The effect of fly ash additive on the resistance of concrete to alkali silica reaction
Source abstract
Abstract
Abstract Concrete is the most widely used construction material obtained after the setting of the mix composed course and fine aggregates, cement and water. The main properties of concrete are determined by the quality and characteristics of aggregates, w/c ratio, and the uniformity of mix compaction. Materials used: Portland cement CEM I 42.5 R, 0/4 fraction sand, 4/16 fraction gravel, fly ash, superplasticizer, and water. 7 batches of specimens were made with different fly ash content: 0%, 15%, 25%, 35%, 45%, 55%, 65% (replacing cement in the mix, %). Compressive strength and flexural strength, water absorption, density, ultrasonic pulse velocity, and alkali silica reaction resistance were tested in modified concretes against the expansion of the specimens. Concrete, where 65% of cement is replaced by fly ash, has higher density, ultrasonic pulse velocity, and lower water absorption rate. Subsequently, the expansion of modified specimens is lower. All these characteristics improve the alkali silica reaction resistance of concrete. The obtained relationship between the fly ash content in concrete mix, the change of ultrasonic pulse velocity and expansion of the specimen is used to evaluate the alkali silica reaction effect on concrete. The tests revealed that concrete modified with 65% of fly ash has better durability and alkali silica reaction resistance characteristics and can be used in construction works.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Concrete and Cement Materials Research · Recycling and utilization of industrial and municipal waste in materials production · Magnesium Oxide Properties and Applications
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (37)
Show source-provided references
1. T.R. Naik, Sustainability of concrete construction, Practice Periodical on Structural Design and Construction, vol. 13, 2008, pp. 98–103.10.1061/(ASCE)1084-0680(2008)13:2(98) ↗
2. Ingham · 2010
3. Islam · 2010
4. Review: a critical assessment to the performance of alkali-silica reaction (ASR) in concrete
5. A review on alkali-aggregate reactions in alkali-activated mortars/concretes made with alkali-reactive aggregates10.1617/s11527-014-0505-2 ↗
6. Chemical modelling of alkali silica reaction: influence of the reactive aggregate size distribution
7. Ferraris · 1995 · 1
8. V. Bocullo, A. Grinys, Betono su aktyviaisiais mineraliniais priedais šarminės korozijos tyrimas, in: 16th Conference for Junior Researchers “Science—Future of Lithuania”, vol. 16, 2013, pp. 1–8.
9. Ballard · 2008
10. Farny · 2007
11. Two-phase damage modeling of concrete affected by alkali-silica reaction under variable temperature and humidity conditions10.1016/j.ijsolstr.2012.07.015 ↗
12. Mechanism of damage for the alkali-silica reaction10.1016/j.cemconres.2005.06.003 ↗
13. Constitutive model for alkali-aggregate reactions
14. Durability of concrete with different mineral admixtures: a review
15. Pozzolana and pozzolanic cements
16. Li · 2011
17. Effects of different mineral admixtures on the properties of fresh concrete10.1155/2014/986567 ↗
18. Tokyay · 2016 · 12
19. L.R. Lenke, L.J. Malvar, Fly ash efficiency for alkali–silica reactivity (ASR) mitigation, in: Texas Section ASCE 2005 Fall Conference, El Paso, TX, October 2005.
20. Effect of fly ash on the durability properties of high strength concrete10.1016/j.proeng.2011.07.144 ↗
21. High-volume fly ash concrete with high strength and low drying shrinkage10.1061/(ASCE)0899-1561(2003)15:2(153) ↗
22. The effect of fly ash composition on the expansion of concrete due to alkali-silica reaction10.1016/S0008-8846(00)00283-0 ↗
23. ACI Education Bulletin E3-13 · 2013
24. “Reactive Solutions” Winter 2008, vol. 1(1), U.S. Department of Transportation, Federal Highway Administration, 2008, p. 3.
25. S.K. Bremseth, COIN Project report no 18, Fly ash in concrete. A literature study of the advantages and disadvantages. Sub P 4.4 Alkali aggregate reactions of concrete, 2010.
26. B.C. Dockter, Using class C fly ash to mitigate alkali-silica reactions in concrete, in: World of Coal Ash (WOCA) Conference, May 4–7, 2009 in Lexington, KY, USA, 2009.
27. Use of recycled concrete aggregate in fly-ash concrete
28. Freeze–thaw durability of concrete: ice formation process in pores10.1016/S0008-8846(98)00103-3 ↗
29. Sustainable medium-strength concrete (CS-Concrete) from coliery spoil in South Wales UK10.3846/1392-3730.2009.15.149-157 ↗
30. Modern building materials and their investigation methods10.3846/1392-3730.2009.15.129-130 ↗
31. Monitoring of concrete resistance to chloride penetration
32. Consistency of fly ash and metakaolin concrete10.3846/1392-3730.2009.15.131-135 ↗
33. Corrosion protection performance of microsilica added concretes in NaCl and seawater environments10.1016/S0950-0618(99)00016-1 ↗
34. Recycling of washed olive pomace ash for fired clay brick manufacturing10.1016/j.conbuildmat.2014.03.026 ↗
35. Concretes containing biomass ashes: mechanical, chemical, and ecotoxic performances10.1016/j.conbuildmat.2013.07.031 ↗
36. CLSM containing mixture of coal ash and a new pozzoloanic material
37. The implementation of wood waste ash as a partial cement replacement material in the production of structural grade concrete ant mortar: an overview10.1016/j.resconrec.2011.02.002 ↗