journal article·2022-01Open access

Effect of slags of different origins and the role of sulfur in slag on the hydration characteristics of cement-slag systems

Yu Zhang, Erik Schlangen, Oğuzhan Çopuroğlu

Abstract

The effect of slag of different origins (synthetic slag produced in the laboratory and commercial slag collected from different steel factories) with comparable chemical composition, amorphous content and particle size distribution, on the hydration characteristics of slag cement was investigated. In order to study the effect of sulfur in slag, a model cement paste of a C3S-slag blend was also produced. It was found that origin of slag has very little impact on the hydration process of cement-slag system. Synthetic slag shows a comparable compressive strength gain to commercial slag at 1 day, and from then on, a lower compressive strength is reached by it compared with that of commercial slag until 28 days. The sulfur in slag starts to participate in reaction after 1 day and it dominates the rate of heat release in calorimetric measurement, consistent with the result of compressive strength test. It significantly affects the elemental composition of the cementitious matrix at 7 days, and higher Al/Si and S/Ca ratios can be detected in cement-commercial slag blend at 7 days. The sulfur is involved in the formation of AFm-phase, such as calcium monosulfoaluminate, and the thermodynamic modelling shows that upon the gradual incorporation of sulfur in slag, calcium monosulfoaluminate precipitates continuously with the consumption of strätlingite and portlandite. The conclusion obtained in the paper provides a basis to understand the role of sulfur in slag on the hydration process of slag cement
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Concrete and Cement Materials Research · Magnesium Oxide Properties and Applications · Concrete Properties and Behavior

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (48)

