journal article·2020-12

Non-hydrophobized perlite renders for repair and thermal insulation purposes: Influence of different binders on their properties and durability

Martin Vyšvařil, Milena Pavlíková, Martina Záleská, Adam Pivák, Tomáš Žižlavský, Pavla Rovnaníková, Patrik Bayer, Zbyšek Pavlík

Publisher page

Abstract

Abstract To meet today’s increasing requirements on the quality of life and thus indoor air climate, new advanced construction materials are under research and development. Specific issue represents repair and renewal of old or historically valuable buildings, where the newly applied materials must be compatible with those originally used in the past. Taking into consideration the necessity to decrease the energy consumption of existing buildings with valuable aesthetic facades and appearance, use of repair renders with improved thermal insulation performance represents acceptable solution to adopt the present building stock to actual thermal requirements. In this paper, complex characterization of non-hydrophobized lightweight renders designed at once for repair and thermal insulation purposes was performed. In composition of designed materials, silica sand was partially or fully replaced with expanded perlite of the similar grain size distribution, whereas the workability of fresh renders was maintained on the same level. Among broad experimental campaign, structural parameters, moisture and heat transport and storage properties, and mechanical parameters of the hardened renders were assessed in dependence on time of samples maturing. Frost resistance test was conducted to characterize renders durability. The use of lime and natural hydraulic lime in composition of perlite lightened mortars enabled to meet all the criteria on rendering and masonry mortars taking into consideration their functionality, compatibility, durability and thermal insulation performance. These mortars well found usable for repair of historical masonry and even in conservation of heritage protected buildings. On the other hand, the cement-lime renders were found to be incompatible, too rigid and less permeable both for water and water vapor than required by culture heritage authorities, related technical standards and directives for repair renders. Nevertheless, these can find use in the construction of new buildings as thermal insulation and general purpose mortars.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Building materials and conservation · Concrete and Cement Materials Research · Dental materials and restorations

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (64)

