journal article·2013-10

Influence of using polymeric aggregate treatment on moisture damage in hot mix asphalt

F. Moghadas Nejad, M. Arabani, Gh.H. Hamedi, A.R. Azarhoosh

Publisher page

Abstract

Abstract Moisture damage in hot mix asphalt (HMA) occurs due to a loss of adhesion and or cohesion, resulting in the reduced strength or stiffness of the HMA and the development of various forms of pavement distress. One of the convenient approaches to decreasing moisture sensitivity in HMA is coating the aggregate surface with a suitable agent. In this research, the effects of two types of polyethylene (PE), namely high density polyethylene (HDPE) and low density polyethylene (LDPE), on moisture damage of asphalt mixtures were evaluated. Two types of aggregates representing a considerable range in mineralogy (granite and limestone) were evaluated during the course of this study. To assess the impact of PE on moisture damage of HMA, control mixtures (without PE) and mixtures containing PE in dry and wet conditions were tested using indirect tensile strength (ITS) and indirect tensile stiffness modulus (ITSM) tests. The results showed that the ratio of wet/dry values of ITS and ITSM for mixtures containing limestone was higher than those of the samples with granite aggregate. The results of the laboratory tests indicate that PE increases the wettability of asphalt binder over the aggregate and the adhesion between the asphalt binder and aggregate, especially in the mixtures containing acidic (granite) aggregate prone to moisture damage. The aggregates treated with HDPE showed better resistance against moisture damage in both aggregates that were used in this study.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Asphalt Pavement Performance Evaluation · Infrastructure Maintenance and Monitoring · Geotechnical Engineering and Underground Structures

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (19)

Show source-provided references
1. Effect of asphalt film thickness on the moisture sensitivity characteristics of hot mix asphalt10.1016/j.buildenv.2006.10.006 ↗
2. Mercado AE. Influence of fundamental material properties and air void structure on moisture damage of asphalt mixes, Ph.D. thesis, A&M University, Texas; 2007.
3. Bhasin A. Development of method to quantify bitumen-aggregate adhesion and loss of adhesion due to moisture. PhD thesis, A&M University, Texas; 2006.
4. Influence of surface treated fly ash with coupling agent on asphalt mixture moisture damage10.1016/j.conbuildmat.2011.11.022 ↗
5. Evaluation of moisture damage in hot mix asphalt using simple performance and superpave indirect tensile tests10.1016/j.conbuildmat.2007.07.014 ↗
6. Influence of using nonmaterial to reduce the moisture susceptibility of hotmix asphalt10.1016/j.conbuildmat.2012.01.004 ↗
7. The effects of using lime and styrene–butadiene–styrene on moisture sensitivity resistance of hot mix asphalt10.1016/j.conbuildmat.2008.08.019 ↗
8. Effect of various additives on moisture damage sensitivity of asphalt mixtures10.1016/j.conbuildmat.2004.05.003 ↗
9. Yoon HH, Tarrer AR. Effect of Aggregate Properties on Stripping. Transportation Research Record Report No. 1171. Transportation Research Board, National Research Council, Washington DC; 1988. p. 37–43.
10. Wasiuddin NM, Zaman MM, O’Rear EA. Effect of polymeric aggregate treatment using styrene butadiene rubber (SBR) for moisture-induced damage potential. In: Transportation Research Board, 86th Annual Meeting, Washington DC, 2007.
11. Effectiveness of antistrip additives for bituminous mixtures
12. Evaluation of moisture damage mechanisms and effects of hydrated lime in asphalt mixtures through measurements of mixture component properties and performance testing10.1061/(ASCE)0899-1561(2008)20:10(659) ↗
13. The effect of anti-strip treatments on asphalt-aggregate systems: an environemental scanning electron microscope study10.1177/009524439803000402 ↗
14. The use of polyethylene in hot asphalt mixtures10.3844/ajassp.2007.390.396 ↗
15. American association of state highways and transportation officials. Resistance of compacted bituminous mixture to moisture induced damage AASHTO T283-99, USA; 2000.
16. Dynamic properties of stone mastic asphalt mixtures containing waste plastic bottles10.1016/j.conbuildmat.2012.02.054 ↗
17. British Standards Institution BSI. Method for determination of the indirect tensile stiffness modulus of bituminous mixtures, Draft for Development Report. No. 213, London; 1993.
18. The effect of recycled concrete aggregate and steel slag on the dynamic properties of asphalt mixtures10.1016/j.conbuildmat.2012.02.036 ↗
19. Little · 2006