journal article·2017-08

Corrosion behavior of steel reinforcement bars embedded in concrete exposed to chlorides: Effect of surface finish

J.O. Rivera-Corral, G. Fajardo, G. Arliguie, R. Orozco-Cruz, F. Deby, P. Valdez

Publisher page

Abstract

Abstract The corrosion behavior of steel bars with different surface finish (ordinary (CS), dual phase (TTS) and galvanized (GS)) was studied in the laboratory using prismatic concrete specimens with two water/cement (w/c) ratios: 0.45 and 0.65. The specimens were exposed to penetration of chlorides using wetting and drying cycles for 2.6 years. The evolution with time of corrosion potential (Ecorr) and polarization resistance (Rp) was studied. Microhardness, microstructural, chloride content and visual inspections of steel bars were also assessed. It was found that the different steels bars exposed followed a same sequence in depassivation for both w/c ratios; i.e. in this order: CS, TTS and GS. During initiation stage, the corrosion current density for TTS was lower than CS, similar behavior was observed in propagation stage for steel bars in specimens with w/c ratio of 0.45. The zinc-based coating obtained by hot-dip galvanization increases the time to corrosion initiation for CS bar and the amount of chlorides needed for this to occur. For GS and TTS bars, localized damage was observed, which was more severe for the GS bar.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Concrete Corrosion and Durability · Corrosion Behavior and Inhibition · Smart Materials for Construction

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (55)

