journal article·2020-03

Alkali activated cement made from blast furnace slag generated by charcoal: Resistance to attack by sodium and magnesium sulfates

Neusa Ap. Munhak Beltrame, Caroline Angulski da Luz, Mariana Perardt, R. Doug Hooton

Publisher page

Abstract

Abstract In Brazil, 20% of annual steel production where the furnaces are fueled using charcoal, with growth prospects the increase in the use of charcoal as a substitute for coke. The slags from coal blast furnaces (coke) have a large percentage of CaO, while those produced in charcoal blast furnaces have a low CaO-SiO2 ratio. This study investigated the behavior of alkali activated slag (AAS) made from GBFS generated by charcoal under attack by sulfates. Acceleration of the attack was achieved using miniature paste prisms and cylinder specimens. Sulfate-resistant blended cement samples (PC) were used for comparison. The results showed that AAS presented good performance in sodium sulfate solution, superior to that of the sulfate-resistant blended cement, such that no expansion, loss of compressive strength or degradation of C-S-H were observed. However, when AAS was subjected to magnesium sulfate solution, decalcification of C-S-H, formation of gypsum and alteration of physical, chemical and mechanical properties were observed. Also, the decreasing in compressive strength was much more intense for AAS. The tests using miniature past specimens were efficient at accelerating the sulfate attack, but the intense shrinkage of AAS indicated the need to monitor the mechanical performance.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Concrete and Cement Materials Research · Recycling and utilization of industrial and municipal waste in materials production · Innovative concrete reinforcement materials

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (20)

Show source-provided references
1. Advances in alternative cementitious binders10.1016/j.cemconres.2010.11.012 ↗
2. Influence of slag chemistry on the hydration of alkali-activated blast-furnace slag – Part II: effect of Al2O310.1016/j.cemconres.2011.08.005 ↗
3. Effect of NaOH content in activated alkali cement (AAC) made with basic slag
4. Sindifer · 2015
5. Influence of slag chemistry on the hydration of alkali-activated blast-furnace slag – part I: effect of MgO10.1016/j.cemconres.2011.05.002 ↗
6. The confused world of sulfate attack on concrete10.1016/j.cemconres.2004.04.004 ↗
7. Hydration and properties of sodium sulfate activated slag10.1016/j.cemconcomp.2012.12.010 ↗
8. Sulfate attack on alkali-activated slag concrete10.1016/S0008-8846(01)00659-7 ↗
9. Durability of geopolymer materials in sodium and magnesium sulfate solutions10.1016/j.cemconres.2004.09.002 ↗
10. Microstructural changes in álcali activated fly ash/slag geopolymers with sulfate exposure10.1617/s11527-012-9906-2 ↗
11. Magnesium sulfate resistance of geopolymer mortar10.1016/j.conbuildmat.2018.06.212 ↗
12. Performance testing of hydraulic cements: measuring sulfate resistance10.6028/jres.123.010 ↗
13. Aleksic · 2010 · 178p
14. ASTM C1012 · 2018
15. ABNT (Associação Brasileira de Normas Técnicas), Cimento Portland resistente a sulfatos, NBR 5737, Rio de Janeiro, RJ, Brazil, 1992.
16. An investigation of the carbonation of alkaline activated cement made from blast furnace slag generated by charcoal10.1016/j.conbuildmat.2019.07.209 ↗
17. Chloride Ions Penetration and Carbonation in Alkaline Activated Slag
18. Beltrame · 2018 · 23.1
19. Preliminary study on combined-alkali±slag paste materials10.1016/S0008-8846(00)00269-6 ↗
20. Influence of nucleation seeding on the hydration kinetics and compressive strength of alkali activated slag paste10.1016/j.cemconres.2011.04.002 ↗