Mechanical and electrical properties of concrete incorporating an iron-particle contained nano-graphite by-product
Source abstract
Abstract
Abstract Electrically conductive cementitious composites (ECCC) have a wide range of potential applications in advanced structural technologies such as structural health monitoring and pavement deicing. General conductive fillers, such as steel fiber, carbon nanofiber and carbon nanotube, have been investigated to enhance the ECCC conductivity. However, cheaper and more efficient conductive fillers are required to promote the wider application of ECCC. The present study applies an iron-particle contained composite nano-graphite by-product (ING) to investigate a new type of conductive concrete. Both mechanical and electrical properties of this conductive concrete are examined and compared with corresponding measured properties of plain concrete and composites incorporating pure nano-graphite (NG). Results show a loss in compressive strength and increase in conductivity of concrete due to the addition of nano-graphite materials. A 1 wt% content of ING leads to almost 20% reduction in concrete’s compressive strength compared with the plain concrete, which is larger than NG (only 6.3%). However, the mechanical behavior of concrete with ING is little better than that of concrete with NG at 3 wt% and 5 wt%. ING is more significant in enhancing concrete conductivity than NG, especially at 1 wt% by resulting in a 70.3% decrease in electrical resistivity while only 11.3% resistivity reduction is observed for NG at the same concentration. Microstructural images show that composites incorporating ING material reach the percolation threshold of resistivity sooner. Meanwhile, ING particles show agglomerated state within the concrete matrix while NG tends to spread among it in the form of platelets.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Smart Materials for Construction · Concrete Corrosion and Durability · Concrete and Cement Materials Research
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (48)
Show source-provided references
1. Shetty · 2008
2. Fibre Bragg gratings in structural health monitoring—present status and applications10.1016/j.sna.2008.04.008 ↗
3. Crack detection application for fiber reinforced concrete using BOCDA-based optical fiber strain sensor10.1061/(ASCE)ST.1943-541X.0000195 ↗
4. Application of optical fiber distributed sensing to health monitoring of concrete structures10.1016/j.ymssp.2012.01.027 ↗
5. Advanced structural health monitoring of concrete structures with the aid of acoustic emission10.1016/j.conbuildmat.2014.04.103 ↗
6. Experimental validation of concrete crack identification and location with acoustic emission method10.1016/j.acme.2012.03.004 ↗
7. Evaluation of concrete fracture procedure based on acoustic emission parameters10.1016/j.conbuildmat.2013.06.034 ↗
8. Fujita Y, Mitani Y, Hamamoto Y. A method for crack detection on a concrete structure. 18th International Conference on Pattern Recognition (ICPR’06), 2006. p. 901–4. doi: 10.1109/ICPR.2006.98.10.1109/ICPR.2006.98 ↗
9. Fast crack detection method for large-size concrete surface images using percolation-based image processing10.1007/s00138-009-0189-8 ↗
10. Deep learning-based crack damage detection using convolutional neural networks: deep learning-based crack damage detection using CNNs10.1111/mice.12263 ↗
11. A state-of-the-art on self-sensing concrete: materials, fabrication and properties10.1016/j.compositesb.2019.107437 ↗
12. Structural health monitoring of concrete columns subjected to seismic excitations using piezoceramic-based sensors10.1088/0964-1726/20/12/125015 ↗
13. Electrical-resistance-based sensing of impact damage in carbon fiber reinforced cement-based materials10.1177/1045389X09354786 ↗
14. Feasibility of electrochemical chloride extraction from structural reinforced concrete using a sprayed conductive graphite powder–cement paste as anode10.1016/j.corsci.2013.07.035 ↗
15. Minsk L. Electrically conductive asphalt for control of snow and ice accumulation. High Research Record 1968;227:57–63. URL:https://trid.trb.org/view/110666.
16. Caggiano MF, Bentley M. Route 130 bridge snowfree installation electrical analysis and recommendations 1998. URL:.https://rosap.ntl.bts.gov/view/dot/15458.
