journal article·2020-01Open access

Performance of reactive magnesia cement formulations containing fly ash and ground granulated blast-furnace slag

Sanjeev Kumar, Cem Sonat, En-Hua Yang, Cise Unluer

Abstract

This study investigated the performance of carbonated reactive MgO cement (RMC) and sealed MgO-SiO2 (RMS) concrete formulations. Fly ash (FA) and ground granulated blast-furnace slag (GGBS) replaced half of the binder component in each system. The assessment of hydration mechanisms via isothermal calorimetry was supported by performance evaluation involving the measurement of permeable pores and compressive strength. Samples were also studied via x-ray diffraction (XRD), Fourier transform infrared spectroscopy (FTIR), thermogravimetric analysis (TGA) and field emission scanning electron microscopy (FESEM). The formation of a continuous carbonate network was responsible for the strength development of RMC samples, whereas hydrate phases such as M-S-H were observed in RMS samples. Partial replacement of RMC with GGBS led to similar performances under carbonation. RMS samples revealed comparable strengths to PC-based samples, highlighting the potential of MgO-SiO2 binders to be used in similar applications without requiring any special curing conditions.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Magnesium Oxide Properties and Applications · Concrete and Cement Materials Research · Layered Double Hydroxides Synthesis and Applications

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (68)

