journal article·2021-08

Fresh and hardened properties of brick aggregate concrete including coconut shell as a partial replacement of coarse aggregate

H. Bari, M.A. Salam, Md. Safiuddin

Publisher page

Abstract

Abstract The study was conducted to develop brick aggregate concrete including coconut shell as a partial replacement of coarse aggregate. Different coconut shell brick aggregate concretes (CSBACs) were prepared using 0–15% coconut shell aggregate (CSA) as a partial replacement of brick coarse aggregate and considering the water to cement (w/c) ratios of 0.45, 0.50 and 0.55 at the constant mix ratio of 1:1.5:3 (cement: fine aggregate: coarse aggregate) by bulk volume. CSBACs were tested to determine the major fresh and hardened properties. The fresh properties of CSBACs examined were workability and wet density. Among the hardened properties of CSBACs investigated, compressive strength was determined at the ages of 28, 56 and 90 days whereas splitting tensile strength, flexural strength, modulus of elasticity, Poisson’s ratio, and dry density were examined at the age of 28 days only. Test results revealed that the workability of CSBAC was lesser than that of the control concrete, but the decrease was lower with higher CSA content whereas the wet density of CSBAC decreased progressively with the increased amount of CSA. The compressive strength, splitting tensile strength, and flexural strength of CSBAC at 28 days decreased significantly for 10% and 15% CSA contents. However, at the ages of 56 and 90 days, the rate of gain in the compressive strength of CSBAC was higher for the w/c ratio of 0.50. The dry density and modulus of elasticity of CSBAC decreased with the increased amount of CSA for all replacement levels of brick aggregate whereas its Poisson’s ratio was higher than that of the control concrete at 28 days. Based on the data obtained, the correlations for the mechanical properties of CSBAC were sought. Strong correlations between most of the mechanical properties of CSBAC were observed in this study.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Innovative concrete reinforcement materials · Innovations in Concrete and Construction Materials · Geotechnical and construction materials studies

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (62)