Show source-provided references
1. Effect of water-repellent admixtures on the behavior of aerial lime-based mortars10.1016/j.cemconres.2009.07.026 ↗
2. Effect of a propylene fibre on the behavior of aerial lime-based mortars10.1016/j.conbuildmat.2010.06.080 ↗
3. Assessment of mortar shrinkage in aspect of organic and inorganic modifiers use10.1016/j.proeng.2015.06.152 ↗
4. Physico-chemical and mechanical characterization of hydraulic mortars containing nano-titania for restoration applications10.1016/j.cemconcomp.2012.07.002 ↗
5. R. Artis, Admixtures and Additives for Lime Mortars, The Building Conservation Directory, 2014, https://www.buildingconservation.com/articles/lime-mortar-additives/lime-mortar-additives.htm, accessed January 1, 2020.
6. RILEM TC 203-RHM, repair mortars for historic masonry: performance requirements for renders and plasters10.1617/s11527-012-9916-0 ↗
7. Introduction to requirements for and functions and properties of repair mortars10.1007/BF02479291 ↗
8. The hydrophobicity of renovation plaster in manufacturing technology optimized by statistical methods10.1016/j.conbuildmat.2013.08.051 ↗
9. In-situ analysis of hygric performance of piaristic monastery building10.1063/1.4912635 ↗
10. Selection of plasters and renders for salt laden masonry substrates10.1016/j.conbuildmat.2008.09.013 ↗
11. Moisture and salt transport in three-layer plaster/substrate systems10.1016/j.conbuildmat.2009.08.014 ↗
12. T. D. Gonçalves, L. Pel, J. Delgado Rodrigues, Worsening of dampness and salt damage after restoration interventions: use of water-repellent additives in plasters and renders, Proc. HMC08, LNEC, Lisbon, 2008.
13. The influence of the pore structure on the moisture transport in lime plaster-brick systems as studied by NMR10.1016/j.conbuildmat.2017.03.086 ↗
14. Design and behavior of traditional lime-based plasters and renders, Review and critical appraisal of strengths and weaknesses10.1016/j.cemconcomp.2018.03.005 ↗
15. EN 998-1, Specification for Mortar for Masonry – Part 1: Rendering and Plastering Mortar, European Committee for Standardization (CEN), Brussels, 2016.
16. EN 1015-10, Methods of test for mortar for masonry – Part 10: Determination of dry bulk density of hardened mortar, European Committee for Standardization (CEN), 1999.
17. EN 1015-11, Methods of test for mortar for masonry – Part 11: Determination of Flexural and Compressive Strength of Hardened Mortar, European Committee for Standardization (CEN), 1999.
18. EN 1015-12, Methods of test for mortar for masonry – Part 12: Determination of Adhesion of Hardened Rendering and Plastering Mortars, European Committee for Standardization (CEN), 2000.
19. EN 1015-18, Methods of test for mortar for masonry – Part 18: Determination of Water Absorption Coefficient Due to Capillary Action of Hardened Mortar, European Committee for Standardization (CEN), 2002.
20. EN 1015-19, Methods of test for mortar for masonry – Part 19: Determination of Water Vapour Permeability of Hardened Rendering and Plastering Mortar, European Committee for Standardization (CEN), 1998.
21. EN 1745, Masonry and masonry products – Methods for Determining Design Thermal Values, European Committee for Standardization (CEN), 2002.
22. F. Pacheco-Torgal F, Faria J, Jalali S. Some considerations about the use of lime–cement mortars for building conservation purpose in Portugal: a reprehensible option or a lesser evil? Constr. Build. Mater. 30 (2012) 488–94.10.1016/j.conbuildmat.2011.12.003 ↗
23. Henry · 2012
24. Lime mortars with heat treated clays and ceramic waste: a review10.1016/j.conbuildmat.2014.09.028 ↗
25. Composite materials in ancient structures10.1016/j.cemconcomp.2004.02.018 ↗
26. Lime pozzolana mortars in Roman catacombs: composition, structures and restoration10.1016/j.cemconres.2004.08.009 ↗
27. Role of lightweight fillers on the properties of a mixed-binder mortar10.1016/j.cemconcomp.2009.07.003 ↗
28. Aerial lime-based mortars blended with a pozzolanic additive and different admixtures: a mineralogical, textural and physical-mechanical study10.1016/j.conbuildmat.2011.12.069 ↗
29. Use of olive stone as an additive in cement lime mortar to improve thermal insulation10.1016/j.enbuild.2013.03.040 ↗
30. Cork-based mortars for thermal bridges correction in a dwelling: thermal performance and cost evaluation10.1016/j.enbuild.2013.12.022 ↗
31. The influence of partial replacement of hemp shives by expanded perlite on physical properties of hemp-lime composite10.1063/1.4994486 ↗
32. Lightweight plasters containing plastic waste for sustainable and energy-efficient building10.1016/j.conbuildmat.2015.07.069 ↗
33. Effect of ceramsite structure on microstructure of interfacial zone and durability of combined aggregate concrete10.1007/s11595-009-1145-1 ↗
34. Effect of porous lightweight aggregate on strength of concrete10.1016/j.matlet.2003.07.036 ↗
35. Hygric and thermal properties of hemp-lime plasters10.1016/j.buildenv.2015.11.013 ↗
36. Use of perlite as a pozzolanic addition in lime mortars
37. Lightweight pozzolanic materials used in mortars: evaluation of their influence on density, mechanical strength and water absorption10.1016/j.cemconcomp.2008.11.003 ↗
38. N.V.Y., Chapter 11 – quantitative phase analysis
39. Pozzolanic properties of brick powders and their effect on the properties of modified lime mortars10.1016/j.conbuildmat.2016.05.062 ↗
40. M. Raverdy, F. Brivot, A. M. Paillére, R. Dron, Appréciation de I'Activité Pouzzolanique des Constituents Secondaires, in: Proceedings of the 7th International Congress on the Chemistry of Cement, Paris, France, 30 June-4 July 1980
41. Éditions Septima: Paris, France, volume 3 (1980) 36-41.
42. EN 1015-3, Methods of test for mortar for masonry. Part 3: determination of consistence of fresh mortar (by flow table), European Committee for Standardization (CEN), Brussels, 1999.
43. EN 13755, Natural stone test methods – Determination of water absorption at atmospheric pressure, European Committee for Standardization (CEN), Brussels, 2008.
44. Determination of moisture diffusivity as a function of both moisture and temperature10.1007/s10765-011-1006-y ↗
45. Iso · 2016
46. Effect of temperature on water vapor transport properties10.1177/1744259114532612 ↗
47. ČSN 722452, Testing of frost resistance of mortar, ÚN, Prague, 1968. (in Czech).
48. WTA Merkblatt 2-9-04/D, Sanierputzsysteme, Wissenschaftlich-Technische Arbeitsgemeinschaft für Bauwerkserhaltung und Denkmalpflege e.V. Vertrieb: WTA Publications, 2005.
49. Mortars with crushed lava granulate for repair of damp historical buildings10.3390/ma12213557 ↗
50. M. Veiga, J. Aguiar, S. A, S. F. Carvalho, Methodologies for characterisation and repair of mortars of ancient buildings, in: P. Lourenço, P. Roca (Eds.), Historical Constructions, Guimarães, 2001.
51. Natural hydraulic lime versus cement for blended lime mortars for restoration works10.1016/j.conbuildmat.2015.06.058 ↗
52. Strength development and lime reaction in mortars for repairing historic masonries10.1016/j.cemconcomp.2004.02.017 ↗
53. Current mortars in conservation: an overview
54. Traditional organic additives improve lime mortars: new old materials for restoration and building natural stone fabrics10.1016/j.conbuildmat.2011.03.020 ↗
55. The longevity of old mortars10.1007/s00339-006-3523-2 ↗
56. I. Papayianni, Design and manufacture of repair mortars for interventions on monuments and historical buildings, Workshop Repair Mortars for Historic Masonry, C. Groot ed., RILEM Publications SARL, 292-304, 2005.
57. The use of zeolite, lightweight aggregate and boiler slag in restoration renders10.1016/j.conbuildmat.2017.03.079 ↗
58. M.R. Veiga, A.C. Magalhães, V. Bokan-Bosikolov, Capillarity tests on historic mortar samples extracted from site. Methodology and compared results. In 13th International Brick an Block Masonry Conference, Amsterdam, July 2004.
59. Influence of the age and drying process on pore structure and sorption isotherms of hardened cement paste10.1016/j.cemconres.2006.06.010 ↗
60. Hysteretic moisture behavior of concrete: modelling and analysis10.1016/j.cemconres.2012.06.010 ↗
61. Fredriksson · Cellulose · 2018 · 25 · 447710.1007/s10570-018-1898-9 ↗
62. Eco-friendly concrete with scrap-tyre-rubber-based aggregate – properties and thermal stability10.1016/j.conbuildmat.2019.07.168 ↗
63. Lime-cement mortars for coating with improved thermal and acoustic performance10.1016/j.conbuildmat.2014.11.012 ↗
64. Characterization of lightweight lime mortars containing brick waste powder10.14311/APP.2019.22.0133 ↗