journal article·2021-01

Effect of microfines from manufactured sand on yield stress of cement paste

Jiang Zhu, Xin Shu, Jinhui Tang, Tian Li, Qianping Ran, Jiaping Liu

Publisher page

Abstract

Abstract With the depletion of natural sand, the manufactured sand is frequently used in cement-based materials, which inevitably affects the flowability. It is mainly due to that the yield stress is affected by the microfines (≤75 μm) in manufactured sand. However, the mechanism is still not fully understood. This paper investigated the effects of the microfines of limestone, granite, and two tuffs on the yield stress of cement pastes with superplasticizer. The average surface coverage, packing density, and particle size distribution (PSD) of the suspending particles were measured to reveal the affecting mechanism of microfines on the internal particle network of the pastes. Results show that the incorporation of the microfines increases the yield stress of cement pastes. Limestone with the highest specific surface area (SSA) and granite with the lowest SSA caused the largest and smallest increases of the yield stress, respectively. Two different tuffs with similar SSA led to equivalent increases of yield stress. It is ascribed to the reduction of the average surface coverage, which reduces the average surface-to-surface separation distance and enhances the colloidal interactions with the incorporation of microfines. Due to the high fraction of fine particles in microfines, although the packing density increases slightly, the PSD effect of the suspending particles is significantly enhanced, which increases the number and effective volume fraction of the contacting particles and therefore the particle contact interactions. The internal particle network of the cement pastes is jointly affected by colloidal interactions and particle contact interactions, which thereby leads to the different influences of the microfines on the yield stress.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Innovations in Concrete and Construction Materials · Concrete and Cement Materials Research · Grouting, Rheology, and Soil Mechanics

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (43)