Show source-provided references
1. Juenger, M., et al., Advances in alternative cementitious binders. 2011. 41(12): p. 1232–1243.10.1016/j.cemconres.2010.11.012 ↗
2. Crossin, E.J.J.o.C.P., The greenhouse gas implications of using ground granulated blast furnace slag as a cement substitute. 2015. 95: p. 101-108.10.1016/j.jclepro.2015.02.082 ↗
3. Li, Y., et al., Environmental impact analysis of blast furnace slag applied to ordinary Portland cement production. 2016. 120: p. 221–230.10.1016/j.jclepro.2015.12.071 ↗
4. Benefits of slag and fly ash10.1016/0950-0618(95)00014-3 ↗
5. Sohn, I., D.J.J.s.r.i. Min, A review of the relationship between viscosity and the structure of calcium‐silicate‐based slags in ironmaking. 2012. 83(7): p. 611–630.10.1002/srin.201200040 ↗
6. Özbay, E., et al., Utilization and efficiency of ground granulated blast furnace slag on concrete properties–A review. 2016. 105: p. 423-434.10.1016/j.conbuildmat.2015.12.153 ↗
7. Sajid, M., et al., Understanding the structure and structural effects on the properties of blast furnace slag (BFS). 2019. 59(7): p. 1153-1166.10.2355/isijinternational.ISIJINT-2018-453 ↗
8. Fly ash as an assemblage of model Ca–Mg–Na-aluminosilicate glasses10.1016/j.cemconres.2015.08.005 ↗
9. The effect of glass composition on the reactivity of synthetic glasses10.1111/jace.14759 ↗
10. Structure and reactivity of synthetic CaO-Al2O3-SiO2 glasses10.1016/j.cemconres.2019.03.004 ↗
11. Beton aus granulierter Hochofenschlacke nach 27jähriger Einwirkung von
12. Glasser, F.P., et al., Modification of cement pore fluid compositions by pozzolanic additives. 1988. 18(2): p. 165–178.10.1016/0008-8846(88)90001-4 ↗
13. Gruskovnjak, A., et al., Hydration of alkali-activated slag: comparison with ordinary Portland cement. 2006. 18(3): p. 119-128.10.1680/adcr.2006.18.3.119 ↗
14. Lothenbach, B., et al., Hydration of a low-alkali CEM III/B–SiO2 cement (LAC). 2012. 42(2): p. 410-423.10.1016/j.cemconres.2011.11.008 ↗
15. Kleinjan, W.E., A. de Keizer, and A.J.J.W.R. Janssen, Kinetics of the chemical oxidation of polysulfide anions in aqueous solution. 2005. 39(17): p. 4093-4100.10.1016/j.watres.2005.08.006 ↗
16. Le Cornec, D., et al., Greening effect in slag cement materials. 2017. 84: p. 93-98.10.1016/j.cemconcomp.2017.08.017 ↗
17. Schwab, A., et al., Characteristics of blast furnace slag leachate produced under reduced and oxidized conditions. 2006. 41(3): p. 381-395.10.1080/10934520500423527 ↗
18. Quennoz, A., K.L.J.C. Scrivener, and C. Research, Interactions between alite and C3A-gypsum hydrations in model cements. 2013. 44: p. 46-54.10.1016/j.cemconres.2012.10.018 ↗
19. Factors influencing the sulfate balance in pure phase C3S/C3A systems10.1016/j.cemconres.2020.106085 ↗
20. Gruyaert, E., et al., Study of the hydration of Portland cement blended with blast-furnace slag by calorimetry and thermogravimetry. 2010. 102(3): p. 941–951.10.1007/s10973-010-0841-6 ↗
21. Berodier, E.M.J., Impact of the supplementary cementitious materials on the kinetics and microstructural development of cement hydration. 2015, EPFL.
22. Schöler, A., et al., Hydration of quaternary Portland cement blends containing blast-furnace slag, siliceous fly ash and limestone powder. 2015. 55: p. 374–382.10.1016/j.cemconcomp.2014.10.001 ↗
23. Scrivener, K.L.J.C. and c. Composites, Backscattered electron imaging of cementitious microstructures: understanding and quantification. 2004. 26(8): p. 935–945.10.1016/j.cemconcomp.2004.02.029 ↗
24. Deschner, F., et al., Hydration of Portland cement with high replacement by siliceous fly ash. 2012. 42(10): p. 1389-1400.10.1016/j.cemconres.2012.06.009 ↗
25. Whittaker, M., et al., The impact of alumina availability on sulfate resistance of slag composite cements. 2016. 119: p. 356-369.10.1016/j.conbuildmat.2016.05.015 ↗
26. Richardson, I.J.C. and C. Research, Tobermorite/jennite-and tobermorite/calcium hydroxide-based models for the structure of CSH: applicability to hardened pastes of tricalcium silicate, β-dicalcium silicate, Portland cement, and blends of Portland cement with blast-furnace slag, metakaolin, or silica fume. 2004. 34(9): p. 1733-1777.10.1016/j.cemconres.2004.05.034 ↗
27. Taylor, R., et al., Composition and microstructure of 20-year-old ordinary Portland cement–ground granulated blast-furnace slag blends containing 0 to 100% slag. 2010. 40(7): p. 971–983.10.1016/j.cemconres.2010.02.012 ↗
28. Escalante-Garcia, J.-I., J.J.C. Sharp, and C. Composites, The chemical composition and microstructure of hydration products in blended cements. 2004. 26(8): p. 967-976.10.1016/j.cemconcomp.2004.02.036 ↗
29. Whittaker, M., et al., The role of the alumina content of slag, plus the presence of additional sulfate on the hydration and microstructure of Portland cement-slag blends. 2014. 66: p. 91-101.10.1016/j.cemconres.2014.07.018 ↗
30. Glasser, F.J.M.s.o.c., Chemical, mineralogical and Micro-structural Changes Occurring in Hydrated Slag-Cement Blends. 1991: p. 41-82.
31. Rodger, S.A. and G.W.J.A.i.C.R. Groves, The microstructure of tricalcium silicate/pulverized-fuel ash blended cement pastes. 1988. 1(2): p. 84-91.10.1680/adcr.1988.1.2.84 ↗
32. Li, B., et al., Spatial zonation of a hydrotalcite-like phase in the inner product of slag: New insights into the hydration mechanism. 2021. 145: p. 106460.10.1016/j.cemconres.2021.106460 ↗
33. The Effect of Adsorbed Al (OH) 4-on the Dissolution Rate of Quartz
34. Chappex, T., K.L.J.J.o.t.A.C.S. Scrivener, The effect of aluminum in solution on the dissolution of amorphous silica and its relation to cementitious systems. 2013. 96(2): p. 592-597.10.1111/jace.12098 ↗
35. Nicoleau, L., et al., Ion-specific effects influencing the dissolution of tricalcium silicate. 2014. 59: p. 118-138.10.1016/j.cemconres.2014.02.006 ↗
36. Pardal, X., et al., 27Al and 29Si solid-state NMR characterization of calcium-aluminosilicate-hydrate. 2012. 51(3): p. 1827-1836.10.1021/ic202124x ↗
37. Suraneni, P., R.J.J.C. Flatt, and C. Research, Use of micro-reactors to obtain new insights into the factors influencing tricalcium silicate dissolution. 2015. 78: p. 208-215.10.1016/j.cemconres.2015.07.011 ↗
38. Wagner, T., et al., GEM-Selektor geochemical modeling package: TSolMod library and data interface for multicomponent phase models. 2012. 50(5): p. 1173-1195.10.3749/canmin.50.5.1173 ↗
39. Kulik, D.A., et al., GEM-Selektor geochemical modeling package: revised algorithm and GEMS3K numerical kernel for coupled simulation codes. 2013. 17(1): p. 1-24.10.1007/s10596-012-9310-6 ↗
40. Hummel, W., et al., Nagra Technical Report NTB 02-16. 2002.
41. Hummel, W., et al., Nagra/PSI chemical thermodynamic data base 01/01. 2002. 90(9-11): p. 805-813.10.1524/ract.2002.90.9-11_2002.805 ↗
42. Matschei, T., et al., Thermodynamic properties of Portland cement hydrates in the system CaO–Al2O3–SiO2–CaSO4–CaCO3–H2O. 2007. 37(10): p. 1379-1410.10.1016/j.cemconres.2007.06.002 ↗
43. Lothenbach, B., et al., Thermodynamic modelling of the effect of temperature on the hydration and porosity of Portland cement. 2008. 38(1): p. 1-18.10.1016/j.cemconres.2007.08.017 ↗
44. Myers, R.J., et al., A thermodynamic model for C-(N-) ASH gel: CNASH_ss. Derivation and validation. 2014. 66: p. 27-47.10.1016/j.cemconres.2014.07.005 ↗
45. Myers, R.J., et al., Thermodynamic modelling of alkali-activated slag cements. 2015. 61: p. 233-247.10.1016/j.apgeochem.2015.06.006 ↗
46. Prediction of cement hydration
47. Lothenbach, B., et al., Influence of limestone on the hydration of Portland cements. 2008. 38(6): p. 848–860.10.1016/j.cemconres.2008.01.002 ↗
48. Nachbaur, L., et al., Electrokinetic properties which control the coagulation of silicate cement suspensions during early age hydration. 1998. 202(2): p. 261-268.10.1006/jcis.1998.5445 ↗