Plaster materials from waste calcium sulfate containing chemicals, organic fibers and inorganic additives
Source abstract
Abstract
Abstract Plaster materials made of waste gypsum or flue-gas-desulferized (FGD) gypsum with chemicals;organic and inorganic additives were studied. Glucose;citric acid and sodium bicarbonate were incorporated to retard the hydration of plaster. Saw dust (SD);coconut fibers (CCF) and tobacco waste fiber (TWF) were incorporated to improve the thermal property. Diatomaceous earth (DE);fly ash (FA) and bottom ash (BA) were incorporated to improve the mechanical and thermal properties. Citric acid;TWF;sodium bicarbonate and glucose could be used to retard the setting time of fresh FGD-plaster to approximately 25 min comparable to that of commercial plaster while the other additives did not retard the hydration. In presences of these retarding additives;needle shaped gypsum changed into lower aspect ratio particles. SD;CCF;DE;FA and BA modified gypsum crystal growth and reduced the crystal length. These changes in morphology consequently gave significant alterations of mechanical and thermal properties of the materials. The additions of organic and inorganic additives resulted in a reduction of bulk density and increases in water absorption;and similar strength compared to commercial gypsum. A good thermal insulating property was obtained from the samples with the incorporation of coconut fiber;BA and DE. In addition;these samples had a good performance in fire proof.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Concrete and Cement Materials Research · Materials Engineering and Processing · Thermal and Kinetic Analysis
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (17)
Show source-provided references
1. State of the art on thermal insulation materials and aims for future developments10.1016/j.enbuild.2004.05.006 ↗
2. Calcium sulphate hemihydrate hydration leading to gypsum crystallization10.1016/j.pcrysgrow.2007.01.002 ↗
3. Boonserm K. Effects of organic and inorganic additives on hydration reaction;mechanical and thermal properties of FGD-gypsum. MS. thesis. Thailand: Chiang Mai University; 2008 [in Thai].
4. Crystallization of gypsum from hemihydrate in presence of additives10.1016/S0022-0248(98)01206-8 ↗
5. Hydration reactions and microstructural characteristics of hemihydrate with citric and malic acid10.1016/j.conbuildmat.2008.07.022 ↗
6. Development and characterization of an inorganic foam obtained by using sodium bicarbonate as a gas generator10.1016/j.conbuildmat.2004.12.001 ↗
7. Density and strength characteristics of foamed gypsum10.1016/S0958-9465(00)00008-1 ↗
8. Payatakes AC (2006) calcium sulfate precipitation in the presence of water-soluble polymers10.1016/j.jcis.2006.07.054 ↗
9. A perspective study on fly ash–lime–gypsum bricks and hollow blocks for low cost housing development10.1016/S0950-0618(02)00034-X ↗
10. Lightweight bricks made of diatomaceous earth;lime and gypsum10.1016/j.ceramint.2008.01.013 ↗
11. Crystallization kinetics of gypsum from dense suspension of hemihydrate in water10.1016/0022-0248(88)90275-8 ↗
12. Gypsum growth in the presence of growth inhibitors: a scanning force microscopy study10.1016/S0009-2541(96)00059-9 ↗
13. The vaporization of semi-volatile compounds during tobacco pyrolysis10.1016/j.jaap.2005.08.005 ↗
14. Development of coconut coir-based lightweight cement board10.1016/j.conbuildmat.2005.08.028 ↗
15. Thermal conductivity of coal ash and slags and models used10.1016/S0016-2361(00)00033-8 ↗
16. Fire resistance of biomass ash panels used for internal partition in buildings10.1016/j.firesaf.2008.12.005 ↗
17. Insulating capacity of fly ash pastes used for passive protection against fire10.1016/j.cemconcomp.2005.03.001 ↗