journal article·2016-06

Mechanical properties of high performance self-compacting concretes at room and high temperature

A. Pineaud, P. Pimienta, S. Rémond, H. Carré

Publisher page

Abstract

Abstract The composition of Self-compacting concretes (SCCs) differs significantly from that of vibrated concretes (VCs). In particular, SCCs generally contain higher paste volumes, larger contents of mineral admixtures and often lower binder to water ratios than VCs. These specific composition parameters allow fulfilling the hard-to-please fresh state requirements of SCCs. However they could also modify significantly their mechanical behavior when concrete is submitted to high temperatures. The main objective of this paper is to study the mechanical behavior of SCCs at room and high temperature. Compressive strength, modulus of elasticity and free thermal strain of 11 self-compacting concretes (SCCs) have been studied at room and high temperature (up to 600 °C). Two series of SCCs are studied: a series in which the mixture proportions of a given concrete are changed in order to vary independently the water/binder ratio and the paste volume and a series with compositions similar to those employed in the precast industry. The variations of compressive strength and modulus of elasticity as a function of the two composition parameters studied are in good agreement with those obtained in the literature for vibrated and self compacting concretes. A relation is given to link the modulus of elasticity of SCC to its compressive strength, which is close to that proposed by ACI 363-2010. The free thermal strain of SCCs is then studied as a function of temperature. Below 300 °C, the free thermal strain of SCCs is larger than that proposed by Eurocode 2 rules for vibrated concrete. Above 300 °C, free thermal strain of SCCs lies between the values proposed by Eurocode 2 for siliceous and calcareous aggregates. The relative compressive strength determined at elevated temperature is generally lower than that proposed by Eurocode 2 for traditional vibrated concrete. The comparison of our results with those determined on several vibrated concretes shows that the obtained relative modulus of elasticity is in the same range. The influence of water to binder ratio and paste volume on these results is discussed.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Fire effects on concrete materials · Innovative concrete reinforcement materials · Concrete and Cement Materials Research

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (32)

Show source-provided references
1. Compressive strength of self-compacting concrete during high-temperature exposure10.1061/(ASCE)MT.1943-5533.0000102 ↗
2. Mechanical properties of self-compacting concrete at high temperature and after cooling
3. A study on the mechanical properties of self-compacting concrete at high temperature and after cooling10.1617/s11527-012-9839-9 ↗
4. Comparison of the hardened properties of self-compacting concrete and normal vibrated concrete
5. Hardened material properties of self-compacting concrete10.1080/13923730.2004.9636318 ↗
6. Assié · 2005
7. A comprehensive investigation into the effect of water to cement ratio and powder content on mechanical properties of self-compacting concrete10.1016/j.conbuildmat.2014.01.098 ↗
8. A comparison between mechanical properties of self compacting concrete and the corresponding properties of normal concrete10.1016/S0008-8846(00)00497-X ↗
9. Self-compacting concrete time development of material properties and bond behaviour
10. Splitting tensile strength and modulus of elasticity of self-compacting concrete10.1016/j.conbuildmat.2010.06.037 ↗
11. A review of the hardened mechanical properties of self-compacting concrete10.1016/j.cemconcomp.2006.07.010 ↗
12. Fire resistance of self-compacting concrete10.1007/BF02483286 ↗
13. Self-consolidating concrete in fire
14. The effect of aggregates concentration upon the strength and modulus of elasticity of concrete10.1680/macr.1979.31.109.225 ↗
15. Self-consolidating concrete subjected to high temperature: mechanical and physicochemical properties10.1016/j.cemconres.2009.08.001 ↗
16. NF EN 1992 · 2005
17. Recommandations RILEM CPC8 Modulus of elasticity of concrete in compression
18. Un extensomètre à béton éliminant l’influence des déformations transversales sur la mesure des déformations longitudinales
19. Relation entre formulation et quelques propriétés mécaniques des bétons à hautes performances10.1007/BF02472636 ↗
20. The effect of paste volume and of water content on the strength and water absorption of concrete10.1016/j.cemconcomp.2004.02.009 ↗
21. The effect of mix proportions and method of testing on poisson’s ratio for mortars and concretes10.1680/macr.1966.18.56.115 ↗
22. Double inclusion model for approximate elastic moduli of concrete material10.1016/0008-8846(95)00196-4 ↗
23. ACI committee 363 · 2010
24. Hager · 2004
25. Parametrical study of transient thermal strain of ordinary and high performance concrete10.1016/j.cemconres.2013.02.004 ↗
26. Impact of the polypropylene fibers on the mechanical properties of HPC concrete
27. Pimienta · 2001
28. Effect of strength on fire behavior of concrete
29. Strain components of nuclear-reactor-type concretes during first heat cycle10.1016/0029-5493(94)00969-6 ↗
30. Déformation thermiques des pâtes et des mortiers avec ajout de fumée de silice à haute température
31. Mechanical properties of HPC at high temperature
32. Effect of transient high temperature on high-strength concrete