journal article·2020-01Open access

High-performance fibre-reinforced heavyweight self-compacting concrete: Analysis of fresh and mechanical properties

Farhad Aslani, Fatemeh Hamidi, Afsaneh Valizadeh, Anthony Thanh-Nhan Dang

Abstract

Fibre-reinforcement of most of the concrete technologies, such as heavyweight concrete (HWC) and self-compacting concrete (SCC), would promote their practical applications through upgrading their mechanical properties, and subsequently, structural performance. This study evaluates the fresh and mechanical properties of fibre-reinforced heavyweight self-compacting concrete (FRHWSCC). Magnetite was used as heavyweight aggregate (HWA). Hooked-end steel and polypropylene (PP) fibres with length of 60 and 65 mm and diameter of 0.75 and 0.85 mm, respectively, were applied as reinforcements. Two different HWA content (75% and 100%), and four different volume fractions including 0.25%, 0.50%, 0.75%, 1.00% for steel, and 0.10%, 0.15%, 0.20%, 0.25% for PP fibres were utilized. To evaluate the fresh properties of FRHWSCC, slump flow test including slump flow diameter and T500mm, and J-Ring test have been performed. Hardened-state density, compressive, tensile, and flexural strength were measured to assess the mechanical properties of FRHWSCC. The obtained results for the fresh properties revealed that despite the negative impact of HWA and fibres on the workability of SCC, the FRHWSCC with both steel and PP fibres were still capable to retain their self-compacting characteristics according to the EFNARC standards. The hardened densities of specimens were above the density threshold for HWC, except for the FRHWSCC containing steel fibre, which showed slight decrease by increasing the steel fibre content to 0.5%, 0.75%, and 1.00% at 75% magnetite content, revealing the void formation within the cement paste. Compressive, tensile, and flexural strength results showed enhancement in the mechanical properties of FRHWSCC by increasing the fibre content, however, for both fibre types, increasing the HWA content impacted the mechanical properties in a negative manner, especially by aging the concrete. Finally, the load-deflection curves analysis confirmed the more ductile failure mode for the FRHWSCC comparing to plain SCC.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Innovative concrete reinforcement materials · Concrete and Cement Materials Research · Concrete Properties and Behavior

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (72)

