Long-tern field test and numerical simulation of foamed polyurethane insulation on concrete dam in severely cold region
Source abstract
Abstract
Abstract The environmental temperature is the key factor for cracking failure of mass concrete structures in severely cold regions. In this paper, field test and numerical calculation of long term insulation are carried out to prevent thermal cracks, and ensure the durability and safety of concrete arch dam. Firstly, an equivalent simulation element for concrete-polyurethane composite structure and its calculation method is proposed, based on the equivalence idea of heat emission coefficient for concrete layer and surface insulation layers with different thickness. Secondly, field tests are demonstrated on an 87.5 m height concrete gravity-arch dam, named Xianghongdian dam, from January 1, 2001 to May 30, 2017. Distributions laws, change laws of temperature field and horizontal displacement of the dam, before and after setting polyurethane insulation layer, are compared deeply. Then, the insulation effects of different thicknesses of foamed polyurethane layer are investigated upon the establishment of a FEM model of a concrete arch dam in northwest China. Consequently, stress fields under different broken conditions of polyurethane insulation layer with different typical temperature loads in severely cold region are calculated and analyzed. The results show that the polyurethane insulation layer generally decreases the temperature change range of concrete dam body over 30% in all conditions and even 90% at some locations. Accordingly, the horizontal displacement component, caused by dam temperature, decreases greatly from 10.80 mm to 2.34 mm and its contribution ratio to yearly horizontal displacement decreases from 75.11% to 36.23%. The insulation layer broken would result in a sharp increase of tensile stress of the corresponding area, with the combination influences of low temperature and cold wave. Under small broken condition, the tensile stress increases from 3.69 MPa to 7.57 MPa among broken area; while under large broken condition, the tensile stress increases to 8.68 MPa, which exceeds the maximum tensile stress of concrete material. In this case, a cracking failure of concrete structure would happen. As the dam concrete is an insulation material in some degree, the stress filed doesn’t change a lot in areas the insulation layer is unbroken.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Geotechnical Engineering and Underground Structures · Dam Engineering and Safety · Grouting, Rheology, and Soil Mechanics
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (39)
Show source-provided references
1. Research on effects of concrete material nonlinearity on evaluation of seismic safety of arch dams
2. Failure analysis method of concrete arch dam based on elastic strain energy criterion10.1016/j.engfailanal.2015.11.045 ↗
3. FEA model for the simulation of the hydration process and temperature evolution during the concreting of an arch dam10.1016/j.engstruct.2018.07.065 ↗
4. Damage detection based on system identification of concrete dams using an extended finite element-wavelet transform coupled procedure10.1177/1077546317722428 ↗
5. Mechanisms of interaction between an arch dam and abutment slope using physical model tests10.1007/s00603-017-1321-0 ↗
6. Zoned elasticity modulus inversion analysis method of a high arch dam based on unconstrained Lagrange support vector regression (support vector regression arch dam)10.1007/s00366-016-0483-9 ↗
7. Key technologies in the design and construction of 300 m ultra-high arch dams10.1016/J.ENG.2016.03.012 ↗
8. Experimental research on impact damage of Xiaowan arch dam model by digital image correlation10.1016/j.conbuildmat.2017.04.143 ↗
9. Effects of contraction joints on vibrational characteristics of arch dams: experimental study10.1155/2015/327362 ↗
10. Energy saving benefit, mechanical performance, volume stabilities, hydration properties and products of low heat cement-based materials10.1016/j.enbuild.2018.04.015 ↗
11. Analysis of heat and moisture insulation schemes for a concrete dam of Shankou hydropower station in Xinjiang Province
12. Temperature control measures for construction of normal concrete arch dam in severe cold region
13. Construction technologies of a RCC gravity dam in North Xinjiang
14. Several technical measures for construction of a roller compacted concrete gravity dam in North Xinjiang
15. Prediction modeling for opening-closing degrees of reservoir cracks base on the GRNN in cold area
16. Research on thermal insulation and moisture holding of concrete dams
17. Engineering performance of polyurethane bonded aggregates
18. Research progress of dam surface coating material for concrete in hydraulic engineering
19. Contributions of flexible-arch configurations in shimenzi Arch Dam: new evidence from field measurements
20. Analysis and measurement of the temperature field in the Shimenzi RCC arch dam
21. A simple method to determine the specific heat capacity of thermal insulations used in building construction10.1016/S0378-7788(02)00112-3 ↗
22. Long-term on-site assessment of hygrothermal performance of interior thermal insulation system without water vapour barrier10.1016/j.enbuild.2008.07.007 ↗
23. The durability of shotcrete in cold region tunnel: a review10.1016/j.conbuildmat.2018.07.088 ↗
24. Thermal stress reduction in cool roof membranes using phase change materials (PCM)10.1016/j.enbuild.2017.10.068 ↗
25. Feedback design of temperature control measures for concrete dams based on real-time temperature monitoring and construction process simulation10.1007/s12205-017-1935-5 ↗
26. Research and practice of Nine-Three-One temperature control mode
27. Computation of temperature field in the construction period of concrete dams
28. Early-warning model of deformation safety for roller compacted concrete arch dam considering time-varying characteristics10.1016/j.compstruct.2018.07.023 ↗
29. Time-varying identification model for crack monitoring data from concrete dams based on support vector regression and the bayesian framework
30. Statistical modelling of thermal displacements for concrete dams: influence of water temperature profile and dam thickness profile10.1016/j.engstruct.2018.03.010 ↗
31. Constructing statistical models for arch dam deformation10.1002/stc.1575 ↗
32. Study on semi-parametric statistical model of safety monitoring of cracks in concrete dams10.1155/2013/874629 ↗
33. Wavelet-fractal diagnosis model and its criterion for concrete dam crack status10.1177/0142331217693076 ↗
34. Safety monitoring of a super-high dam using optimal kernel partial least squares10.1155/2015/571594 ↗
35. Copula entropy and information diffusion theory-based new prediction method for high dam monitoring
36. Multi-scale deformation combination forecast model for concrete dam based on BP-ARIMA
37. Study on insulation measure for over-winter concrete placing layer of dam block for Fengman Hydropower Station Reconstruction Project
38. Effect of superficial insulation on roller-compacted concrete dams in cold regions10.1016/j.advengsoft.2011.06.004 ↗
39. Over-winter insulation method for long interval thin placing layer of concrete dam in alpine region