Bond behaviour of FRP strips glued on masonry: Experimental investigation and empirical formulation
Source abstract
Abstract
Abstract This paper investigates the bond behaviour of carbon and glass fibre reinforced polymers (FRPs) glued on various kinds of masonry supports. It presents the results of a wide experimental campaign carried out at the Laboratory of Structures of the University of Salerno (Italy). Four different types of masonry were considered. Clay-bricks as well as some natural masonry elements (i.e., tuff or limestone, that are rather common for existing buildings in the Mediterranean Area) were employed as supports for gluing FRP sheets and perform double-shear pull-out tests. A preliminary experimental work was carried out on samples of the above mentioned masonry blocks for quantifying their key mechanical properties. Thus, a wide series of masonry specimens were tested both in compression and bending for evaluating their compressive and tensile strength and determining the key statistical parameters which describe their distribution and scatter. Then, 29 double-shear pull-out tests were carried out for observing the bond behaviour of FRP strips on the various masonry substrates. Moreover, two sets of six coupon tests were performed for evaluating the actual axial stiffness of FRP plates glued on masonry samples. The paper reports the key results of the above mentioned tests with the aim of pointing out the influence of the various relevant parameters of both masonry and composite materials on the resulting bond strength. A significant influence of masonry properties was observed and quantified, whereas no significant effect induced by the two different kinds of composite materials were actually observed. The above mentioned experimental results are employed for assessing the theoretical formula adopted by Italian Guidelines for evaluating ultimate bond strength of composite laminates glued on masonry. Finally, an alternative fully empirical relationship is calibrated on pull-out test results presented in this paper.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Structural Behavior of Reinforced Concrete · Masonry and Concrete Structural Analysis · Concrete Corrosion and Durability
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (25)
Show source-provided references
1. EN 1996-1-1:2005. Design of masonry structures – Part 1-1: General rules for buildings – rules for reinforced and unreinforced masonry.
2. EN 1998-1:2004. Eurocode 8. Design of structures for earthquake resistance. General rules, seismic actions and rules for buildings.
3. Shear strengthening masonry panels with sheet glass-fiber reinforced polymer10.1061/(ASCE)1090-0268(2004)8:5(434) ↗
4. Shear behavior of masonry panels strengthened by FRP laminates10.1016/S0950-0618(02)00043-0 ↗
5. Shear capacity of masonry walls externally strengthened by a cement-based composite material: an experimental campaign10.1016/j.conbuildmat.2009.08.019 ↗
6. Masonry columns confined by composite materials: experimental investigation10.1016/j.compositesb.2011.02.001 ↗
7. Strengthening of masonry arches with fiber-reinforced polymer strips10.1061/(ASCE)1090-0268(2004)8:3(191) ↗
8. Experimental behavior of FRP strengthened masonry arches10.1061/(ASCE)CC.1943-5614.0000086 ↗
9. Reduction of the lateral thrust of masonry arches and vaults with FRP composites10.1016/j.conbuildmat.2006.07.009 ↗
10. Motavalli M, Czaderski C. FRP composites for retrofitting of existing civil structures in Europe: state-of-the-art review. In: Proceedings of the American composites manufacturers association 2007, ISBN, Tampa, FL (USA). Arlington, VA 22201, USA: American Composites Manufacturers Association (ACMA); 2007. .
11. Strengthening of masonry structures using epoxy-bonded FRP laminates10.1061/(ASCE)1090-0268(1998)2:2(96) ↗
12. Strengthening techniques tested on masonry structures struck by the Umbrian–Marche earthquake of 1997–199810.1016/S0950-0618(02)00014-4 ↗
13. American Concrete Institute. ACI 440.7R-10: guide for the design and construction of externally bonded fiber-reinforced polymer systems for strengthening unreinforced masonry structures; April 2010.
14. CNR DT 200. Instructions for design, execution and control of strengthening interventions by means of fibre-reinforced composites, Italian National Research Council; 2004.
15. Bond analysis of masonry structures strengthened with CFRP sheets10.1016/j.conbuildmat.2005.06.040 ↗
16. Bond behaviour of CFRP laminates glued on clay bricks: experimental and numerical study10.1016/j.compositesb.2010.09.020 ↗
17. Experimental bond behavior of FRP sheets glued on brick masonry10.1061/(ASCE)CC.1943-5614.0000147 ↗
18. Bond behaviour of FRP-to-clay brick masonry joints10.1016/j.engstruct.2009.06.006 ↗
19. Experimental study on FRP-to-concrete bonded joints10.1016/j.compositesb.2004.06.001 ↗
20. Mapei. MapeWrap C Uni-Ax, high strength uni-directional carbon fibre fabric with high and very high modulus of elasticity; 2010. [accessed 06.01.11].
21. Mapei. MapeWrap G Uni-Ax, unidirectional glass fibre fabrics; 2010. [accessed 06.01.11].
22. Mapei. MapeWrap 31, Medium viscosity epoxy resin for impregnation of MapeWrap with “dry systems; 2010. [accessed 06.01.11].
23. Strengthening of concrete prisms using the plate-bonding technique10.1007/BF00013161 ↗
24. Nist/Semantech. e-Handbook of statistical methods; 2003. [accessed 06.01.11].
25. EN 1990. Basis of structural design; 2002.