journal article·2019-02

Bond mechanism of EBROG method using a single groove to attach CFRP sheets on concrete

Amir Tajmir-Riahi, Niloufar Moshiri, Davood Mostofinejad

Publisher page

Abstract

Abstract Improving bond behavior of fiber reinforced polymer (FRP)-to-concrete through externally bonded reinforcement on groove (EBROG) technique was scrutinized in this paper. Bond resistance of a single groove without its interference with probable adjacent grooves was discussed in order to be able to further perceive the EBROG mechanism. To do so, a total of 18 single lap-shear tests were conducted on carbon fiber reinforced polymer (CFRP) strengthened concrete blocks. Bond behavior in terms of maximum load capacity, effective bond length and bond mechanism of externally bonded reinforcement (EBR) method and EBROG technique were investigated. Experimental results revealed that EBROG method with only a single groove improved the bond strength significantly. It was also discussed that in EBROG method, meso plies would engender in concrete depth, and help the bonded joint to resist higher loads. For instance, bond strength of EBROG specimen with 5 × 5 mm groove dimension was 10.4 kN; which is 42% higher compared to EBR specimen with 7.3 kN of load capacity. Bond strength of 12.2 kN was also observed in EBROG specimen with 5 × 10 mm groove dimension showing 67% increase respect to EBR. In addition, an innovative technique was introduced to measure the effective bond length based on load-slip diagrams. An image correlation system (ICS) was used to determine full-field displacements/strains in order to comprehensively study the EBROG function.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Structural Behavior of Reinforced Concrete · Concrete Corrosion and Durability · Structural Response to Dynamic Loads

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (34)

Show source-provided references
1. Experimental study on bond behavior between concrete and FRP reinforcement10.1061/(ASCE)1090-0268(2008)12:2(180) ↗
2. Prediction of interfacial bond failure of FRP–concrete surface10.1061/(ASCE)1090-0268(2007)11:4(427) ↗
3. Bond–slip models for FRP sheets/plates bonded to concrete10.1016/j.engstruct.2005.01.014 ↗
4. An experimental study on delamination of FRP plates bonded to concrete10.1016/j.conbuildmat.2007.04.009 ↗
5. Development of the nonlinear bond stress–slip model of fiber reinforced plastics sheet–concrete interfaces with a simple method10.1061/(ASCE)1090-0268(2005)9:1(52) ↗
6. FRP-strengthened RC beams. I: review of debonding strength models10.1016/S0141-0296(01)00105-5 ↗
7. FRP plates adhesively bonded to reinforced concrete beams: generic debonding mechanisms10.1260/136943306779369482 ↗
8. Anchorage strength models for FRP and steel plates bonded to concrete10.1061/(ASCE)0733-9445(2001)127:7(784) ↗
9. Generic debonding resistance of EB and NSM plate-to-concrete joints10.1061/(ASCE)1090-0268(2007)11:1(62) ↗
10. Grooving as alternative method of surface preparation to postpone debonding of FRP laminates in concrete beams10.1061/(ASCE)CC.1943-5614.0000117 ↗
11. Externally bonded reinforcement in grooves (EBRIG) technique to postpone debonding of FRP sheets in strengthened concrete beams10.1016/j.conbuildmat.2012.09.030 ↗
12. Experimental investigation into bond behavior of CFRP sheets attached to concrete using EBR and EBROG techniques10.1016/j.compositesb.2013.03.003 ↗
13. Bond behavior of CFRP sheets attached to concrete through EBR and EBROG joints subject to mixed-mode I/II loading10.1061/(ASCE)CC.1943-5614.0000816 ↗
14. Strengthening of RC columns by longitudinal CFRP sheets: effect of strengthening technique10.1016/j.conbuildmat.2015.01.040 ↗
15. Compressive strength of CFRP composites used for strengthening of RC columns: comparative evaluation of EBR and grooving methods10.1061/(ASCE)CC.1943-5614.0000545 ↗
16. Experimental investigation of the efficacy of EBROG method in seismic rehabilitation of deficient reinforced concrete beam-column joints using CFRP sheets10.1061/(ASCE)CC.1943-5614.0000781 ↗
17. Experimental study of circular RC columns strengthened with longitudinal CFRP composites under eccentric loading: comparative evaluation of EBR and EBROG methods10.1061/(ASCE)CC.1943-5614.0000618 ↗
18. Bond efficiency of EBR and EBROG methods in different flexural failure mechanisms of FRP strengthened RC beams10.1016/j.conbuildmat.2014.01.002 ↗
19. Experimental study on effect of EBR and EBROG methods on debonding of FRP sheets used for shear strengthening of RC beams10.1016/j.compositesb.2012.09.081 ↗
20. Effect of concrete strength and groove dimension on performance of grooving method to postpone debonding of FRP sheets in strengthened concrete beams
21. EBROG and EBRIG methods for strengthening of RC beams by FRP sheets10.1080/19648189.2014.900523 ↗
22. Effect of GM patterns on ductility and debonding control of FRP sheets in RC strengthened beams10.1016/j.conbuildmat.2015.05.062 ↗
23. Effect of groove characteristics on CFRP-to-concrete bond behavior of EBROG joints: experimental study using particle image velocimetry (PIV)10.1016/j.conbuildmat.2013.08.036 ↗
24. Experimental and analytical study on CFRP strips-to-concrete bonded joints using EBROG method10.1016/j.compositesb.2018.09.046 ↗
25. Sika Group, Technical data sheet, Sikadur 330, epoxy adhesive. http://www.sika.com, 2017.
26. Sika Group, Technical data sheet, SikaWrap-230C, Woven carbon fiber fabrics for structural strengthening. www.sika.com, 2017.
27. ASTM D3039/D3039M, Standard test method for tensile properties of polymer matrix composite materials, 2000.
28. Soil deformation measurement using particle image velocimetry (PIV) and photogrammetry10.1680/geot.2003.53.7.619 ↗
29. Displacement and strain field measurement in steel and RC beams using particle image velocimetry10.1061/(ASCE)EM.1943-7889.0000805 ↗
30. Front and side view image correlation measurements on FRP to concrete pull-off bond tests10.1061/(ASCE)CC.1943-5614.0000106 ↗
31. Direct determination of cohesive stress transfer during debonding of FRP from concrete10.1016/j.compstruct.2010.05.024 ↗
32. Investigating the effects of concrete compressive strength, CFRP thickness and groove depth on CFRP-concrete bond strength of EBROG joints10.1016/j.conbuildmat.2018.08.203 ↗
33. Analytical modeling of the bond–slip relationship at FRP-concrete interfaces for adhesively-bonded joints10.1016/j.compositesb.2010.06.004 ↗
34. Analytical identification of bond–slip relationship of EB-FRP joints10.1016/j.compositesb.2012.01.048 ↗