journal article·2020-01

Out-of-plane bending of masonry wallette strengthened with geosynthetic

Hasim Ali Khan, Radhikesh Prasad Nanda

Publisher page

Abstract

Abstract The out-of-plane flexural strength of masonry wallettes with different strengthening patterns using geotextile was studied experimentally and numerically. Three different patterns viz. parallel, diagonal and cross were used as strengthening of the wallettes on both sides. From the experimental study, it has been ascertained that strengthening using geosynthetic enhanced the load-carrying, displacement, stiffness, ductility, flexural strength and energy dissipation capacity remarkably being the greatest effect achieved using the cross pattern. Finite element ANSYS non-linear micro modelling is carried out to predict the out-of-plane performance of masonry wallettes before and after strengthening. It was also observed less brittle behaviour in comparison to the wallette without strengthening. Therefore, geosynthetic can be suitable for strengthening of the masonry buildings against out-of-plane bending during an earthquake due to low cost, ready availability and high strength.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Masonry and Concrete Structural Analysis · Building materials and conservation · Hygrothermal properties of building materials

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (46)

Show source-provided references
1. Base isolation by geosynthetic for brick masonry buildings10.1177/1077546311412411 ↗
2. In-plane shear and out-of-plane bending capacity interaction in brick masonry walls
3. Free · 2008
4. R. Angel, D. Abrams, D. Shapiro, J. Uzarski, M. Webster, Behavior of reinforced concrete Frames with Masonry Infills, Civil Engineering Studies, Structural Research Series no. 589, University of Illinois, 2009. https://www.ideals.illinois.edu/bitstream/handle/2142/14210/SRS-589.pdf?sequence=2&isAllowed=y.
5. S.A. Hashemi, K.M. Mosalam, Seismic evaluation of reinforced concrete buildings including effects of masonry infill walls, Pacific Earthquake Engineering Research Center, PEER 2007/100. https://nees.org/data/get/NEES-2006-0135.groups/Documentation/Hashemi%20Mosalam-Seismic%20evaluation%20of%20reinforced%20concrete%20buildings%20including%20effects%20of%20masonry%20infill%20walls_PEER%202007-100.pdf.
6. Simple-lower-bound-limit-analysis-homogenization-model-for-in-and-out-of-plane-loaded-masonry-walls10.1016/j.conbuildmat.2011.01.012 ↗
7. Out-of-plane maximum resisting bending moment of masonry walls strengthened with FRCM composites10.1016/j.compstruct.2018.04.054 ↗
8. Simple numerical model with second order effects for out-of-plane loaded masonry walls10.1016/j.engstruct.2012.08.029 ↗
9. An explicit finite element modelling method for masonry walls under out-of-plane loading10.1016/j.engstruct.2016.01.026 ↗
10. Validation of analytical multiparameter homogenization models for out-of-plane loaded masonry walls by means of the finite element method
11. Numerical modeling of FRP strips bonded to a masonry substrate10.1016/j.compstruct.2018.05.119 ↗
12. Out-of-plane strength of unreinforced masonry infill panels10.1193/1.1585912 ↗
13. Seismic behavior of framed masonry panels with prior damage when subjected to out-of-plane loading10.1193/1.3651624 ↗
14. Earthquake Tips, Learning earthquake design and construction, National information centre of earthquake engineering, IIT Kanpur, 2005. https://tnsdma.tn.gov.in/app/webroot/img/document/library/06-Earth-Quake-Tips.pdf.
15. A critical review of retrofitting methods for unreinforced masonry structures
16. Damaged masonry walls in two-way bending retrofitted with vertical FRP strips10.1016/j.conbuildmat.2007.09.007 ↗
17. Out-of-plane flexural behavior of unreinforced red brick walls strengthened with FRP composites10.1016/j.compositesb.2006.07.019 ↗
18. Seismic retrofitting of unreinforced brick masonry panels with glass fibre reinforced polymers10.4018/IJGEE.2017010102 ↗