Show source-provided references
1. Fibre reinforced cement-based (FRC) composites after over 40 years of development in building and civil engineering10.1016/j.compstruct.2008.03.006 ↗
2. Cement industry: sustainability, challenges and perspectives10.1007/s10311-010-0302-2 ↗
3. Alkali-activated materials10.1016/j.cemconres.2017.02.009 ↗
4. Effects of elevated temperatures on properties of concrete10.1016/j.firesaf.2007.01.003 ↗
5. Direct tensile properties of engineered cementitious composites: a review10.1016/j.conbuildmat.2017.12.124 ↗
6. Geopolymers and related alkali-activated materials10.1146/annurev-matsci-070813-113515 ↗
7. Use of macro plastic fibres in concrete: a review10.1016/j.conbuildmat.2015.05.105 ↗
8. On Engineered Cementitious Composites (ECC): a review of the material and its applications
9. A review of Australian research into natural fibre cement composites10.1016/j.cemconcomp.2004.09.003 ↗
10. A review of the mechanical and durability properties of strain hardening cement-based composite (SHCC)
11. Effect of the addition of polypropylene fibers on the rheological behaviour of fresh fluid cementitious materials
12. Development of high-performance heavy density concrete using different aggregates for gamma-ray shielding10.1016/j.pnucene.2014.11.009 ↗
13. Assessing the physical, mechanical properties, and γ-ray attenuation of heavy density concrete for radiation shielding purposes10.1080/12269328.2018.1469434 ↗
14. Fire performance of heavyweight self-compacting concrete and heavyweight high strength concrete10.3390/ma12050822 ↗
15. Effect of elevated temperatures on mechanical properties of high-strength concrete containing varying proportions of hematite10.1002/fam.1102 ↗
16. Mechanical properties of shielding concrete with magnetite aggregate subjected to high temperature10.1016/j.proeng.2015.06.117 ↗
17. The effect of elevated temperature on the properties of cement mortars containing nanosilica and heavyweight aggregates10.1016/j.conbuildmat.2017.02.003 ↗
18. High temperatures properties of barite concrete with cathode ray tube funnel glass10.1002/fam.2181 ↗
19. Influence of barite aggregate friability on mixing process and mechanical properties of concrete10.1016/j.conbuildmat.2014.10.040 ↗
20. Development of heavyweight high performance fiber reinforced cementitious composites (HPFRCC)–part I: mechanical properties10.1016/j.conbuildmat.2017.05.009 ↗
21. Development of heavyweight high performance fiber reinforced cementitious composites (HPFRCC)–part II: X-ray and gamma radiation shielding properties10.1016/j.conbuildmat.2017.12.086 ↗
22. Effect of Nano-ferrite addition on mechanical properties and gamma ray attenuation coefficient of steel fiber reinforced heavy weight concrete10.1016/j.conbuildmat.2019.02.099 ↗
23. Self-compacting concrete10.3151/jact.1.5 ↗
24. Workability, testing, and performance of self-consolidating concrete
25. In situ mechanical properties of wall elements cast using self-consolidating concrete
26. Effects of specimen size and shape on compressive and tensile strengths of self-compacting concrete with or without fibres
27. Hybrid fiber reinforced self-compacting concrete with a high-volume coarse fly ash10.1016/j.conbuildmat.2005.06.032 ↗
28. Use of silica fume and recycled steel fibers in self-compacting concrete (SCC)10.1016/j.conbuildmat.2016.08.046 ↗
29. Mechanical, durability and microstructural characteristics of ultra-high-strength self-compacting concrete incorporating steel fibers10.1016/j.matdes.2009.04.024 ↗
30. Workability of hybrid fiber reinforced self-compacting concrete10.1016/j.buildenv.2004.12.014 ↗
31. Mechanical behaviour and fibre dispersion of hybrid steel fibre reinforced self-compacting concrete10.1016/j.conbuildmat.2011.08.044 ↗
32. An experimental survey on combined effects of fibers and nanosilica on the mechanical, rheological, and durability properties of self-compacting concrete10.1016/j.matdes.2013.03.046 ↗
33. Mechanical properties of self-compacting concrete reinforced with polypropylene fibres10.1179/143307511X13018917925900 ↗
34. AS 3972. General purpose and blended cements, 2010.
35. AS 2350. Methods of testing Portland and blended cements, 2006.
36. AS 3583. Methods of test for supplementary cementitious materials for use with Portland and blended cement, 2016.
37. AS 3582. Supplementary cementitious materials for use with portland and blended cement - Slag - Ground granulated iron blast-furnace, 2001.
38. Development of self-consolidating rubberized concrete incorporating silica fume10.1016/j.conbuildmat.2017.11.146 ↗
39. AS 1478.1. Chemical admixtures for concrete, mortar and grout- Admixtures for concrete, 2000.
40. ASTM A820/A820M Standard Specification for Steel Fibers for Fiber-Reinforced Concrete, 2016.
41. BS EN 14889-2 Fibres for concrete. Polymer fibres. Definitions, specifications and conformity, 2006.
42. Bunsell · 2005
43. M.F. Kaplan, Concrete radiation shielding, 1989.
44. ERMCO The European guidelines for self-compacting concrete (May), 2005.
45. Specification and Guidelines for Self-Compacting Concrete, 2002.
46. AS 1012 Methods of testing concrete, 2014.
47. Bleeding characteristics of high consistency heavyweight concrete mixtures10.1016/j.conbuildmat.2018.11.029 ↗
48. Performance of new viscosity modifying admixtures in enhancing the rheological properties of cement paste10.1016/S0008-8846(03)00233-3 ↗
49. Polymer-based admixtures10.1016/S0958-9465(97)00065-6 ↗
50. Workability and mechanical properties of heavyweight magnetite concrete
51. Mix design effective parameters on γ-ray attenuation coefficient and strength of normal and heavyweight concrete10.1016/j.conbuildmat.2011.08.043 ↗
52. Shrinkage of heavyweight magnetite concrete with and without fly ash10.1016/j.conbuildmat.2013.05.034 ↗
53. Mechanical properties and constitutive stress–strain behaviour of steel fiber reinforced concrete under uni-axial stresses10.1007/s41024-019-0044-x ↗
54. Properties of polypropylene fiber reinforced concrete using recycled aggregates10.1016/j.conbuildmat.2015.08.133 ↗
55. Green concrete production incorporating waste carpet fiber and palm oil fuel ash10.1016/j.jclepro.2016.06.162 ↗
56. Assessment and development of high-performance fibre reinforced lightweight self-compacting concrete including recycled crumb rubber aggregates exposed to elevated temperatures10.1016/j.jclepro.2018.07.323 ↗
57. Development of high-performance self-compacting concrete using waste recycled concrete aggregates and rubber granules10.1016/j.jclepro.2018.02.074 ↗
58. Experimental investigation into rubber granules and their effects on the fresh and hardened properties of self-compacting concrete10.1016/j.jclepro.2017.12.003 ↗
59. Experimental investigation into the properties of self-compacting rubberised concrete incorporating polypropylene and steel fibers10.1002/suco.201800182 ↗
60. Properties of high-performance self-compacting rubberized concrete exposed to high-temperatures10.1061/(ASCE)MT.1943-5533.0002672 ↗
61. The effect of carbon nanofibers on fresh and mechanical properties of lightweight engineered cementitious composite using hollow glass microspheres10.1177/0021998319827078 ↗
62. Fabrication and characterization of an engineered cementitious composite with enhanced fire resistance performance10.1016/j.jclepro.2019.02.241 ↗
63. investigation into rubber granules and their effects on the fresh and hardened properties of self-compacting concrete10.1016/j.jclepro.2017.12.003 ↗
64. Lightweight self-compacting concrete incorporating Perlite, Scoria, and Polystyrene aggregates10.1061/(ASCE)MT.1943-5533.0002350 ↗
65. Normal- and high-strength lightweight self-compacting concrete incorporating Perlite, Scoria, and Polystyrene aggregates at elevated temperatures10.1061/(ASCE)MT.1943-5533.0002538 ↗
66. Development of heavyweight self-compacting concrete and ambient-cured heavyweight geopolymer concrete using magnetite aggregates10.3390/ma12071035 ↗
67. Properties of ambient-cured normal and heavyweight geopolymer concrete exposed to high temperatures10.3390/ma12050740 ↗
68. Effectiveness of fiber reinforcement on the mechanical properties and shrinkage cracking of recycled fine aggregate concrete10.3390/ma9030131 ↗
69. A study on effect of steel fiber in fly ash based self compacting concrete
70. Radiation shielding and mechanical properties of steel fiber reinforced concrete (SFRC) produced with EAF slag aggregates10.1016/j.radphyschem.2018.03.010 ↗
71. Flexural performance of fibre reinforced concrete made with steel and synthetic fibres10.1016/j.conbuildmat.2012.06.042 ↗
72. Post-cracking behaviour of steel and macro-synthetic fibre-reinforced concretes10.1016/j.conbuildmat.2010.12.022 ↗