journal article·2017-02

Feasibility of using biomass fly and bottom ashes in dry-cast concrete production

J.-M. Lessard, A. Omran, A. Tagnit-Hamou, R. Gagne

Publisher page

Abstract

Abstract The production of low cost and durable dry-cast concrete (DCC) represents an important industry for developing countries. DCC can have more environmental benefits if designed with alternative supplementary cementitious materials (ASCM) since its strength is not the main concern. This paper presents a laboratory optimization of pulp and paper biomass-fly ash (BFA) as ASCM and biomass-bottom ash (BBA) as an alternative sand, and combinations of both for DCC production. The BFA was used to replace up to 30% of cement and the BBA was employed to replace up to 80% of the sand. All DCC mixtures were characterized based on the fresh (compactness), mechanical (compressive and splitting-tensile strength), and transport (water absorption, air voids, and electrical resistivity) properties up to 91 days. The DCC mixtures made with 5%, 10%, or 15% BFA and 25% of BBA can reach a compactness index of 99% with a compaction work lower than specified by the Standards. The use of the BFA and BBA lead to a small decrease of the compressive strength, however they can exhibit very low permeability and water absorption values, lower than required by the specifications (close to 5%). Those results demonstrate the feasibility of using BFA or BBA in the production of DCC, which significantly contributes to the sustainability of the pulp and paper and concrete industries.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Recycling and utilization of industrial and municipal waste in materials production · Concrete and Cement Materials Research · Recycled Aggregate Concrete Performance

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (37)

Show source-provided references
1. Effect of additives on the mechanical properties of some cement products
2. N. Amer, C. Storey, C., J.D. Norbert Jr., Effect of density on mechanical properties and durability of roller compacted concrete. Research & Development information, Portland cement Association, Serial no. 2940, 2008.
3. ASTM, Standard Specification for Portland Cement, C150-04, West Conshohocken, PA, 2004.
4. ASTM, Standard Test Method for Splitting Tensile Strength of Cylindrical Concrete Specimens, C496/C496M-11, West Conshohocken, PA, 2011.
5. ASTM, Standard Practice for Capping Cylindrical Concrete Specimens, C617/C617M-12, West Conshohocken, PA, 2012.
6. ASTM, Standard Specification for Coal Fly Ash and Raw or Calcined Natural Pozzolan for Use in Concrete, C618-12a, West Conshohocken, PA, 2012.
7. ASTM, Standard Test Method for Density, Absorption, and Voids in Hardened Concrete, C642-13, West Conshohocken, PA, 2013.
8. ASTM, Standard Test Method for Compressive Strength of Cylindrical Concrete Specimens, C39/C39M-14, West Conshohocken, PA, 2014.
9. F. Ayrinhac, Valorisation des cendres volantes de chaudière à lit fluidisé circulant dans la filière du génie civil [Valuing fly ash from circulating fluidized bed boiler in civil engineering industry] (Ph.D. thesis), Institut National des Sciences Appliquées de Toulouse, France, 2005 (in French).
10. Compressive strength and hydration of wastepaper sludge ash-ground granulated blast furnace slag blended pastes10.1016/S0008-8846(03)00042-5 ↗
11. Setting time and heat of hydration of wastepaper sludge ash-ground granulated blastfurnace slag blended cements
12. Performance of dry cast concrete blocks containing waste glass powder or polyethylene aggregates10.1016/j.cemconcomp.2011.05.004 ↗
13. Dry-cast concrete masonry products: properties and durability10.1139/L07-072 ↗
14. CSA · 2006 · 12
15. T. Davienko, Hydratation d’un système ciment binaire contenant des cendres volantes de biomasse [Hydration of a binary cimentitous system containing biomass fly ash] (Ph.D. thesis), Université de Sherbrooke, Canada, 2015 (in French).
16. Energy consumption during compaction with a gyratory intensive compactor tester. Estimations models10.1016/j.conbuildmat.2010.06.083 ↗
17. D. Chahidi-Elouazzani, Caractérisation physico-chimique et valorisation en bâtiment et travaux public des cendres issues de l’incinération des boues de papeteries [Physico-chemical characterization and the recycle of ashes from incineration of sludge from paper mills in building and public works] (Ph.D. thesis), Institut National des Sciences Appliquées de Lyon, France, 2005 (in French).
18. J.-P. Faubert, Valorisation de particules fines dans les bétons compactés au rouleau et les bétons moulés à sec [Valuation of fine particles in roller-compacted concrete and dry cast concrete] (Master’s thesis), Université de Sherbrooke, Canada, 2012 (in French).
19. Reaction products and strength development of wastepaper sludge ash and the influence of alkalis10.1016/j.cemconcomp.2013.09.009 ↗
20. On the early-age behavior of zero-slump concrete10.1016/j.cemconres.2011.11.007 ↗
21. Workability of no-slump concrete
22. A preliminary study of the cementitious properties of wastepaper sludge ash ground granulated blast-furnace slag (WSA-GGBS) blends
23. Bagasse ash as an effective replacement in fly ash bricks
24. J. Lavta-Somppi, Experimental studies on pulp and paper mill sludge ash behavior in fluidized bed combustors (Ph.D. thesis), University of technology, Espoo, Finland, 1998, 90 p.
25. Feasibility of using biomass fly and bottom ashes to produce RCC and PCC
26. Mixture proportioning of roller-compacted concrete – a review
27. Mehta · 2013
28. An investigation into the strength development of wastepaper sludge ash blended with ground granulated blast furnace slag10.1016/j.cemconres.2009.07.001 ↗
29. NT Build 427, Concrete, Fresh: Compactability with IC-tester (intensive compaction tester), Nordtest, 1994.
30. Pacheco-Torgal · 2014
31. J. Pera, J. Ambroise, Transformation of paper sludge into a value-added admixture for concrete, in: Global Symposium on Recycling Waste treatment and Clean Technology (REWAS 1999), vol. 1, Minerals, Metals and Materials Society, San Sebastian, Spain, 1999, pp. 381–389.
32. J. Pera, J. Ambroise, Properties of calcined paper sludge, in: R.K. Dhir, T.D. Dyer, K.A. Paine (Eds.), Sustainable Construction: Use of Incinerator Ash, Thomas Telford Ltd, London, 2000, pp. 405–414.
33. Development of highly reactive metakaolin from paper sludge10.1016/S1065-7355(97)00016-3 ↗
34. Characterization and use of biomass fly ash in cement-based materials10.1016/j.jhazmat.2009.07.109 ↗
35. J. Roby, Propriétés de bétons de cendres volantes provenant de l’incinération des boues de désancrage des usines de cogeneration [Properties of concretes made with fly ash from incineration of deinking sludge in cogeneration plants] (Master’s thesis), Université de Sherbrooke, Canada, 2011 (in French).
36. Reuse of woody biomass ash waste in cementitious materials10.15255/CABEQ.2015.2231 ↗
37. A. Xie, Characteristics of wastepaper sludge ash and its potential applications in concrete (Master’s thesis), Université de Sherbrooke, Canada, 2009.