Advanced characterisation of bituminous sub-ballast for its application in railway tracks: The influence of temperature
Source abstract
Abstract
Abstract The use of bituminous sub-ballast in railway tracks is regarded as an appropriate solution for improving the strength of the section. However, for its widespread application, more in-depth studies are needed to assess its efficacy with respect to the main requirements that this material must meet under various service conditions. Such conditions include the range of temperatures that can occur during the service life of the railway tracks, which can modify the behaviour of bituminous material. This paper therefore focuses on evaluating the mechanical behaviour of bituminous material (under both routine and adverse temperatures that are expected in railway lines in extreme climates) in comparison to that presented by conventional granular sub-ballast. In particular, performance is examined with respect to the main requirements that need to be met by these materials (resistance to plastic and punching deformations, bearing capacity, stress dissipation, cracking resistance, and waterproof properties) for their use in railway tracks. At the same time, their influence on the performance of the global section was assessed for both types of sub-ballast by means of a full-scale test. The results demonstrated that the use of bituminous sub-ballast could improve both the mechanical response of the track and the protection of the remainder of the track bed layers, since this material exhibited higher strength against the loads imposed by passing trains, lower permeability, and a higher capacity to dissipate stresses transmitted by the ballast to the substructure. However, it is also important to consider that temperature plays a fundamental role in the resistance of bituminous sub-ballast to plastic and punching deformations, whilst its resistance to cracking declines sharply at higher temperatures. This could limit its application in railway lines in regions where values of this parameter are expected to be higher than those commonly recorded for this layer.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Railway Engineering and Dynamics · Geotechnical Engineering and Underground Structures · Structural Engineering and Vibration Analysis
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (21)
Show source-provided references
1. Bach · 2013
2. CENIT, Estudio sobre la viabilidad de incorporar capas de sub-balasto con material bituminoso en las líneas de alta velocidad en España-Fase 2. 252 pp. Conf. Report, 2005.
3. D.W. Christensen, R. Bonaquist, D. Jack, Evaluation of triaxial strength as a simple test for asphalt concrete rut resistance. Final Report, Pennsylvania Transportation Institute, the Pennsylvania State University, University Park, PA, 2002.
4. Influence of time and temperature on asphalt rheological properties
5. C.L. Ho, D. Humphrey, J. Hyslip, W. Moorhead, Use of recycled tire rubber to modify track substructure interaction, in: 92nd Annual Transportation Research Board Meeting, Washington D.C., U.S.A., 2013.
6. The deformation behavior of asphaltic concrete under triaxial compression
7. Geotechnical properties of ballast and the role of geosynthetics10.1680/grim.2006.10.3.91 ↗
8. High speed track deterioration: the role of the vertical stiffness of the track10.1243/095440904322804411 ↗
9. The temperature effect on the reflective cracking of asphalt overlays10.1080/14680629.2008.9690141 ↗
10. UGR-FACT test for the study of fatigue cracking in bituminous mixes10.1016/j.conbuildmat.2013.02.024 ↗
11. Mean Damage Parameter for the characterization of fatigue cracking behavior in bituminous mixes10.1016/j.matdes.2013.09.004 ↗
12. The effect of polymer modified binders on the long-term performance of bituminous mixtures: the influence of temperature10.1016/j.matdes.2015.04.018 ↗
13. R. Parson, A. Rahman, J. Han, Properties of fouled railroad ballast (Phase 1). Mid-America Transportation Center. Final Report 25-1121-0001-465, 2012.
14. Influence of early colour degradation of asphalt pavements on their thermal behaviour10.1016/j.conbuildmat.2014.05.028 ↗
15. J.G. Rose, D. Li, L.A. Walker, Tests and evaluations of in-service asphalt trackbeds. American Railway Engineering and Maintenance-of-Way Association, Annual Conference & Exposition, Washington, D.C., USA, 2002.
16. J.G. Rose, L.S. Bryson, Hot mix asphalt railway trackbeds: trackbed materials, performance evaluations, and significant implications. International Conference on Perpetual Pavements, Columbus, Ohio, USA, 2009.
17. J.G. Rose, P.F. Teixeira, N.E. Ridgway, Utilization of asphalt/bituminous layers and coatings in railway trackbeds – A compendium of international applications. Join Rail Conference, Urbana, IL, USA, 2010.10.1115/JRC2010-36146 ↗
18. Rose · 2011
19. J.G. Rose, Maintaining adequate trackbed structural support- An important railway infrastructure issue. Seminar at University of Illinois at Urbana-Champaign, USA, 2014.
20. Spanish Standard for Subballast, PF-7, Pliego de Prescripciones Técnicas Generales de Materiales Ferroviarios PF-7, Subbalasto. Servicio de publicaciones del Ministerio de Fomento, Madrid, 2006.
21. The use of bituminous subballast on future high-speed lines in Spain: structural design and economical impact