journal article·2020-05

Bearing behavior and serviceability evaluation of seawater sea-sand concrete beams reinforced with BFRP bars

Yuntao Hua, Shiping Yin, Linli Feng

Publisher page

Abstract

Abstract Currently, the combination of fiber reinforced polymer (FRP) and seawater sea-sand concrete (SWSSC) is becoming a popular research topic. In this paper, the bearing behavior and serviceability evaluation of SWSSC beams reinforced with basalt FRP (BFRP) bars were studied. A total of 10 beams with lengths of 2100 mm, widths of 180 mm, and heights of 300, 250 and 350 mm were constructed. The experimental parameters included the reinforcement ratio, section height, bar diameter and bar type. The test results were discussed in terms of failure modes, bearing capacity, deflection and crack width. With an increase in the reinforcement ratio, the failure mode of the specimen transitions from tensile failure, to balance failure and ultimately to compressive failure. The flexural capacity, crack width and deflection of the FRP-SWSSC beams are much higher than that of a steel-SWSSC beam. Increasing the reinforcement ratio or the section height can increase the bending stiffness of the beam, which consequently increases the bearing capacity and reduces the strain, deflection and crack width of the beams. However, beams with similar axial stiffnesses exhibit similar flexural behaviors. BFRP bars with smaller diameters have better bonding properties with the concrete, thus reducing the crack width, while the bearing capacity and deflection are not affected. The curvature limit of 0.005/d can meet the deflection and crack width serviceability requirements of BFRP-SWSSC beams. In addition, the experimental results are compared with the existing design specifications, and at 0.3Mn, both the ACI 440.1R-15 and GB 50608-10 specifications underestimate the deflection value of the test beam, while the CSA S806-12 specification conservatively overestimates the deflection value of the beam.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Structural Behavior of Reinforced Concrete · Innovative concrete reinforcement materials · Concrete Corrosion and Durability

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (38)

