Influence new-to-old concrete interface qualities on the behaviour of support zones of composite concrete beams
Source abstract
Abstract
Abstract The paper describes the investigations of concrete composite units consisting of two concrete parts. In each test series the interface was differently arranged and characterised by different strength parameters. They were: non-reinforced interface with existing adhesion, reinforced interface with existing adhesion and reinforced interface with broken adhesion. Simply-supported beams were subjected to four point bending. The failure of all beams was the result of exceeding the shear resistance of the support zones, but the cracks pattern in each series was different. The paper presents the results of the tests, in particular: deflection, stresses in the longitudinal and transverse reinforcement and strains of concrete. The distribution of strains along the height of the beam and the slip between the connected parts are also described. On the basis of these data a classification of failure mechanisms of concrete composite beams is proposed, as well as the analytical criteria allowing to predict failure manner of a composite beam.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Structural Engineering and Materials Analysis · Structural Behavior of Reinforced Concrete · Innovative concrete reinforcement materials
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (14)
Show source-provided references
1. Eurocode 2: design of concrete structures – part 1-1: general rules of buildings EN 1992-1-1; 2003 [final draft].
2. DIN 1045-1 (Ausgabe Juli 2001). Tragwerke aus Beton, Stahlbeton und Spannbeton. Teil 1: Bemessung und Konstruktion in German).
3. Cooperation of two concretes in composite beams
4. Bond strength between sealed bridge decks and concrete overlays
5. Proposed theory to determine the horizontal shear between composite precast and in situ concrete10.1016/S0958-9465(00)00050-0 ↗
6. Grabias M. Influence of expansive concrete on the bearing capacity of support zone in concrete composite structures. PhD Thesis. Lublin University of Technology; 2001.
7. Halicka · 2007
8. Nachträglich ergänzte Querschnitte mit horizontaler Fuge nach DIN 1045-110.1002/best.200301450 ↗
9. Priebe H, Szumocki J. Cooperation of two concretes in composite concrete beams. In: Proceedings of first scientific conference ‘composite structures’. Technical University of Zielona Góra; 1986. p. 135–42 [in Polish].
10. Rżanicyn · 1982
11. Sadowska-Buraczewska B. Bearing capacity and deformability of composite concrete beams with HPC. PhD Thesis. Bialystok University of Technology; 2004.
12. Schäfer HG, Schmidt-Kehle W. Schubdeckung und Fugenverbund bei nachträglich durch Ortbeton ergänzten Ferigteilplatten und Fertigteilbalken. Beton- und Stahlbetonbau 90, Heft 2/1995; p. 49–53 [in German].10.1002/best.199500080 ↗
13. Horizontal shear strength of indirectly loaded composite concrete beams
14. Structural upgrading of RC beams using composite overlays10.1016/S0950-0618(00)00042-8 ↗