Show source-provided references
1. Shetty · 2013
2. Material aspects for high-strength high performance concrete
3. Crushed bricks as coarse aggregate for concrete
4. FAOSTAT, Food and agricultural data, Food and Agriculture Organization (FAO) of the United Nations, Rome, Italy, 2019.
5. Mechanical and bond properties of coconut shell concrete10.1016/j.conbuildmat.2010.06.053 ↗
6. Long term study on compressive and bond strength of coconut shell aggregate concrete10.1016/j.conbuildmat.2011.08.072 ↗
7. Study on reinforced lightweight coconut shell concrete beam behavior under shear10.1016/j.matdes.2013.03.022 ↗
8. A study on the utilization of coconut shell as coarse aggregate in concrete
9. Exploratory study of coconut shell as coarse aggregate in concrete
10. Sustainable concrete by partially replacing coarse aggregate using coconut shell10.15415/jotitt.2014.21004 ↗
11. Strength properties of concrete containing coconut shell as coarse aggregate replacement
12. Experimental investigation on the properties of recycled concrete and coconut shell aggregate concrete
13. Experimental study on strength characteristics of M25 concrete with partial replacement of coarse aggregate with coconut shell and cement with fly ash
14. Experiments on partial replacement of coconut shell as coarse aggregate in concrete
15. Properties of concrete using crushed brick as aggregate
16. Mechanical properties of brick aggregate concrete10.1016/j.conbuildmat.2008.07.023 ↗
17. Properties of higher strength concrete made with crushed brick as coarse aggregate
18. Effect of replacing natural coarse aggregate by brick aggregate on the properties of concrete
19. Mechanical properties of brick aggregate concrete containing rice husk ash as a partial replacement of cement10.1061/(ASCE)MT.1943-5533.0002272 ↗
20. ASTM C150/C150M - 16, Standard specification for Portland cement, ASTM International, West Conshohocken, PA, USA, 2016.
21. ASTM C136/C136M - 14, Standard test method for sieve analysis of fine and coarse aggregates, ASTM International, West Conshohocken, PA, USA, 2014.
22. 2016
23. ASTM C566 - 13, Standard test method for total evaporable moisture content of aggregate by drying, ASTM International, West Conshohocken, PA, USA, 2013.
24. ASTM C128 - 15, Standard test method for relative density (specific gravity) and absorption of fine aggregate, ASTM International, West Conshohocken, PA, USA, 2015.
25. ASTM C127 - 15, Standard test method for relative density (specific gravity) and absorption of coarse aggregate, ASTM International, West Conshohocken, PA, USA, 2015.
26. IS 2386-1963, Methods of test for aggregates for concrete, Bureau of Indian Standards, New Delhi, India.
27. BS 812 : Part 1 : 1975, Methods for sampling and testing of mineral aggregates, sands and fillers, British Standards Institution, London, UK, 1975.
28. IS 10262: 2019, Concrete mix proportioning – guidelines (second revision), Bureau of Indian Standards, New Delhi, India, 2019.
29. IS 456-2000 (Reaffirmed 2016), Plain and reinforced concrete – code of practice, Bureau of Indian Standards, New Delhi, India, 2016.
30. Mohiuddin · 2014
31. Mandal · 2017
32. ASTM C143/C143M - 15, Standard test method for slump of hydraulic-cement concrete, ASTM International, West Conshohocken, PA, USA, 2015.
33. ASTM C138/C138M - 16, Standard test method for density (unit weight), yield and air content (gravimetric) of concrete, ASTM International, West Conshohocken, PA, USA, 2016.
34. ASTM C192/C192M - 15, Standard practice for making and curing concrete test specimens in the laboratory, ASTM International, West Conshohocken, PA, USA, 2015.
35. ASTM C39/C39M - 16, Standard test method for compressive strength of cylindrical concrete specimens, ASTM International, West Conshohocken, PA, USA, 2016.
36. ASTM C642 - 13, Standard test method for density, absorption, and voids in hardened concrete, ASTM International, West Conshohocken, PA, USA, 2013.
37. ASTM C496/C496M - 11, Standard test method for splitting tensile strength of cylindrical concrete specimens, ASTM International, West Conshohocken, PA, USA, 2011.
38. ASTM C293/C293M - 16, Standard test method for flexural strength of concrete (using simple beam with center-point loading), ASTM International, West Conshohocken, PA, USA, 2016.
39. ASTM C469/C469M - 14, Standard test method for static modulus of elasticity and Poisson’s ratio of concrete in compression, ASTM International, West Conshohocken, PA, USA, 2014.
40. Coconut shell as partial replacement of coarse aggregate in concrete
41. ACI 213R-03, Guide for structural lightweight aggregate concrete, American Concrete Institute, Detroit, Michigan, USA, 2003.
42. Properties of concrete with coconut shells as aggregate replacement
43. Comparative study on coconut shell aggregate with conventional concrete
44. Performance of coconut shell as coarse aggregate in concrete10.1016/j.conbuildmat.2017.02.066 ↗
45. Concrete from an agricultural waste-oil palm shell (OPS)10.1016/j.buildenv.2003.10.007 ↗
46. Oil palm shell as a lightweight aggregate for production of high strength lightweight concrete10.1016/j.conbuildmat.2010.11.075 ↗
47. Ductility behaviour of reinforced palm kernel shell concrete beams
48. Lightweight concrete using coconut shells as aggregate, Proceedings of International Conference on Advances in Concrete and Construction
49. An investigation of key mechanical and durability properties of coconut shell concrete with partial replacement of fly ash
50. Bari H., Effect of Coconut Shell on the Properties of Brick Aggregate Concrete, M.Sc. Eng. Thesis (Civil & Structural), Department of Civil Engineering, Dhaka University of Engineering & Technology (DUET), Gazipur, Gazipur-1707, Bangladesh, 2018.
51. Neville · 2011
52. Improvement of strength of concrete with partial replacement of coarse aggregate with coconut shell and coir fibres10.9790/1684-11321624 ↗
53. ASTM C330/C330M - 14, Standard specification for lightweight aggregates for structural concrete, ASTM International, West Conshohocken, PA, USA, 2014.
54. Erdogan · 2003
55. Study on determination of coefficient of modulus of elasticity for coconut shell concrete
56. Study on properties of concrete with agricultural waste
57. Brandt · 2009
58. Mechanical and fracture characteristics of eco-friendly concrete produced using coconut shell, ground granulated blast furnace slag and manufactured sand10.1016/j.conbuildmat.2015.11.035 ↗
59. Moore · 2013
60. Relation between density and compressive strength of hardened concrete
61. 2014
62. Nassar · 2002