Effect of cracking, corrosion and repair on the frequency response of RC beams
Source abstract
Abstract
Abstract This paper presents a laboratory investigation to study the effect of cracking, corrosion and repair on the frequency response of simply-supported reinforced concrete beams. The beams were subjected to four-point bending at 70% of their theoretical ultimate loads. Corrosion was then induced using an electro-chemical acceleration technique. The beams were then repaired to restore their load-carrying and deflection capacities. Based on response time histories, the fundamental frequency characteristics of the beams were deduced using Fourier transform (FT) and Hilbert-Huang transform (HHT). Experimental results revealed significant changes in the normalized frequency, R f , with decrease in R f associated with load-induced cracking, an increase in R f associated with moderate reinforcement corrosion and a subsequent decrease in R f associated with repair. The results of this study support the use of frequency response, obtained with an appropriate signal processing technique such as HHT, to infer the health of monitored structures, taking into account environmental conditions, likelihood of corrosion occurrence, properties of repair material and interfacial bonding.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Structural Health Monitoring Techniques · Concrete Corrosion and Durability · Ultrasonics and Acoustic Wave Propagation
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (14)
Show source-provided references
1. Doebling · 1996
2. Detection of structural damage through changes in frequency: a review10.1016/S0141-0296(96)00149-6 ↗
3. Structural damage identification from dynamic-test data10.1061/(ASCE)0733-9445(1994)120:8(2437) ↗
4. Chowdhury MR, Ramirez MA. Comparison of the modal responses for defective versus non-defective concrete test beams. In: Proceedings of the 10th international modal analysis conference; 1992. p. 508–15.
5. Damage quantification of flexurally loaded rc slab using frequency response data10.1177/147592170400300401 ↗
6. Capozucca R, Nilde Cerri M. Identification of damage in reinforced concrete beams subjected to corrosion. ACI Struct J November/December; 2000, p. 902–9.
7. The effect of corrosion on the natural frequency and modal damping of reinforced concrete beams10.1016/S0141-0296(01)00005-0 ↗
8. Bridge assessment using forced-vibration testing10.1061/(ASCE)0733-9445(1995)121:2(161) ↗
9. Huang NE, Shen Z, Long SR, Wu MLC, Shih HH, Zheng QN et al. The empirical mode decomposition and the hilbert spectrum for non-linear and non-stationary time series analysis. Proc Royal Soc Lond Ser A-Math Phys Eng Sci 1998; 903–95.10.1098/rspa.1998.0193 ↗
10. Corrosion durability and structural response of functionally-graded concrete beams10.3151/jact.1.307 ↗
11. Quek ST, Tua PS, Wang Q. 2003. Comparison of Hilbert-Huang, wavelet and Fourier transforms for selected applications. In: Mini-symposium on Hilbert-Huang transform in engineering applications 31 October–01 November, Newark, Delaware; 2003.
12. Mindess · 1981
13. Maaddawy TEl, Soudki KA. Viability of using CFRP laminates to repair RC beams corroded under sustained loads. In: Proceedings of the 6th international symposium on FRP reinforcement for concrete structures (FRPRCS-6), vol. 2; 2003. p. 855–64.10.1142/9789812704863_0081 ↗
14. Bond behavior of corroded reinforcement bars