Experimental study on hygrothermal characteristics of coral sand aggregate concrete and aerated concrete under different humidity and temperature conditions
Source abstract
Abstract
Abstract In the low-latitude isolated island area, coral sand concrete (CSC) is gradually replacing aerated concrete (AC) due to its advantages of easy access to raw materials and good durability. This paper studies the hygrothermal characteristics of CSC and AC through experiments. The experiments analyzed the change in thermal conductivity of material in the dry state (within the temperature range of −20 to 50 °C) and the influence of humidity on thermal conductivity of material (at 25 °C and 35 °C, within the humidity range of 0–100%). At the same time, the water absorption coefficient and the sorption isotherms were obtained. The results show that the thermal conductivity is only slightly affected by temperature and does not increase monotonically with the increase in temperature. The change in thermal conductivity with relative humidity can be divided into three stages and can be fitted to a polynomial function. The effect of humidity on AC’s thermal conductivity is more obvious than that of CSC, which is positively correlated with the hygroscopicity and porosity of the material. When the relative humidity changes from 0% to 100%, the thermal conductivities of CSC and AC increase by 39.25% and 89.35%, respectively.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Hygrothermal properties of building materials · Building materials and conservation · Masonry and Concrete Structural Analysis
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (53)
Show source-provided references
1. Study of compressive strength characteristics of coral aggregate concrete10.1680/macr.1996.48.176.141 ↗
2. Coral concrete at bikini atoll
3. Mechanical properties and microstructure of Portland cement concrete prepared with coral reef sand10.1007/s11595-016-1481-x ↗
4. Birkeland · 1997
5. Physical and mechanical properties of coral sand in the Nansha islands
6. The corrosion investigation of rebar embedded in the fibers reinforced concrete10.1016/j.conbuildmat.2012.04.051 ↗
7. A study on chloride ion diffusivity of porous aggregate concretes and improvement method10.2208/jsceje.65.30 ↗
8. Effects of fly ash, blast furnace slag and metakaolin on mechanical properties and durability of coral sand concrete10.1016/j.clay.2017.02.026 ↗
9. Durability and microstructure of coral sand concrete incorporating supplementary cementitious materials10.1016/j.conbuildmat.2018.03.082 ↗
10. Development of properties and microstructure of concrete with coral reef sand under sulphate attack and drying-wetting cycles10.1016/j.conbuildmat.2018.01.085 ↗
11. Experimental study on the thermal properties of lightweight aggregate concretes at different moisture contents and ambient temperatures10.1016/j.conbuildmat.2017.06.087 ↗
12. Hygric, thermal and durability properties of autoclaved aerated concrete10.1016/j.conbuildmat.2012.12.036 ↗
13. Moisture content influence on the thermal conductivity and diffusivity of wood-concrete composite10.1016/j.conbuildmat.2013.06.067 ↗
14. Nonlinear effect of moisture content on effective thermal conductivity of building materials with different pore size distributions10.1007/s10765-016-2062-0 ↗
15. Evaluation of thermal conductivity for thermally insulated concretes10.1016/j.enbuild.2013.01.043 ↗
16. Evaluation of thermal conductivity, mechanical and transport properties of lightweight aggregate foamed geopolymer concrete10.1016/j.enbuild.2013.12.029 ↗
17. The effects of pumice aggregate/cement ratios on the low-strength concrete properties10.1016/j.conbuildmat.2007.01.030 ↗
18. Investigation of properties of low-strength lightweight concrete for thermal insulation10.1016/j.buildenv.2005.09.024 ↗
19. Elevated-temperature thermal properties of lightweight foamed concrete10.1016/j.conbuildmat.2010.07.016 ↗
20. The combined effect of heat and moisture transfer dependent thermal conductivity of polystyrene insulation material: Impact on building energy performance10.1016/j.enbuild.2018.03.055 ↗
21. Effect of thermal conductivity change of moist fibrous insulation on energy performance of buildings under hot-humid conditions10.1016/j.enbuild.2013.01.035 ↗
22. The impact of the temperature dependent thermal conductivity of insulating materials on the effective building envelope performance10.1016/j.enbuild.2017.03.052 ↗