Show source-provided references
1. Is gravel becoming scarce? Evaluating the local criticality of construction aggregates10.1016/j.resconrec.2017.07.016 ↗
2. Use of sea-sand and seawater in concrete construction: current status and future opportunities10.1016/j.conbuildmat.2017.08.130 ↗
3. Corrosion inhibitors for steel in concrete: state-of-the-art report10.1016/j.conbuildmat.2006.10.013 ↗
4. Combined effects of saline solution and moist concrete on long-term durability of GFRP reinforcing bars10.1016/j.conbuildmat.2012.08.021 ↗
5. Long-term durability of basalt- and glass-fiber reinforced polymer (BFRP/GFRP) bars in seawater and sea sand concrete environment10.1016/j.conbuildmat.2017.02.038 ↗
6. Fatigue behaviour of sea sand concrete beams reinforced with basalt fiber-reinforced polymer bars10.1016/j.conbuildmat.2018.05.218 ↗
7. Theoretical model for seawater and sea sand concrete-filled circular FRP tubular stub columns under axial compression10.1016/j.engstruct.2018.01.017 ↗
8. Mechanical properties of seawater sea-sand concrete reinforced with discrete BFRP-needles10.1016/j.conbuildmat.2019.02.029 ↗
9. Structural behavior of seawater sea-sand concrete shear wall reinforced with GFRP bars10.1016/j.engstruct.2019.03.101 ↗
10. GB 50608. Technical code for infrastructure application of FRP composites. Beijing: China planning press; 2010. (in Chinese).
11. ACI 440.1R-15.Guide for the design and construction of concrete reinforced with FRP bars. Farmington Hills, MI, USA: American Concrete Institute, 2015.
12. CSA S806-12.Design and construction of building structures with fibre-reinforced polymers. Canada: Canadian Standards Association, 2012.
13. Analytical and experimental flexural behavior of concrete beams reinforced with glass fiber reinforced polymers bars10.1016/j.conbuildmat.2015.03.057 ↗
14. Evaluation of the flexural strength and serviceability of geopolymer concrete beams reinforced with glass-fiber-reinforced polymer (GFRP) bars10.1016/j.engstruct.2015.08.003 ↗
15. Serviceability and ultimate load behavior of concrete beams reinforced with Basalt Fiber-Reinforced Polymer bars10.14359/51688752 ↗
16. Evaluation of flexural behavior and serviceability performance of concrete beams reinforced with FRP bars10.1061/(ASCE)CC.1943-5614.0000216 ↗
17. Flexural behavior of concrete beams reinforced with ribbed basalt-FRP bars under static loads10.1061/(ASCE)CC.1943-5614.0000752 ↗
18. Evaluation of the flexural strength and serviceability of concrete beams reinforced with different types of GFRP bars10.1016/j.engstruct.2018.06.089 ↗
19. Experimental testing of concrete bridge-deck slabs reinforced with basalt-FRP reinforcing bars under concentrated loads10.1061/(ASCE)BE.1943-5592.0000892 ↗
20. Experimental study on flexural behavior of ECC-concrete composite beams reinforced with FRP bars10.1016/j.compstruct.2018.10.026 ↗
21. Flexural behavior of partially fiber-reinforced high-strength concrete beams reinforced with FRP bars10.1016/j.conbuildmat.2017.12.003 ↗
22. Experimental study of concrete beams prestressed with basalt fiber reinforced polymers. Part I: flexural behavior and serviceability10.1016/j.compstruct.2017.01.081 ↗
23. Full-scale testing and numerical analysis of a precast fibre reinforced self-compacting concrete slab pre-stressed with basalt fibre reinforced polymer bars10.1016/j.compositesb.2017.07.004 ↗
24. Flexural properties of sea sand concrete with Basalt Fiber Reinforced Polymer (BFRP)rebar
25. Durability test on the flexural performance of seawater sea-sand concrete beams completely reinforced with FRP bars10.1016/j.conbuildmat.2018.10.166 ↗
26. Behaviors of hybrid beams composed of seawater sea-sand concrete (SWSSC) and a prefabricated UHPC shell reinforced with FRP bars10.1016/j.conbuildmat.2019.04.059 ↗
27. ASTM-11a.Standard test method for tensile properties of fiber-reinforced polymer matrix composite bars. ASTM D7205, West Conshohocken, PA, 2011.
28. ASTM D1141-98(13). Standard practice for the preparation of substitute ocean water. West Conshohocken: ASTM International, 2008.
29. Experimental testing of Basalt-Fiber-Reinforced Polymer bars in concrete beams10.1016/j.compositesb.2016.01.045 ↗
30. Structural ductility of concrete beams prestressed with FRP tendons
31. L.G. Jaeger, A.A. Mufti, G. Tadros, The concept of the overall performance factor in rectangular-section reinforced concrete members. In: Proc., 3rd int. sym. on non-metallic (FRP) reinforcement for concrete structures, vol. 2. Tokyo: Japan. Concrete Institute. (1997) 551–558.
32. CAN/CSA-S6-14. Canadian highway bridge design code. Ontario, Canada: Canadian Standard Association; 2014.
33. Equivalent moment of inertia based on integration of curvature10.1061/(ASCE)CC.1943-5614.0000164 ↗
34. Bond durability of BFRP bars embedded in concrete under seawater conditions and the long-term bond strength prediction10.1016/j.matdes.2015.12.066 ↗
35. Bond degradation of basalt fiber-reinforced polymer (BFRP) bars exposed to accelerated aging conditions10.1016/j.conbuildmat.2015.02.036 ↗
36. Suitability of sea water for mixing structural concrete exposed to a marine environment10.1016/0958-9465(95)00015-5 ↗
37. Performance of seawater-mixed concrete in the tidal environment10.1016/j.cemconres.2003.09.020 ↗
38. ISIS Canada Research Network, “Reinforced Concrete Structures with Fibre-Reinforced Polymers,” ISIS Manual No. 3, University of Manitoba, Winnipeg, MB, Canada, 2007.