Bond degradation due to the desalination process
Source abstract
Abstract
Abstract In this paper, bond degradation due to the desalination process of chloride-contaminated reinforced concrete is investigated. Four different constant voltages were applied to study the effect of the current on the desalination. Two constant current densities were applied for comparison. Two different electrolytes, NaOH and Ca(OH)2, were used to examine the effect of electrolyte on the bond characteristics. Pullout specimens were cast and tested, using a single rebar pullout test. Three bond parameters of the bond strength, the critical debonding shear load per unit embedded rebar length and the shear stiffness per unit embedded rebar length were obtained to evaluate the bond quality after desalination. It is found that the bond characteristics decrease dramatically as the duration and/or the voltage of desalination increase. Using Ca(OH)2 solution as the electrolyte, less bond loss is observed than using NaOH solution. A micro-hardness experiment shows that softening of concrete near the rebar becomes more apparent as the desalination duration and/or desalination voltage increase. A chemical titration experiment indicates that the accumulation of potassium and sodium ions increases as the desalination duration and/or desalination voltage increase. A pH value measurement shows that the desalination current increases the pH value of concrete near the rebar. More than two-thirds of chloride ions migrate out of the rebar–concrete interface in two weeks of desalination with desalination voltage greater than 10 V. Bond strength decreases approximately 40–60%.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Concrete Corrosion and Durability · Smart Materials for Construction · Concrete and Cement Materials Research
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (20)
Show source-provided references
1. Corrosion of reinforcement in concrete construction
2. Effect of cement composition on chloride binding and corrosion of reinforcing steel in concrete
3. Lankard DR, Slatter JE, Holden WA, Niest DE. Neutralization of chloride in concrete. FHWA Report No. FHWA-RD-76-6, Battelle Columbus Laboratories, September, 1975
4. Morrison GL, Virmani YP, Stratton FW, Gilliand WJ. Chloride removal and monomer impregnation of bridge deck concrete by electro-osmosis. FHWA Report No. FHWA-KS-82-2, Kansas Department of Transport, August, 1982
5. Polder R, Van der Hondel HJ. Electrochemical realkalisation and chloride removal of concrete. State of the art, laboratory and field experience. In: Proceedings of RILEM Conference, Rehabilitation of Concrete Structures, Melbourne, 1992: 135–47
6. Vennesland Ø, Humstad EP. Electrochemical removal of chloride from concrete- effects of bond strength and removal efficiency. In: Proceedings of the Fourth International Symposium on Corrosion of Reinforcement in the Construction Industry, Cambridge, 1996: 448–55
7. Factors influencing electrochemical removal of chloride from concrete10.1016/0008-8846(96)00067-1 ↗
8. Carbonation and electrochemical chloride extraction from concrete10.1016/0008-8846(96)00076-2 ↗
9. Mechanical properties of anodic and cathodic regions of ECE treated concrete10.1016/S0008-8846(96)85014-9 ↗
10. Structural shape effect on rehabilitation of vertical concrete structures by ECE technique10.1016/0008-8846(95)00192-1 ↗
11. Pull-out and bond degradation of steel rebars in ECE concrete10.1016/0008-8846(95)00210-3 ↗
12. The effect of the electrochemical chloride extraction treatment on steel-reinforced mortar, part I: electrochemical measurements10.1016/S0008-8846(99)00118-0 ↗
13. The effect of the electrochemical chloride extraction treatment on steel-reinforced mortar, part II: microstructural characterization10.1016/S0008-8846(99)00117-9 ↗
14. Mathematical modeling of electrochemical chloride extraction from concrete10.1016/0008-8846(95)00063-I ↗
15. Numerical modeling of electrochemical chloride removal from concrete
16. Electrochemical removal of chlorides, modeling of the extraction, resulting profiles and determination of the efficient time of treatment10.1016/S0008-8846(00)00220-9 ↗
17. Electrochemical chloride removal from concrete prisms containing chloride penetrated from sea water10.1016/0950-0618(95)00062-3 ↗
18. Simultaneous chloride removal and realkalinization of old concrete structures10.1016/0008-8846(94)90028-0 ↗
19. A pullout test for determining interface properties between rebar and concrete10.1016/S1065-7355(96)00004-1 ↗
20. Degradation of the bond strength between rebar and concrete due to the impressed cathodic current