013.08.002.10.1016/j.compositesb.2013.08.002 ↗
8. How does adsorption behavior of polycarboxylate superplasticizer effect rheology and flowability of cement paste with polypropylene fiber?10.1016/j.cemconcomp.2018.11.003 ↗
9. H. Mazaheripour, S. Ghanbarpour, S. H. Mirmoradi, et I. Hosseinpour, The effect of polypropylene fibers on the properties of fresh and hardened lightweight self-compacting concrete, Constr. Build. Mater., 25 (1) 351‑358, janv. 2011, doi: 10.1016/j.conbuildmat.2010.06.018.10.1016/j.conbuildmat.2010.06.018 ↗
10. Combined effects of water film thickness and polypropylene fibre length on fresh properties of mortar10.1016/j.conbuildmat.2018.03.259 ↗
11. Comparative evaluation of virgin and recycled polypropylene fibre reinforced concrete10.1016/j.conbuildmat.2016.03.162 ↗
12. Properties of polypropylene fiber reinforced concrete using recycled aggregates10.1016/j.conbuildmat.2015.08.133 ↗
13. A.C. Aydin, Self compactability of high volume hybrid fiber reinforced concrete, Constr. Build. Mater., 21 (6) 1149–1154, juin 2007, doi: 10.1016/j.conbuildmat.2006.11.017.10.1016/j.conbuildmat.2006.11.017 ↗
14. S.E. Chidiac et F. Mahmoodzadeh, Plastic viscosity of fresh concrete – A critical review of predictions methods, Cem. Concr. Compos., 31 (8) 535–544, sept. 2009, doi: 10.1016/j.cemconcomp.2009.02.004.10.1016/j.cemconcomp.2009.02.004 ↗
15. Controlling the quality of fresh concrete—a new approach10.1680/macr.2000.52.5.353 ↗
16. Measurement and modeling of fresh concrete viscous constant to predict pumping pressures10.1139/l11-058 ↗
17. G. Dreux, F. Gorisse, et J. Simonnet, COMPOSITION DES BETONS : METHODE DREUX-GORISSE - BILAN DE CINQ ANNEES D’APPLICATION EN COTE D’IVOIRE, ANN ITBTP, no 414(BETON‑214), mai 1983, Consulté le: sept. 09, 2019. [En ligne]. Disponible sur: https://trid.trb.org/view/1039141.
18. AFNOR et M. Hesling, NF EN 12350-2 Essais pour béton frais — Partie 2 : Essai d’affaissement, p. 3, juin 2019.
19. J. E. Wallevik, Relationship between the Bingham parameters and slump, Cem. Concr. Res., 36 (7) 1214–1221, juill. 2006, doi: 10.1016/j.cemconres.2006.03.001.10.1016/j.cemconres.2006.03.001 ↗
20. O.H. Wallevik et J.E. Wallevik, Rheology as a tool in concrete science: The use of rheographs and workability boxes, Cem. Concr. Res., 41 (12) 1279‑1288, déc. 2011, doi: 10.1016/j.cemconres.2011.01.009.10.1016/j.cemconres.2011.01.009 ↗
21. H. Soualhi, E.-H. Kadri, T.-T. Ngo, A. Bouvet, F. Cussigh, et Z.-E.-A. Tahar, Design of portable rheometer with new vane geometry to estimate concrete rheological parameters, J. Civ. Eng. Manag., 23 (3) 347–355, avr. 2017, doi: 10.3846/13923730.2015.1128481.10.3846/13923730.2015.1128481 ↗
22. H. Soualhi, E.-H. Kadri, A. Bouvet, T.-T. Ngo, F. Cussigh, et A.-S.-E. Belaidi, New model to estimate plastic viscosity of eco-friendly and conventional concrete, Constr. Build. Mater., 135, 323‑334, mars 2017, doi: 10.1016/j.conbuildmat.2017.01.009.10.1016/j.conbuildmat.2017.01.009 ↗
23. Rheology of ordinary and low-impact environmental concretes10.1080/01694243.2015.1059641 ↗
24. D. Burns, M. Jolin, F. Gagnon, et F. Chapdelaine, État des connaissances dans le béton projeté par voie humide, p. 11.
25. C.F. Ferraris et F. de Larrard, Modified Slump Test to Measure Rheological Parameters of Fresh Concrete, Cem. Concr. Aggreg., 20 (2) 241–247, déc. 1998, doi: 10.1520/CCA10417J.10.1520/CCA10417J ↗
26. G.H. Tattersall, Workability and Quality Control of Concrete, p. 268.
27. E.P. Koehler et D.W. Fowler, Summary of Concrete Workability Test Methods, août 2003, doi: 10.15781/T29G0P.
28. D. Beaupré, Rheology of high performance shotcrete, University of British Columbia, 1994.
29. P.F.G. Banfill, Rheology of Fresh Cement and Concrete: Proceedings of an International Conference, Liverpool, 1990. CRC Press, 1990.10.1201/9781482288889 ↗
30. Rheological methods for assessing the flow properties of mortar and related materials10.1016/0950-0618(94)90007-8 ↗
31. J. Gołaszewski et J. Szwabowski, Influence of superplasticizers on rheological behaviour of fresh cement mortars, Cem. Concr. Res., 34 (2) 235‑248, févr. 2004, doi: 10.1016/j.cemconres.2003.07.002.10.1016/j.cemconres.2003.07.002 ↗
32. Optimisation de la viscosité des bétons à faible impact environnemental, thesis
33. F. de Larrard, Structures granulaires, p. 414.
34. T.T. Ngo, E.H. Kadri, R. Bennacer, et F. Cussigh, Use of tribometer to estimate interface friction and concrete boundary layer composition during the fluid concrete pumping, Constr. Build. Mater., 24 (7) 1253–1261, juill. 2010, doi: 10.1016/j.conbuildmat.2009.12.010.10.1016/j.conbuildmat.2009.12.010 ↗
35. F. Chapdelaine, Etude fondamentale et pratique sur le pompage du béton, p. 154.
36. T.-T. Ngo, E.-H. Kadri, F. Cussigh, et R. Bennacer, Relationships between concrete composition and boundary layer composition to optimise concrete pumpability, Eur. J. Environ. Civ. Eng., 16 (2) 157–177, févr. 2012, doi: 10.1080/19648189.2012.666910.10.1080/19648189.2012.666910 ↗
37. A.J. Al-Tayyib, M.M. Al-Zahrani, Rasheeduzzafar, et G.J. Al-Sulaimani, Effect of polypropylene fiber reinforcement on the properties of fresh and hardened concrete in the Arabian Gulf environment, Cem. Concr. Res., 18 (4) 561–570, juill. 1988, doi: 10.1016/0008-8846(88)90049-X.10.1016/0008-8846(88)90049-X ↗
38. Fracture mechanics of polyolefin fibre reinforced concrete: Study of the influence of the concrete properties, casting procedures, the fibre length and specimen size10.1016/j.engfracmech.2015.12.032 ↗