Show source-provided references
1. M.G. Fontana, N.D. Greene, Corrosion Engineering, third ed., 1987.
2. Corrosion behaviour of new stainless steels reinforcing bars embedded in concrete10.1016/j.cemconres.2007.06.003 ↗
3. Electrochemical behavior of steel bar in electrolytes: influence of pH value and cations10.1007/s11595-011-0376-0 ↗
4. Corrosion inhibition mechanism of phosphates for early-age reinforced mortar in the presence of chlorides10.1016/j.cemconcomp.2015.04.009 ↗
5. Chloride threshold values to depassivate reinforcing bars embedded in a standardized OPC mortar10.1016/S0008-8846(00)00265-9 ↗
6. Chloride induced corrosion of reinforcing steel evaluated by concrete resistivity measurements10.1016/j.electacta.2004.05.001 ↗
7. Chloride threshold level for corrosion of steel in concrete10.1016/j.corsci.2007.05.007 ↗
8. Critical chloride content in reinforced concrete – A review10.1016/j.cemconres.2009.08.006 ↗
9. Threshold chloride concentration of selected corrosion – resistant rebar materials compared to carbon steel10.5006/1.3279899 ↗
10. Analysis of the variability of chloride threshold values in the literature10.1002/maco.200905296 ↗
11. Influence of detections methods on chloride threshold value for the corrosion of steel reinforcement10.1016/j.conbuildmat.2008.09.011 ↗
12. Influence of cement type in reinforcement corrosion of mortars under action of chlorides10.1016/j.conbuildmat.2012.11.050 ↗
13. Corrosion of steel rebar embedded in natural pozzolan based mortars exposed to chlorides10.1016/j.conbuildmat.2008.02.023 ↗
14. Chloride induced corrosion durability of high volume fly ash concretes containing nano particles10.1016/j.conbuildmat.2015.09.030 ↗
15. Electrochemical extraction of chlorides from reinforced concrete using a conductive cement paste as the anode10.1016/j.corsci.2010.01.016 ↗
16. Conservation of historical reinforced concrete structures damaged by carbonation induced corrosion by means of electrochemical realkalisation10.1016/j.culher.2008.01.006 ↗
17. Efficiency of a conductive cement-based anodic system for the application of cathodic protection, cathodic prevention and electrochemical chloride extraction to control corrosion in reinforced concrete structures10.1016/j.corsci.2015.04.012 ↗
18. Corrosion products of galvanized rebars embedded in chloride-contaminated concrete10.5006/1.3280600 ↗
19. Dependence of corrosion potential and corrosion rate of a low-alloy steel upon depth of aqueous solution10.1016/S0010-938X(98)00041-9 ↗
20. Corrosion mechanism of hot-dip galvanised reinforcement bar in cracked concrete10.1016/j.corsci.2008.08.050 ↗
21. Microstructure-mechanical property relationships of dual-phase steel wire10.1007/BF02814834 ↗
22. Mechanical properties and corrosion susceptibility of dual-phase steel in concrete10.1016/0008-8846(94)90109-0 ↗
23. Tempcore: a new process for the production of high quality reinforcing bars
24. Corrosion performance of dual-phase steel embedded in concrete
25. Microstructural influence on the electrochemical corrosion behaviour of dual-phase steels in 3.5% NaCl solution10.1016/j.matlet.2005.03.030 ↗
26. Effect of various dual-phase heat treatments on the corrosion behavior of reinforcing steel used in the reinforced concrete structures10.1016/j.conbuildmat.2008.02.001 ↗
27. Study on the effect of volume fraction of dual phase steel to corrosion behaviour and hardness
28. ASTM A615/A615 M, Standard Specification for Deformed and Plain Carbon-Steel Bars for Concrete Reinforcement, Annual Book of ASTM Standards, vol. 01.04, 2016.
29. ASTM A767/A767M, Standard Specification for Zinc-Coated (Galvanized) Steel Bars for Concrete Reinforcement, Annual Book of ASTM Standards, vol. 01.04, 2016.
30. ASTM E407, Standard Practice for Microetching Metals and Alloys, Annual Book of ASTM Standards, vol. 03.01, 2016.
31. ASTM E384, Standard Test Methods for Microindentation Hardness of Materials, Annu. B. ASTM Stand., vol. 03.01, 2016.
32. Testing of chloride exposed reinforced concrete and service life misrepresentation of service performance
33. ACI-318, “ACI-318”, 2008.
34. ASTM C150, Standard Specification for Portland Cement, Annual Book of ASTM Standards, vol. 04.01, 2016.
35. ASTM C33, Standard Specification for Concrete Aggregates, Annual Book of ASTM Standards, vol. 04.02, 2016.
36. ASTM C876, Standard Test Method for Corrosion Potentials of Uncoated Reinforcing Steel in Concrete, Annual Book of ASTM Standards, vol. 03.02, 2016.
37. Chloride-induced corrosion of steel in cracked concrete – Part I: experimental studies under accelerated and natural marine environments10.1016/j.cemconres.2015.08.009 ↗
38. Potentiostatic transient technique, a simple approach to estimate the corrosion current density and Stern-Geary constant of reinforcing steel in concrete10.1016/j.cemconres.2010.04.006 ↗
39. J.A. Gonzalez, A. Molina, M. Escudero, M.C. Andrade, A comparison of linear polarization and alternating current impedance in the determination of corrosion rates of reinforcements, in: Proc conf Corrosion/85, paper 257, NACE, ed., Boston, Massachusetts, 1985.10.5006/C1985-85257 ↗
40. Effect of surface condition on the initial corrosion of galvanized reinforcing steel embedded in concrete10.1016/j.corsci.2008.06.035 ↗
41. Stability of the calcium hydroxyzincate protective layer developed on galvanized reinforcements after a further increase of the pH value10.3989/mc.1986.v36.i204.882 ↗
42. ASTM G1, Standard Practice for Preparing, Cleaning, and Evaluating Corrosion Test Specimens, Annual Book of ASTM Standards, vol. 03.02, 2011.
43. Corrosion rate monitoring in the laboratory and on-site10.1016/0950-0618(95)00044-5 ↗
44. Corrosion film breakdown of galvanized steel in sulphate-chloride solutions10.1016/j.conbuildmat.2014.05.053 ↗
45. Corrosion behavior of galvanized steel due to typical soil organics10.1016/j.conbuildmat.2015.11.009 ↗
46. Corrosion of hot-dip galvanized steel reinforcement
47. Corrosion of galvanised steel under an electrolytic drop10.1016/j.corsci.2006.05.027 ↗
48. Corrosion monitoring of galvanised coatings through electrochemical impedance spectroscopy10.1016/j.corsci.2008.02.010 ↗
49. The influence of w/c ratio, concrete cover thickness and degree of water saturation on the corrosion rate of reinforcing steel in concrete10.1016/S0008-8846(96)85013-7 ↗
50. Corrosion resistance of galvanized steel reinforcements in carbonated concrete: effect of wet-dry cycles in tap water and in chloride solution on the passivating layer10.1016/j.cemconres.2014.07.014 ↗
51. The presentation of the chloride threshold level for corrosion of steel in concrete10.1016/S0010-938X(97)00009-7 ↗
52. Corrosion initiation of reinforced concretes based on Portland or GGBS cements: chloride contents and electrochemical characterizations versus time10.1016/j.cemconres.2012.07.004 ↗
53. Effect of chloride ions on the corrosion of galvanized steel embedded in concrete prepared with cements of different composition10.1016/S1452-3981(23)07741-6 ↗
54. Corrosion behavior in concrete of three differently galvanized steel bars10.1016/j.cemconcomp.2006.01.011 ↗
55. Corrosion behaviour of dual-phase and galvanized steels in concrete10.1108/00035591211224672 ↗