journal article·2018-06

Structural behavior of corroded reinforced concrete beams under sustained loading

Weiping Zhang, Hongfei Zhang, Xianglin Gu, Wei Liu

Publisher page

Abstract

Abstract This paper presents the results of an experimental study designed to investigate the combined effects of corrosion and sustained loads on the structural performance of reinforced concrete beams. A total of eight RC beams, including both uncorroded beams and corroded ones accelerated by the impressed current method, were tested. All the beams were subjected to a four-point sustained bending load which was equivalent to 17%, 33% or 50% of the designed ultimate load, respectively. Corrosion degree, crack patterns, crack width and mid-span deflection of the beams were monitored during the test. The results showed that reinforcement corrosion had no obvious effect on the transverse crack spacing and a slight effect on the development of transverse crack width for the beams under simultaneous loading and corrosion. A higher load level and a lower current density allow for more sufficient oxidation of corrosion products with a larger volume expansion rate, leading to premature initiation and rapid propagation of corrosion cracking, and more obvious deflection development of RC beams. For a beam under simultaneous loading and reinforcement corrosion, the effect of reinforcement corrosion on its deflection cannot be ignored, because it may exceed creep effect at a relatively low corrosion degree.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Concrete Corrosion and Durability · Corrosion Behavior and Inhibition · Concrete and Cement Materials Research

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (16)

Show source-provided references
1. Mehta · 1994
2. Deterioration of concrete due to reinforcement steel corrosion10.1016/0958-9465(95)00043-7 ↗
3. Flexural strength of concrete beams with corroding reinforcement
4. Residual flexure capacity of corroded reinforced concrete beams10.1016/j.engstruct.2006.07.018 ↗
5. Deflection of RC beams under simultaneous load and steel corrosion10.1680/macr.2001.53.3.171 ↗
6. Effects of reinforcement configuration and sustained load on the behaviour of reinforced concrete beams affected by reinforcing steel corrosion10.1016/j.cemconcomp.2012.07.010 ↗
7. Factors controlling cracking of concrete affected by reinforcement corrosion10.1007/BF02480466 ↗
8. On-site measurements of corrosion rate of reinforcements10.1016/S0950-0618(00)00063-5 ↗
9. Effectiveness of impressed current technique to simulate corrosion of steel reinforcement in concrete10.1061/(ASCE)0899-1561(2003)15:1(41) ↗
10. Long-term performance of corrosion-damaged reinforced concrete beams
11. Behaviour of RC beams corroded under sustained service loads10.1016/j.conbuildmat.2009.06.005 ↗
12. Interaction between corrosion crack width and steel loss in RC beams corroded under load10.1016/j.cemconres.2010.03.010 ↗
13. ASTM. ASTM G1-03(2011) Practice for Preparing, Cleaning, and Evaluating Corrosion Test Specimens.
14. In situ observation of initial rust formation process on carbon steel under Na2SO4 and NaCl solution films with wet/dry cycles using synchrotron radiation X-rays10.1016/j.corsci.2004.10.021 ↗
15. Composition and expansion coefficient of rust based on X-ray diffraction and thermal analysis10.1016/j.corsci.2011.01.007 ↗
16. Longitudinal strains and stiffness of RC beams under load as measures of corrosion levels10.1016/j.engstruct.2011.11.021 ↗