17. Roca spur bridge: the implementation of an innovative deicing technology10.1061/(ASCE)0887-381X(2008)22:1(1) ↗
18. Derwin D, Booth P, Zaleski P, Marsey W, Flood W. Snowfree®, heated pavement system to eliminate icy runways, 2003. doi: 10.4271/2003-01-2145.10.4271/2003-01-2145 ↗
19. Multifunctional electrically conductive concrete using different fillers10.1016/j.jobe.2017.10.012 ↗
20. A review on material design, performance, and practical application of electrically conductive cementitious composites10.1016/j.conbuildmat.2019.116892 ↗
21. Electrical resistivity of carbon and steel micro-fiber reinforced cements10.1016/0008-8846(92)90104-4 ↗
22. Self-sensing capability of ultra-high-performance concrete containing steel fibers and carbon nanotubes under tension10.1016/j.sna.2018.04.009 ↗
23. Strain sensors based on the electrical resistance change accompanying the reversible pull-out of conducting short fibers in a less conducting matrix10.1088/0964-1726/4/1/009 ↗
24. Mustafa Sahmaran and Victor C. Li ML. Transport properties of engineered cementitious composites under chloride exposure. ACI Mater. J., n.d.;104. doi: 10.14359/18964.10.14359/18964 ↗
25. Electrical percolation threshold of cementitious composites possessing self-sensing functionality incorporating different carbon-based materials10.1088/0964-1726/25/10/105005 ↗
26. Effect of compressive strain on electrical resistivity of carbon black-filled cement-based composites10.1016/j.cemconcomp.2006.05.004 ↗
27. Multi-layer graphene-engineered cementitious composites with multifunctionality/intelligence10.1016/j.compositesb.2017.07.063 ↗
28. Percolation model of graphite-modified asphalt concrete10.1007/BF02870889 ↗
29. Self-sensing capabilities of cement-based sensor with layer-distributed conductive rubber fibres10.1016/j.sna.2019.111763 ↗
30. Evaluation of modified-graphite nanomaterials in concrete nanocomposite based on packing density principles10.1016/j.conbuildmat.2014.12.019 ↗
31. A self-sensing carbon nanotube/cement composite for traffic monitoring10.1088/0957-4484/20/44/445501 ↗
32. Effect of graphite nanoplatelets and carbon nanofibers on rheology, hydration, shrinkage, mechanical properties, and microstructure of UHPC10.1016/j.cemconres.2018.01.001 ↗
33. Mechanical properties of ultra-high-performance concrete enhanced with graphite nanoplatelets and carbon nanofibers10.1016/j.compositesb.2016.09.069 ↗
34. Nano graphite platelets-enabled piezoresistive cementitious composites for structural health monitoring10.1016/j.conbuildmat.2017.01.006 ↗
35. Intrinsic self-sensing concrete and structures: a review10.1016/j.measurement.2014.09.048 ↗
36. Fluctuation of electrical properties of carbon-based nanomaterials/cement composites: Case studies and parametric modeling10.1016/j.cemconcomp.2019.04.008 ↗
37. Graphene-based photocatalysts for hydrogen generation10.1021/jz302048d ↗
38. Standard,A., General purpose and blended cements, AS 3972-2010, Standard Australia. 2010. URL:https://www.standards.org.au/standards-catalogue/sa-snz/manufacturing/bd-010/as--3972-2010.
39. M.L. Kosmatka, S.H. Wilson, Design and Control of Concrete Mixtures. Portland Cement Association,16th edition, 2016. ISBN:978-0893122775.
40. ASTM (American Society for Testing and Materials), C, Standard Practice for Making and Curing Concrete Test Specimens in the Laboratory, ASTM C192/C192M-19. 2019. URL:https://www.astm.org/Standards/C192.
41. Test methods for on site measurement of resistivity of concrete — a RILEM TC-154 technical recommendation10.1016/S0950-0618(00)00061-1 ↗
42. Electrical resistance of carbon-nanofiber concrete10.1088/0964-1726/18/9/095039 ↗
43. Strain and damage sensing properties on multifunctional cement composites with CNF admixture10.1016/j.cemconcomp.2013.11.009 ↗
44. ASTM (American Society for Testing and Materials), C, Standard Test Method for Compressive Strength of Cylindrical Concrete Specimens, ASTM C39/C39M-20. 2020. URL:https://www.astm.org/Standards/C39.htm.
45. Mechanical, thermal and electromagnetic properties of nanographite platelets modified cementitious composites10.1016/j.compositesa.2016.11.017 ↗
46. Mechanical properties of recycled aggregate concrete under uniaxial loading10.1016/j.cemconres.2004.09.020 ↗
47. Piezoresistive cement-based materials for strain sensing10.1106/104538902031861 ↗
48. Electrical conductivity of a graphite layer10.1103/PhysRevB.22.904 ↗