journal article·2016-05

Influence of mix composition and strength on the fracture properties of self-compacting concrete

W.S. Alyhya, M.S. Abo Dhaheer, M.M. Al-Rubaye, B.L. Karihaloo

Publisher page

Abstract

Self-compacting concrete (SCC) has undergone extensive investigations that have led to confidence in its fresh and hardened properties, yet its composition variations raise concerns as to its fracture behaviour. This paper presents the results of an experimental study on fracture behaviour of SCC mixes differing by the coarse aggregate volume, paste to solids ratio (p/s) and water to binder (or cementitious material (w/cm )) ratio. First the size-dependent fracture energy (Gf) has been determined using the RILEM work-of-fracture test on three point bend specimens of a single size, half of which contained a shallow starter notch (notch to depth ratio = 0.1), while the other half contained a deep notch (notch to depth ratio = 0.6). Then the specific size-independent fracture energy (GF) was calculated using the simplified boundary effect formalism in which the variation in the fracture energy along the unbroken specimen ligament is approximated by a bilinear diagram. Finally, the bilinear approximation of the tension softening diagram corresponding to GF has been obtained using the non-linear hinge model. It is found that GF and the critical crack opening (wc ) are dominated by the coarse aggregate volume in the mix and the mix grade. The larger the coarse aggregate volume (or the smaller the paste to solids ratio) the larger are both the mix toughness (GF) and the critical crack opening (wc ). However, the higher the mix grade the larger is the mix toughness (GF) but the lower is the critical crack opening (wc).
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Innovative concrete reinforcement materials · Concrete and Cement Materials Research · Concrete Properties and Behavior

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (54)

