Flexural strengthening of reinforced concrete beams using hybrid near-surface embedded/externally bonded fabric-reinforced cementitious matrix
Source abstract
Abstract
Abstract The efficacy of hybrid near-surface embedded/externally bonded (NSE/EB) fabric-reinforced cementitious matrix (FRCM) for flexural strengthening of reinforced concrete (RC) beams was assessed experimentally. Bending tests were conducted on eight RC beams: 6 strengthened and two reference beams. The test parameters were (a) the internal tensile reinforcement ratio and (b) the FRCM fabric type (glass, polyparaphenylene benzobisoxazole (PBO), and carbon). The experimental results revealed that the hybrid NSE/EB-FRCM could effectively be used for the flexural strengthening of RC beams based on the test parameters. The strengthened beams exhibited an enhanced flexural behavior as evidenced by their increased load-carrying capacity ( P u ) that ranged between 24.7% and 109%. The maximum enhancement in the load-carrying capacity was measured in carbon FRCM strengthened beams owing to the higher axial stiffness of carbon FRCM relative to PBO and glass FRCM. The strengthening efficacy of the FRCM was increased with an increase in the FRCM axial stiffness. An increase in the internal tensile reinforcement ratio showed an adverse effect on the gain in P u . The stiffness factor ( β f ) was used to study the combined effect of the test parameters. An almost linear relationship was observed between the increase in P u and β f with a good coefficient of correlation of 97%. Moreover, the strengthening system has increased the post-crack stiffness of the beam with an average increase of 52%. Finally, the prediction of the ACI 549 provisions was examined and compared with the experimental results.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Masonry and Concrete Structural Analysis · Structural Behavior of Reinforced Concrete · Innovative concrete reinforcement materials
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (43)
Show source-provided references
1. Strengthening of concrete structures with textile reinforced mortars: state-of-the-art review10.1061/(ASCE)CC.1943-5614.0000882 ↗
2. Behavior of RC beams strengthened in shear with FRP and FRCM composites10.1016/j.engstruct.2017.07.084 ↗
3. Textile-reinforced mortar (TRM) versus fibre-reinforced polymers (FRP) in flexural strengthening of RC beams10.1016/j.conbuildmat.2017.05.023 ↗
4. TRM versus FRP in flexural strengthening of RC beams: Behaviour at high temperatures10.1016/j.conbuildmat.2017.07.195 ↗
5. TRM vs FRP jacketing in shear strengthening of concrete members subjected to high temperatures10.1016/j.compositesb.2016.09.026 ↗
6. Tensile characterization of multi-ply fabric-reinforced cementitious matrix strengthening systems
7. Experimental and analytical study on strengthening of reinforced concrete T-beams in shear using steel reinforced grout (SRG)10.1016/j.compositesb.2019.107368 ↗
8. Experimental investigation of the performance of diagonal reinforcement and CFRP strengthened RC short columns10.1016/j.compstruct.2019.110984 ↗
9. Structural behaviour of fabric reinforced cementitious matrix (FRCM) strengthened concrete columns under eccentric loading10.1016/j.compositesb.2015.01.042 ↗
10. Performance of RC slab-type elements strengthened with fabric-reinforced cementitious-matrix composites10.1061/(ASCE)CC.1943-5614.0000415 ↗
11. Flexural strengthening of two-way RC slabs with textile-reinforced mortar: experimental investigation and design equations10.1061/(ASCE)CC.1943-5614.0000713 ↗
12. Concurrent seismic and energy retrofitting of RC and masonry building envelopes using inorganic textile-based composites combined with insulation materials: a new concept10.1016/j.compositesb.2018.04.002 ↗