23. Temperature dependence of sorption isotherm of hygroscopic building materials. Part 1: Experimental evidence and modeling10.1016/j.enbuild.2016.12.082 ↗
24. Influence of temperature on water vapour sorption isotherms and kinetics of hardened cement paste and concrete10.1016/j.cemconres.2016.11.006 ↗
25. Heat and mass transfer between indoor air and a permeable and hygroscopic building envelope: part I Field measurements10.1177/1097196304044395 ↗
26. Performance evaluation of indirect evaporative cooling using whole-building hygrothermal simulations10.1016/j.applthermaleng.2009.02.004 ↗
27. The effect of combining a relative-humidity-sensitive ventilation system with the moisture-buffering capacity of materials on indoor climate and energy efficiency of buildings10.1016/j.buildenv.2008.04.017 ↗
28. Thermal conductivity of reference solid materials10.1023/B:IJOT.0000028477.74595.d5 ↗
29. A new methodology for determining water absorption of lightweight, normal-weight and heavyweight aggregates in a viscous medium10.1016/j.conbuildmat.2018.01.025 ↗
30. The drying potential and risk for mold growth in compact wood frame roofs with built-in moisture10.1177/1744259109351441 ↗
31. Impact of wind-driven rain on historic brick wall buildings in a moderately cold and humid climate: numerical analyses of mould growth risk, indoor climate and energy consumption10.1016/j.enbuild.2008.07.011 ↗
32. The effects of structures on indoor humidity – Possibility to improve comfort and perceived air quality10.1034/j.1600-0668.2002.01128.x ↗
33. Effect of moisture content on heat and moisture transport and storage properties of thermal insulation materials10.1016/j.enbuild.2012.07.002 ↗
34. Moisture hysteresis influence on mass transfer through bio-based building materials in dynamic state10.1016/j.enbuild.2018.01.067 ↗
35. Characterization of flax lime and hemp lime concretes: Hygric properties and moisture buffer capacity10.1016/j.enbuild.2014.11.043 ↗
36. Water absorption and electrical resistivity of concrete with recycled concrete aggregates and fly ash10.1016/j.cemconcomp.2018.10.004 ↗
37. Predicting the initial rate of water absorption in clay bricks10.1016/j.conbuildmat.2009.01.009 ↗
38. Water absorption of carbonated reactive MgO concrete and its correlation with the pore structure10.1016/j.jcou.2018.01.026 ↗
39. Effect of moisture and temperature on thermal properties of three bio-based materials10.1016/j.conbuildmat.2016.02.061 ↗
40. ISO 8302, Thermal insulation; determination of steady-state thermal resistance and related properties; guarded hot plate apparatus, 1991.
41. Rapid thermal conductivity measurement with a hot disk sensor: Part 1. Theoretical considerations10.1016/j.tca.2005.06.026 ↗
42. Thermal conductivity measurements on wood materials with transient plane source technique10.1016/j.tca.2014.11.021 ↗
43. Experimental study on the effects of humidity and temperature on aerogel composite and foam insulations10.1016/j.enbuild.2017.03.070 ↗
44. Water vapor adsorption in porous building materials: experimental measurement and theoretical analysis10.1007/s11242-011-9884-9 ↗
45. GB/T20312, Hygrothermal performance of building materials and products – Determination of hygroscopic sorption properties, 2006.
46. Strength and permeability properties of self-compacting concrete with cold bonded fly ash lightweight aggregate10.1016/j.conbuildmat.2014.10.032 ↗
47. ASTM C1794. Standard Test Methods for Determination of the Water Absorption Coefficient by Partial Immersion. 2015.
48. Standard reference data for the thermal conductivity of water10.1063/1.555963 ↗
49. Determination d'un réseau aleatoire de pores pour modéliser la sorption et la migration d'humidité dans un mortier de ciment10.1016/0017-9310(91)90219-5 ↗
50. Influence of the volume fraction and the nature of fine lightweight aggregates on the thermal and mechanical properties of structural concrete10.1016/j.conbuildmat.2013.11.019 ↗
51. Influence of volume fraction and characteristics of lightweight aggregate concrete on the mechanical properties of concrete10.1016/j.conbuildmat.2009.02.038 ↗
52. Hygrothermal characteristics of aerogel-enhanced insulating materials under different humidity and temperature conditions10.1016/j.enbuild.2017.09.079 ↗
53. Water sorption isotherms of some building materials10.1081/DRT-200047948 ↗