Show source-provided references
1. Karihaloo · 1995
2. Bazant · 1998
3. Determination of the fracture energy of mortar and concrete by means of three-point bend tests on notched beams
4. Determination of size-independent specific fracture energy of concrete from three-point bend and wedge splitting tests10.1680/macr.2003.55.2.133 ↗
5. Analysis of work-of-fracture method for measuring fracture energy of concrete
6. Size dependence of concrete fracture energy determined by RILEM work-of-fracture method10.1007/BF00033974 ↗
7. Size effects on concrete fracture energy: dimensional transition from order to disorder10.1007/BF02486360 ↗
8. Fracture energy and fracture process zone10.1007/BF02472590 ↗
9. The effect of specimen size on the fracture energy of concrete10.1016/0008-8846(84)90062-0 ↗
10. Various size effects in fracture of concrete10.1016/0008-8846(85)90016-X ↗
11. Measurement of the fracture energy using three-point bend tests: Part 1 – influence of experimental procedures10.1007/BF02473065 ↗
12. Measurement of the fracture energy using three-point bend tests: Part 2 – influence of bulk energy dissipation10.1007/BF02472671 ↗
13. A general bilinear fit for the softening curve of concrete10.1007/BF02472827 ↗
14. Size effect on toughness induced by crack close to free surface10.1016/S0013-7944(99)00123-X ↗
15. A simple method for determining the true specific fracture energy of concrete10.1680/macr.2003.55.5.471 ↗
16. Analysis of crack formation and crack growth in concrete by means of fracture mechanics and finite elements10.1016/0008-8846(76)90007-7 ↗
17. Analytical model for fictitious crack propagation in concrete beams
18. Fictious crack propagation in fiber-reinforced-concrete beams
19. A method for constructing the bilinear tension softening diagram of concrete corresponding to its true fracture energy10.1680/macr.2004.56.10.597 ↗
20. Bilinear tension softening diagrams of concrete mixes corresponding to their size-independent specific fracture energy10.1016/j.conbuildmat.2013.06.004 ↗
21. Effect of coarse aggregate size and matrix quality on ITZ and failure behavior of concrete under uniaxial compression10.1016/S0958-9465(03)00092-1 ↗
22. Self-compacting concrete10.3151/jact.1.5 ↗
23. Self-compacting concrete10.1680/stco.2000.1.1.3 ↗
24. Y. Edamatsu, N. Nishida, A rational mix-design method for self-compacting concrete interaction between coarse aggregate and mortar particles, in: Proc. Sixth East-Asia- Pacific Conf. Struct. Eng. Constr., vol. 2, 1998, pp. 1307–1312.
25. A simple mix design method for self-compacting concrete10.1016/S0008-8846(01)00566-X ↗
26. The effect of aging on the fracture characteristics and ductility of self-compacting concrete10.1016/j.matdes.2013.10.066 ↗
27. Self-compacting concrete: an analysis of 11years of case studies10.1016/j.cemconcomp.2005.10.003 ↗
28. The influence of coarse aggregate size and volume on the fracture behavior and brittleness of self-compacting concrete10.1016/j.cemconres.2014.06.008 ↗
29. Evaluation of the effect of maximum aggregate size on fracture behavior of self compacting concrete10.1016/j.conbuildmat.2014.01.065 ↗
30. Effect of coarse aggregate volume on fracture behavior of self compacting concrete10.1016/j.conbuildmat.2013.11.041 ↗
31. The effect of water to cement ratio on fracture parameters and brittleness of self-compacting concrete10.1016/j.matdes.2013.02.018 ↗
32. Determination of size-independent specific fracture energy of normal- and high-strength self-compacting concrete from wedge splitting tests10.1016/j.conbuildmat.2013.07.062 ↗
33. Influence of paste volume on shrinkage cracking and fracture properties of self-compacting concrete10.1016/j.cemconcomp.2007.03.010 ↗
34. Boundary effect on concrete fracture and non-constant fracture energy distribution10.1016/S0013-7944(02)00223-0 ↗
35. Size effect on specific fracture energy of concrete10.1016/j.engfracmech.2006.01.031 ↗
36. Influence of fracture process zone height on fracture energy of concrete10.1016/j.cemconres.2003.12.027 ↗
37. Fracture process zone size and true fracture energy of concrete using acoustic emission10.1016/j.conbuildmat.2009.10.014 ↗
38. Size-independent fracture energy in plain concrete beams using tri-linear model10.1016/j.conbuildmat.2011.01.003 ↗
39. Determination of size-independent specific fracture energy of concrete mixes by the tri-linear model10.1016/j.cemconres.2013.03.010 ↗
40. Determination of size-independent specific fracture energy of concrete mixes by two methods10.1016/j.cemconres.2013.03.015 ↗
41. Mix proportioning of self- compacting high- and ultra- high-performance concretes with and without steel fibres10.1680/macr.11.00190 ↗
42. Mix proportioning of self-compacting normal and high-strength concretes10.1680/macr.12.00164 ↗
43. Proportioning of self-compacting concrete mixes based on target plastic viscosity and compressive strength: mix design procedure
44. Proportioning of self-compacting concrete mixes based on target plastic viscosity and compressive strength: experimental validation
45. Development of self-compacting high and ultra high performance concretes with and without steel fibres10.1016/j.cemconcomp.2011.11.001 ↗
46. CARDIFRC® – development and mechanical properties. Part III: uniaxial tensile response and other mechanical properties10.1680/macr.2005.57.8.433 ↗
47. EFNARC Guidelines, The European Guidelines for Self-Compacting Concrete; specification, production and use, 2005, p. 63.
48. BS EN 12390:part 3, Testing hardened concrete: compressive strength of test specimens, 2009.
49. BS EN 12390:part 6, Testing hardened concrete: tensile splitting strength of test specimens, 2009.
50. BS 1881:part 121, Method for determination of static modulus of elasticity in compression, 1983.
51. Interpretation of aggregate volume fraction effects on fracture behavior of concrete10.1016/j.conbuildmat.2011.08.080 ↗
52. Effect of water/cement ratio and silica fume addition on the fracture toughness and morphology of fractured surfaces of gravel concretes10.1016/S0008-8846(00)00332-X ↗
53. Effect of specimen and crack sizes, water/cement ratio and coarse aggregate texture upon fracture toughness of concrete10.1680/macr.1984.36.129.227 ↗
54. Neville · 1995