13. Shear strengthening of full-scale RC T-beams using textile-reinforced mortar and textile-based anchors10.1016/j.compositesb.2016.03.076 ↗
14. Shear strengthening of reinforced concrete T-beams under cyclic loading with TRM or FRP jackets10.1617/s11527-014-0470-9 ↗
15. Analysis of the bond between Fabric Reinforced Cementitious Mortar (FRCM) strengthening systems and concrete10.1016/j.compositesb.2014.10.027 ↗
16. A shear design model for RC beams strengthened with fabric reinforced cementitious matrix10.1016/j.engstruct.2019.109698 ↗
17. Flexural strengthening of RC beams with an externally bonded fabric-reinforced cementitious matrix10.1061/(ASCE)CC.1943-5614.0000473 ↗
18. Effectiveness of fabric-reinforced cementitious matrix in strengthening reinforced concrete beams10.1061/(ASCE)CC.1943-5614.0000741 ↗
19. Flexural strengthening of RC beams using textile reinforced mortar – Experimental and numerical study10.1016/j.compstruct.2012.09.053 ↗
20. Bond between textile-reinforced mortar (TRM) and concrete substrates: experimental investigation10.1016/j.compositesb.2016.05.041 ↗
21. Influence of the substrate characteristics on the bond behavior of PBO FRCM-concrete joints10.1016/j.conbuildmat.2015.10.045 ↗
22. Pull-off characterization of FRCM/concrete interface10.1016/j.compositesb.2019.02.025 ↗
23. Bond characteristics of different FRCM systems10.1016/j.conbuildmat.2018.04.216 ↗
24. Experimental analysis on bond between PBO-FRCM strengthening materials and concrete10.1016/j.compositesb.2012.03.011 ↗
25. ACI Committee 549, Guide to design and construction of externally bonded fabric-reinforced cementitious matrix (FRCM) systems for repair and strengthening concrete and masonry structures (ACI 549.4R-13), American Concrete Institute, Farmington Hills, MI, USA., 2013.
26. Flexural strengthening of RC beams with cement-based composites10.1061/(ASCE)CC.1943-5614.0000218 ↗
27. Debonding analysis of reinforced concrete beams strengthened with fibre reinforced cementitious mortar10.1016/j.engfracmech.2011.06.012 ↗
28. Strengthening of reinforced-concrete beams in shear with a fabric-reinforced cementitious matrix
29. United States Department of Labor, Protecting Workers from the Hazards of Abrasive Blasting Materials, OSHA FS 3697-2014, 2014.
30. Hybrid NSE/EB technique for shear strengthening of reinforced concrete beams using FRCM: experimental study10.1016/j.conbuildmat.2017.12.224 ↗
31. Near surface embedded-FRCM for flexural strengthening of reinforced concrete beams10.1016/j.conbuildmat.2019.01.145 ↗
32. Internal transverse reinforcement configuration effect of EB/NSE-FRCM shear strengthening of RC deep beams10.1016/j.compositesb.2019.03.004 ↗
33. FRCM/internal transverse shear reinforcement interaction in shear strengthened RC beams10.1016/j.compstruct.2018.06.034 ↗
34. Textile-reinforced mortar (TRM) versus fiber-reinforced polymers (FRP) in shear strengthening of concrete beams10.1016/j.compositesb.2015.03.055 ↗
35. RC beams shear-strengthened with fabric-reinforced-cementitious-matrix (FRCM) composite10.1007/s40091-015-0102-9 ↗
36. Flexural analysis of reinforced concrete beams strengthened with a cement based high strength composite material10.1016/j.compstruct.2011.07.008 ↗
37. Standard test method for compressive strength of cylindrical concrete specimens
38. ISE/104 Committee, BS 4449:2005: Steel for the reinforcement of concrete. Weldable reinforcement steel. Bar, coil and decoiled product, BSI, 2005, (n.d.).
39. Ruredil, Technical datasheet, Ruredil X Mesh Gold, (n.d.).
40. SIKA Technical datasheet., SikaWrap-350G Grid data sheet, 2016., (n.d.).
41. Ruredil, Technical datasheet, X MESH C10 RUREDIL X MESH C10, (2013) 1–6.
42. Different FRCM systems for shear-strengthening of reinforced concrete beams10.1016/j.conbuildmat.2017.07.132 ↗
43. ACI Committee 318, Building code requirements for structural plain concrete (ACI 318.1-83) and commentary, 2014.