journal article·2019-04

Creep behavior of steel fiber reinforced reactive powder concrete at high temperature

Muhammad Abid, Xiaomeng Hou, Wenzhong Zheng, Raja Rizwan Hussain, Shaojun Cao, Zhihao Lv

Publisher page

Abstract

Abstract Reactive powder concrete (RPC) shows a great application potential owing to its superior strength and excellent durability. However, creep behavior at high temperature is a major concern, as scanty information is available in the past literature. Therefore, the aim of this paper is to investigate the creep behavior of RPC at high temperature. Creep behavior is further segregated into free thermal strain, short-term creep and transient strain based on different thermo-mechanical regimes. Steady-state thermal and loading conditions and transient thermal and loading conditions were considered. Tests were carried out from 10 to 60% stress level of ambient and high-temperature compressive strength ratios and up to target temperature of 900 °C. The result shows that short-term creep of RPC increases considerably above 500 °C and the increase under the same loading ratios at 700 and 900 °C is approximately 13 and 23 times as that of short-term creep at 120 °C, respectively. Furthermore, increased stress level also triggered the short-term creep within the same target temperature. The evolution of free thermal strain and transient strain were slow below 250 °C. However, at higher temperature, the increase in strain rate becomes noticeable. It was found that heating rate has a direct influence on the expansion of RPC. On the other hand, transient strain was not affected by increasing heating rate from 3 to 5 °C/min. Finally, fitting equations were proposed which will be useful in fire safety design of RPC structures in computer programmes.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Fire effects on concrete materials · Innovative concrete reinforcement materials · Advanced ceramic materials synthesis

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (53)