Show source-provided references
1. P.N. Quiroga, The effect of the aggregates characteristics on the performance of Portland cement concrete, Ph.D. Thesis, The University of Texas at Austin, Austin, America, 2003.
2. N. Ahn, An experimental study on the guidelines for using higher contents of aggregate microfines in Portland cement concrete, Ph.D. Thesis, The University of Texas at Austin, Austin, America, 2000.
3. Understanding influence of crushers on shape characteristics of fine aggregates based on digital image and conventional techniques10.1016/j.conbuildmat.2017.06.058 ↗
4. A.A. Jeknavorian, E. Koehler, Use of chemical admixtures to modify the rheological behavior of cementitious systems containing manufactured aggregates, the Concrete Sustainability Conference of NRMCA, Tempe, Arizona, April, 2010.
5. Filler from crushed aggregate for concrete: Pore structure, specific surface, particle shape and size distribution10.1016/j.cemconcomp.2014.03.010 ↗
6. Sand production with VSI crushing and air classification: Optimising fines grading for concrete production with micro-proportioning10.1016/j.mineng.2015.03.025 ↗
7. Comparison of 2-D and 3-D shape analysis of concrete aggregate fines from VSI crushing10.1016/j.powtec.2016.12.037 ↗
8. Three dimensional shape analysis of concrete aggregate fines produced by VSI crushing10.1016/j.powtec.2016.12.020 ↗
9. Effects of limestone fines on water film thickness, paste film thickness and performance of mortar10.1016/j.powtec.2014.04.027 ↗
10. J. Wang, Research of effects and mechanism of manfactured sand characteristics on portland cement concrete, Ph.D. Thesis, Wuhan University of Technology, Wuhan, China, 2008. (in Chinese).
11. Effect of mineral admixtures on properties of self-compacting concrete10.1016/j.cemconcomp.2011.04.005 ↗
12. Relationship among particle characteristic, water film thickness and flowability of fresh paste containing different mineral admixtures10.1016/j.conbuildmat.2017.07.093 ↗
13. Relating early hydration, specific surface and flow loss of cement pastes10.1617/s11527-018-1304-y ↗
14. Rheological properties of micromortars containing fines from manufactured aggregates10.1617/s11527-006-9173-1 ↗
15. The nature of limestone filler and self-consolidating feasibility—Relationships between physical, chemical and mineralogical properties of fillers and the flow at different states, from powder to cement-based suspension10.1016/j.powtec.2011.11.045 ↗
16. Effects of fineness and substitution ratio of limestone powder on yield stress of cement suspensions10.1617/s11527-019-1378-1 ↗
17. Influence of crushed aggregate fines with micro-proportioned particle size distributions on rheology of cement paste10.1016/j.cemconcomp.2017.02.012 ↗
18. Measurement of particle size distribution and specific surface area for crushed concrete aggregate fines10.1016/j.apt.2016.11.018 ↗
19. Yodel: a yield stress model for suspensions10.1111/j.1551-2916.2005.00888.x ↗
20. Dispersion forces in cement suspensions10.1016/j.cemconres.2003.08.019 ↗
21. Yield stress of multimodal powder suspensions: an extension of the YODEL (Yield Stress mODEL)10.1111/j.1551-2916.2007.01595.x ↗
22. Interaction of cement model systems with superplasticizers investigated by atomic force microscopy, zeta potential, and adsorption measurements10.1016/j.jcis.2010.03.005 ↗
23. Experimental determination of the thermodynamic parameters affecting the adsorption behaviour and dispersion effectiveness of PCE superplasticizers10.1016/j.cemconres.2009.12.002 ↗
24. Characterization of Polycarboxylate-Ether Based Superplasticizer on Cement Clinker Surfaces10.1111/j.1551-2916.2012.05189.x ↗
25. Crushed sand in concrete – Effect of particle shape in different fractions and filler properties on rheology10.1016/j.cemconcomp.2016.04.004 ↗
26. Steady state flow of cement suspensions: A micromechanical state of the art10.1016/j.cemconres.2009.08.026 ↗
27. Yield stress and bleeding of fresh cement pastes10.1016/j.cemconres.2012.03.015 ↗
28. A test method for determining adhesion forces and Hamaker constants of cementitious materials using atomic force microscopy10.1016/j.cemconres.2011.07.004 ↗
29. N. Fernandez, From tribology to rheology impact of interparticle friction in the shear thickening of non-Brownian suspensions, PhD Thesis, Department of materials science, ETH Zurich (2014).
30. R. Flatt, I. Schober, Superplasticizers and the rheology of concrete, in: N. Roussel (Ed.), Understanding the Rheology of Concrete, Woodhead Publishing, 2012.10.1533/9780857095282.2.144 ↗
31. Effect of particle-size distribution and specific surface area of different binder systems on packing density and flow characteristics of cement paste10.1016/j.cemconcomp.2017.01.005 ↗
32. Impact of physical and physicochemical properties of supplementary cementitious materials on structural build-up of cement-based pastes10.1016/j.cemconres.2020.105994 ↗
33. Adsorbing polymers and viscosity of cement pastes10.1016/j.cemconres.2014.04.005 ↗
34. L. Ferrari, P. Boustingorry, Impact of supplementary cementitious materials on the rheology of cement pastes, 2nd International Conference on the Chemistry of Construction Materials, Munich, Germany, October, 2016.
35. Fluidizing efficiency of comb-like superplasticizers: The effect of the anionic function, the side chain length and the grafting degree10.1016/j.cemconres.2015.02.001 ↗
36. From mini-cone test to Abrams cone test: measurement of cement-based materials yield stress using slump tests10.1016/j.cemconres.2004.07.032 ↗
37. F. de Larrard, Concrete constituents: Relevant Parameters, in F. de Larrard (Ed.), Concrete mixture proportioning: A scientific approach, CRC Press, 1999, pp. 222–249.10.1201/9781482272055 ↗
38. Influence of superplasticizer dosage on the viscosity of cement paste with low water-binder ratio10.1016/j.conbuildmat.2017.05.145 ↗
39. Consequences of competitive adsorption between polymers on the rheological behaviour of cement pastes10.1016/j.cemconcomp.2014.05.002 ↗
40. Effect of polycarboxylate ether superplasticizer (PCE) on dynamic yield stress, thixotropy and flocculation state of fresh cement pastes in consideration of the Critical Micelle Concentration (CMC)10.1016/j.cemconres.2018.02.019 ↗
41. Multi scale experimental study of concrete rheology: From water scale to gravel scale10.1617/s11527-005-9047-y ↗
42. Thixotropy of SCC—A model describing the effect of particle packing and superplasticizer adsorption on thixotropic structural build-up of the mortar phase based on interparticle interactions10.1016/j.cemconres.2017.11.004 ↗
43. Toward the viscosity reducing of cement paste: Optimization of the molecular weight of polycarboxylate superplasticizers10.1016/j.conbuildmat.2019.117984 ↗