Show source-provided references
1. Advances in alternative cementitious binders10.1016/j.cemconres.2010.11.012 ↗
2. Hewlett · 2003
3. Recycling contaminated sediment into eco-friendly paving blocks by a combination of binary cement and carbon dioxide curing10.1016/j.jclepro.2017.07.070 ↗
4. Recycling contaminated wood into eco-friendly particleboard using green cement and carbon dioxide curing10.1016/j.jclepro.2016.07.180 ↗
5. Impact of hydrated magnesium carbonate additives on the carbonation of reactive MgO cements10.1016/j.cemconres.2013.08.009 ↗
6. Enhancing the carbonation of MgO cement porous blocks through improved curing conditions10.1016/j.cemconres.2014.02.005 ↗
7. The role of brucite, ground granulated blastfurnace slag, and magnesium silicates in the carbonation and performance of MgO cements10.1016/j.conbuildmat.2015.07.105 ↗
8. Influence of carbonation on the properties of reactive magnesia cement-based pressed masonry units10.1680/adcr.2008.20.2.53 ↗
9. Influence of mix design on the carbonation, mechanical properties and microstructure of reactive MgO cement-based concrete10.1016/j.cemconcomp.2017.03.004 ↗
10. Performance of magnesia cements in porous blocks in acid and magnesium environments10.1680/adcr.11.00011 ↗
11. Effects of different reactive MgOs on the hydration of MgO-activated GGBS paste10.1061/(ASCE)MT.1943-5533.0001009 ↗
12. Utilization of alkali-activated olivine in soil stabilization and the effect of carbonation on unconfined compressive strength and microstructure10.1061/(ASCE)MT.1943-5533.0001833 ↗
13. Performance and microstructural development of MgO–SiO2 binders under different curing conditions10.1016/j.conbuildmat.2017.08.020 ↗
14. Novel synergy of Si-rich minerals and reactive MgO for stabilisation/solidification of contaminated sediment10.1016/j.jhazmat.2018.11.067 ↗
15. Role of sodium hexametaphosphate in MgO/SiO2 cement pastes10.1016/j.cemconres.2016.08.003 ↗
16. The role of MgO in the thermal behavior of MgO–silica fume pastes10.1007/s10973-016-5827-6 ↗
17. Chandra Berntsson · 2003
18. Early-age properties, strength development and heat of hydration of concrete containing various South African slags at different replacement ratios10.1016/j.conbuildmat.2011.06.018 ↗
19. Mechanical and durability properties of high performance concretes containing supplementary cementitious materials10.1016/j.conbuildmat.2009.08.045 ↗
20. The greening of the concrete industry10.1016/j.cemconcomp.2008.12.010 ↗
21. Porosity, gas permeability, carbonation and their interaction in high-volume fly ash concrete10.1680/macr.2008.60.7.535 ↗
22. Effect of fly ash on the durability properties of high strength concrete
23. Effects of carbonation treatment on the properties of hydrated fly ash-MgO-Portland cement blends10.1016/j.conbuildmat.2015.07.193 ↗
24. Effectiveness of using CO2 pressure to enhance the carbonation of Portland cement-fly ash-MgO mortars10.1016/j.cemconcomp.2016.03.013 ↗
25. Development of low-carbon cementitious materials via carbonating Portland cement–fly ash–magnesia blends under various curing scenarios: a comparative study10.1016/j.jclepro.2016.01.066 ↗
26. Blast furnace slag-Mg (OH) 2 cements activated by sodium carbonate10.1039/C8RA03717E ↗
27. Coarse blast furnace slag as a cementitious material, comparative study as a partial replacement of Portland cement and as an alkali activated cement10.1016/j.conbuildmat.2009.02.002 ↗
28. Freeze–thaw cycle test and damage mechanics models of alkali-activated slag concrete10.1016/j.conbuildmat.2010.12.006 ↗
29. Properties and microstructure of GGBS–magnesia pastes10.1680/adcr.13.00005 ↗
30. Properties of binary and ternary reactive MgO mortar blends subjected to CO2 curing10.1016/j.cemconcomp.2013.03.009 ↗
31. Influence of slag chemistry on the hydration of alkali-activated blast-furnace slag—Part I: Effect of MgO10.1016/j.cemconres.2011.05.002 ↗
32. Durability of carbonated MgO concrete containing fly ash and ground granulated blast-furnace slag10.1016/j.conbuildmat.2018.10.121 ↗
33. Improving the performance of reactive MgO cement-based concrete mixes10.1016/j.conbuildmat.2016.09.090 ↗
34. Influence of supplementary cementitious materials on the performance and environmental impacts of reactive magnesia cement concrete10.1016/j.jclepro.2017.05.044 ↗
35. Accelerated carbonation–A potential approach to sequester CO2 in cement paste containing slag and reactive MgO10.1016/j.cemconcomp.2013.07.001 ↗
36. Development of magnesium-silicate-hydrate cement by pulverized fuel ash10.4028/www.scientific.net/KEM.709.61 ↗
37. Sequestration of CO2 in reactive MgO cement-based mixes with enhanced hydration mechanisms10.1016/j.conbuildmat.2017.03.038 ↗
38. ASTM, Standard Test Method for Measurement of Heat of Hydration of Hydraulic Cementitious Materials using Isothermal Conduction Calorimetry, 2009.
39. ASTM, Standard Test Method for Compressive Strength of Hydraulic Cement Mortars (using 2-in. Or [50-mm] Cube Specimens), 2013.
40. The science of concrete
41. Calorimetric determination of the effect of additives on cement hydration process10.2478/s11696-012-0256-x ↗
42. Hydration process of portland cement blended with silica fume
43. Surface carbonation of synthetic CSH samples: A comparison between fresh and aged CSH using X-ray photoelectron spectroscopy10.1016/j.cemconres.2008.02.003 ↗
44. Porosity and water permeability study of supercritically carbonated cement pastes involving mineral additions10.1021/ie061571o ↗
45. Investigation of the carbonation mechanism of CH and CSH in terms of kinetics, microstructure changes and moisture properties10.1016/j.cemconres.2013.11.015 ↗
46. Investigation of the performance and thermal decomposition of MgO and MgO-SiO2 formulations10.1016/j.tca.2017.07.009 ↗
47. Recycling and reuse of reactive MgO cements–A feasibility study10.1016/j.conbuildmat.2017.09.068 ↗
48. Magnesium and calcium silicate hydrates10.1016/j.cemconres.2015.06.007 ↗
49. Enhanced formation of magnesium silica hydrates (MSH) using sodium metasilicate and caustic magnesia in magnesia castables10.1016/j.ceramint.2017.04.058 ↗
50. Influence of time and temperature on ageing and phases synthesis in the MgO–SiO2–H2O system10.1016/j.tca.2013.01.018 ↗
51. Synthesis and characterisation of magnesium silicate hydrate gels10.1016/j.cemconres.2004.06.022 ↗
52. Study of the degradation of non-conventional MgO-SiO2 cement reinforced with lignocellulosic fibers10.1016/j.cemconcomp.2017.03.015 ↗
53. Mixtures of pulverised fuel ash, Portland cement and Magnesium oxide: characterization of pastes and setting behaviour
54. Aminobenzoate modified MgAl hydrotalcites as a novel smart additive of reinforced concrete for anticorrosion applications10.1016/j.conbuildmat.2013.06.049 ↗
55. Bell · 2010
56. Properties of magnesium silicate hydrates (MSH)10.1016/j.cemconres.2015.10.003 ↗
57. Microstructural, mechanical and thermal characterisation of sol–gel-derived aluminium titanate–mullite ceramic composites10.1016/j.actamat.2006.02.032 ↗
58. Structure and properties of mullite—A review10.1016/j.jeurceramsoc.2007.03.017 ↗
59. The mechanism of hydration of MgO-hydromagnesite blends10.1016/j.cemconres.2017.10.003 ↗
60. Infrared and infrared emission spectroscopy of nesquehonite 299 Mg (OH)(HCO3)· 2H2O-implications for the formula of nesquehonite10.1016/j.saa.2010.12.059 ↗
61. Infrared emission spectroscopic study of brucite10.1016/S1386-1425(99)00016-5 ↗
62. The role of magnesium during the hydration of C3S and CSH formation. Scanning electron microscopy and mid-infrared studies10.1680/adcr.2005.17.1.9 ↗
63. New sampling method to improve the reliability of FTIR analysis for self-compacting concrete10.1016/j.conbuildmat.2018.03.216 ↗
64. Thermogravimetric analysis–mass spectrometry (TGA–MS) of hydromagnesite from Dujiali Lake in Tibet, China10.1007/s10973-018-7197-8 ↗
65. Limitations of the hydrotalcite formation in Portland composite cement pastes containing dolomite and metakaolin10.1016/j.cemconres.2017.11.007 ↗
66. B. Lothenbach, P. Durdzinski, K. De Weerdt, Thermogravimetric analysis, A Practical Guide to Microstructural Analysis of Cementitious Materials; Scrivener, K., Snellings, R., Lothenbach, B., Eds (2015) 178-208.
67. Effect of temperature on the microstructure of calcium silicate hydrate (CSH)10.1016/j.cemconres.2013.06.008 ↗
68. Performance and microstructure of MgO-SiO2 concrete under different environments10.1016/j.conbuildmat.2018.07.032 ↗