19. Load capacity of concrete masonry block walls strengthened with epoxy-bonded GFRP sheets10.1177/0021998305051119 ↗
20. Out-of-plane testing of unreinforced masonry walls strengthened using ECC shotcrete10.1016/j.istruc.2016.04.005 ↗
21. Out-of-plane flexural strengthening of URM wallettes using basalt fibre reinforced polymer composite10.1016/j.conbuildmat.2019.04.268 ↗
22. Out-of-plane flexural behaviour of masonry wallettes strengthened using FRP composites and externally bonded grids: comparative study10.1016/j.compositesb.2019.107302 ↗
23. FRCM strengthening of clay brick walls for out of plane loads
24. S. Maxwell, W. Kim, T. B. Edil, C. H. Benson, Effectiveness of geosynthetics in stabilizing soft subgrades. Final Rep. No. 0092- 45-15, Dept. of Civil and Environmental Engineering, Univ. of Wisconsin-Madison, Madison, WI. (2005). http://digital.library.wisc.edu/1793/53969.
25. In-plane strength of masonry panel strengthened with geosynthetic10.1016/j.conbuildmat.2017.08.169 ↗
26. Flexural and shear behavior of geo-grid confined RC beams with steel fiber reinforced concrete10.1016/j.conbuildmat.2015.01.021 ↗
27. IS: 3495 (Parts 1 to 4): Methods of tests of burnt clay building bricks, 1992. http://www.iitk.ac.in/ce/test/IS-codes/is.3495.1-4.1992.pdf.
28. American Society for Testing and Materials, ASTM C109/C 109M: Standard test method for compressive strength of hydraulic cement mortars, 1999. DOI: 10.1520/C0109_C0109M-16A.10.1520/C0109_C0109M-16A ↗
29. American Society for Testing and Materials, ASTM C1006/C1006M: Standard test method for splitting tensile strength of masonry units, 1984. DOI: 10.1520/C1006_C1006M-19.10.1520/C1006_C1006M-19 ↗
30. Geotextiles: production, properties and performance10.1080/00405160903509803 ↗
31. American Society for Testing and Materials, ASTM D4595-17: Standard test method for tensile properties of geotextiles by the wide-width strip method, 2017. DOI: 10.1520/D4595-17.10.1520/D4595-17 ↗
32. Diagonal compression testing of FRP-retrofitted unreinforced clay brick masonry wallettes10.1061/(ASCE)CC.1943-5614.0000209 ↗
33. Shear behavior of masonry panels strengthened by FRP laminates10.1016/S0950-0618(02)00043-0 ↗
34. Experimental response of double-wythe masonry panels strengthened with glass fibre reinforced polymers subjected to diagonal compression tests10.1016/j.engstruct.2012.01.018 ↗
35. American Society for Testing and Materials, ASTM E518/E518M: Standard Test Method for determination of the flexural bond strength of unreinforced masonry panels in Masonry Assemblages, 2002. DOI: 10.1520/E0518_E0518M-15.10.1520/E0518_E0518M-15 ↗
36. Experimental investigation of out-of-plane behaviour of URM wallettes strengthened using welded wire mesh10.1016/j.conbuildmat.2018.09.176 ↗
37. ANSYS WORKBENCH. 2018. WORKBENCH user’s manual release 18.0. USA. Canonsburg (PA): ANSYS Inc.
38. A coupled homogenisation-damage model for masonry cracking10.1016/j.compstruc.2004.02.020 ↗
39. Influence of reinforcement on the behavior of hollow concrete blocks masonry prism under compression – an experimental and analytical approach
40. Stress-strain characteristics of clay brick masonry under uniaxial compression10.1061/(ASCE)0899-1561(2007)19:9(728) ↗
41. ECP 204-2005, Egyptian Code for Design and Construction of Masonry Structures, Ministry of Housing and Urban Communities, Egypt, 2005.
42. Analysis of factors affecting ultimate load of concrete based on ANSYS
43. Numerical simulation of masonry structures based on ANSYS contact analysis
44. Effect of mortar joint thickness on the compressive strength of autoclaved flyash–lime brick masonry
45. Study on out-of-plane behaviour of unreinforced masonry strengthened with welded wire mesh and mortar10.1016/j.conbuildmat.2017.03.002 ↗
46. Strength characteristic of novel mesh embedment technique for new brick construction with least expensive material10.1016/j.engstruct.2018.10.062 ↗