Show source-provided references
1. Reactive powder concretes with high ductility and 200–800 MPa compressive strength
2. Effects of steel fiber and strain rate on the dynamic compressive stress-strain relationship in reactive powder concrete10.1016/j.conbuildmat.2018.03.101 ↗
3. Development of ultra-high performance engineered cementitious composites using polyethylene (PE) fibers10.1016/j.conbuildmat.2017.10.040 ↗
4. The effect of high temperature on reactive powder concrete10.1016/j.conbuildmat.2014.07.097 ↗
5. Effects of high-pressure/temperature curing on reactive powder concrete microstructure formation10.1016/j.conbuildmat.2015.12.147 ↗
6. Mechanical properties of reactive powder concrete containing mineral admixtures under different curing regimes10.1016/j.conbuildmat.2008.08.003 ↗
7. A review on ultra high performance concrete: Part II. Hydration, microstructure and properties10.1016/j.conbuildmat.2015.08.095 ↗
8. D. Bierwagen, A. Abu-Hawash, Ultra high performance concrete highway bridge, in: Proceedings of the 2005 Mid-Continent Transportation Research Symposium, Ames, Iowa, 2005, pp. 1–14.
9. B. Graybeal, Fabrication of an optimized UHPC bridge, in: Proceedings of PCI National Bridge Conference, Atlanta, GA, USA, 2004.
10. High temperature behaviour of hybrid steel–PVA fibre reinforced reactive powder concrete10.1617/s11527-015-0537-2 ↗
11. Literature review of reactive powder concrete
12. Thermal and mechanical properties at high temperature of a very high-strength durable concrete10.1061/(ASCE)MT.1943-5533.0000058 ↗
13. High temperature and residual properties of reactive powder concrete–A review10.1016/j.conbuildmat.2017.04.083 ↗
14. Effect of fire insulation on fire resistance of hybrid-fiber reinforced reactive powder concrete beams10.1016/j.compstruct.2018.10.073 ↗
15. 129-MHT, “Test Method for Mechanical Properties of Concrete at High Temperatures: Part 6–Thermal Strain”
16. 129-MHT, “Test Methods for Mechanical Properties of Concrete at High Temperatures: Part 8 Steady-State Creep and Creep Recovery for Service and Accident Conditions”10.1007/BF02481690 ↗
17. Test methods for mechanical properties of concrete at high temperatures. Recommendations: Part 7: Transient creep for service and accident conditions10.1007/BF02480669 ↗
18. Anderberg · 1976
19. Strain of concrete during first heating to 600 C under load10.1680/macr.1985.37.133.195 ↗
20. Numerical modeling of the behavior of concrete structures in fire
21. Z. Guo, X. Shi, Experiment and Calculation of Reinforced Concrete at Elevated Temperatures, Elsevier, 2011, pp. 17-55 (Chapter 2 and 3).10.1016/B978-0-12-386962-3.10002-6 ↗
22. Creep Behavior of high-strength concrete with olypropylene fibers at elevated temperatures
23. Experimental research on the transient thermal strain of high strength concrete at elevated temperature
24. Transient strain of self-compacting concrete loaded in compression heated to 700 C10.1617/s11527-012-9894-2 ↗
25. Transient thermal creep of concrete in accidental conditions at temperatures up to 400 C10.1680/macr.2006.58.4.201 ↗
26. Effect of high temperature creep on the fire response of restrained steel beams10.1617/s11527-010-9583-y ↗
27. Quantifying transient creep effects on fire response of reinforced concrete columns10.1016/j.engstruct.2018.07.093 ↗
28. Effect of transient creep on the behaviour of reinforced concrete columns in fire10.1016/j.engstruct.2009.04.005 ↗
29. Effect of transient creep on behavior of reinforced concrete beams in a fire
30. Effect of high-temperature transient creep on response of reinforced concrete columns in fire10.1617/s11527-016-0903-8 ↗
31. Compressive and tensile properties of reactive powder concrete with steel fibres at elevated temperatures10.1016/j.conbuildmat.2012.12.066 ↗
32. Monotonic and cyclic behavior of high-strength concrete with polypropylene fibers at high temperature
33. Mechanical properties of steel fiber reinforced reactive powder concrete following exposure to high temperature reaching 800 C10.1016/j.nucengdes.2011.04.008 ↗
34. Mechanical properties, short time creep, and fatigue of an austenitic steel10.3390/ma9040298 ↗
35. Short-term creep of concrete at elevated temperatures10.1002/fam.810050403 ↗
36. Effect of fibers on high-temperature mechanical behavior and microstructure of reactive powder concrete10.3390/ma12020329 ↗
37. Compressive strength of concrete at temperatures to 1600F
38. Experimental determination of mechanical properties and short-time creep of AISI 304 stainless steel at elevated temperatures10.1007/s12613-010-0107-0 ↗
39. Graybeal · 2005
40. Basic creep of unsealed hardened cement paste at temperatures between 20 C and 725 C10.1680/macr.1987.39.139.93 ↗
41. Creep behavior of high-strength concrete with Nylon fibers at elevated temperatures10.4334/JKCI.2011.23.5.627 ↗
42. Heat deformations of cement paste phases and the microstructure of cement paste
43. U. Schneider, U. Diederichs, Detection of cracks by mercury penetration measurements, Fracture Mechanics of Concrete, Elsevier Science Publishers, Amsterdam, 1983, pp. 207–222.
44. Short-term thermal creep model of concrete based on experiments
45. G. Khoury, Y. Anderberg, K. Both, J. Fellinger, N. Høj, C. Majorana, Fib bulletin 38: fire design of concrete structures—materials, structures and modelling, state-of-the art report, Federation internationale du beton, Lausanne, Switzerland, 2007.10.35789/fib.BULL.0038 ↗
46. Experimental study of micro/macro crack development and stress–strain relations of cement-based composite materials at elevated temperatures10.1016/j.cemconres.2003.08.029 ↗
47. Effect of temperature on thermal properties of different types of high-strength concrete10.1061/(ASCE)MT.1943-5533.0000225 ↗
48. British Standard Institute. Eurocode 2: Design of Concrete Structures – Part 1-2: General Rules – Structural Fire Design. BS EN. 1992-1-2:2004.
49. Lie · 1992
50. Stress-induced thermal and shrinkage strains in concrete
51. Transient strain of high strength concrete at elevated temperatures and the impact of polypropylene fibers10.1617/s11527-011-9798-6 ↗
52. Concrete at high temperatures—a general review10.1016/0379-7112(88)90033-1 ↗
53. Transient creep of concrete under biaxial stress and high temperature10.1016/0008-8846(96)00114-7 ↗